How to hide one of your disk partitions by registering a list

New Binary Value"nodrives"=01,00,00,00 (Hide A disk) 02,00,00,00 (Hide B disk) 04,00,00,00 (Hide C disk) 08,00,00,00 (Hide D disk) 10,00,00,00 (Hide E disk) 20,00,00,00 (Hide F disk) FF,FF,FF,03 (Hide all).

Note] If you want to hide multiple drives, add their corresponding values, such as If you want to hide A and C drives, set"05,00,00,00"；To hide the D, E and F drive settings"38，00，00，00", note that it should be operated in hexadecimal system.

Hiding is 3c 00 00 00

Check it out. When hidden, it can be opened by entering the path.

1.Enter the drive letter of the hidden partition in Internet Explorer, e.g. C: Enter.

It is also possible to enter the corresponding drive letter in the Start Run section.

2.You can use the Super Bunny software, or you can manually modify the registry or use Group Policy (both of which show hidden hard drive partitions.

It can also be set up in the registry, which is a little more complicated, but not difficult to learn.

Open the registry and go to the following path:

Create a new key nodrives, the key value of this key is the key to hiding the drive letter, to explain, I also spent a lot of time researching, we should think of these values as four areas 00 00 00 00

Zone 1 controls drives A-H, Zone 2 controls drives I-P, Zone 3 controls drives Q-X, Zone 4 controls Y and Z letters.

It has been going down to multiples, for example, a disk is 01, b disk is 02, and then it is c disk 02 * 2 = 04, but after D disk 08, because it is calculated in 16 base (don't tell me you don't know what hexadecimal is), so E disk 08 * 2 is 16, and the next digit will be written as E disk 10, and then go down to F disk 10 * 2 = 20....

If you want to hide two partitions, then add the values together, for example, to hide a disk and f disk at the same time, the value is 01000000 + 20000000 = 21000000, if you want to hide all the disks in this area, you should write ff (the last digit of hexadecimal).

The next disk is calculated the same, and,If you are written as a dword value,Then you have to reverse,Four areas are opposite,For example, a disk should be written as 00000001,I disk should be written as 00000100 Oh,It is recommended that you try it,The impression will be more profound。

Change to "00 00 00 00" to indicate that no drive letter is hidden; Changing to "ff ff ff ff" means that all drive letters are hidden. The key value of the drive letter (in multiples of hexadecimal increments) is as follows:

A disk: 01, 00, 00, 00

B disk: 02,00,00,00

C disk: 04, 00, 00, 00

D disk: 08, 00, 00, 00

E-disk: 10,00,00,00

Delete this binary key you set "nodrives" after saving and restarting the computer tried OK?