Subject 3: What is the situation in the exam, and what gear is used

Subject 3 generally starts with first gear, and the vehicle can be changed to second gear when walking, because there is a requirement in subject 3 that the driving distance with first and second gears cannot exceed 500 meters, otherwise it will be judged as unqualified in the exam! When driving in second gear, when the speed is 20 kilometers higher with refueling, you can change to third gear! When the speed exceeds 30 kilometers, you can change to 4th gear, and you can change to 5th gear after 40 kilometers (general subject 3 does not use 5th gear); Of course, when you drive, you can observe the speedometer under the steering wheel (the watch on the right), remember one thing, give a little oil before shifting, so that the speed reaches the speed required by you to change gears, release the accelerator, and then press the clutch pedal to change gears!

After the gear is engaged, slowly lift the clutch pedal, and you can't lift it fast, otherwise the car will shake (10 points will be deducted); Release the clutch pedal and start with the oil. The same principle, when you want to downshift, release the throttle first, click the foot brake, let the speed down, when the speed of the gear is reached, then press the clutch pedal and downshift! Otherwise, if your speed does not match the gear, the engine will shake and cause points to be deducted!

Subject 3, remember to start in first gear, turn in second gear, run the whole process in third gear, and hang in 4th gear in the middle of the road (subject 3 requires 4 gear operation);

Subject 3 exam, gear operation skills.

Subject 3 exam - the specific operation of the gear.

<> subject 3 generally starts in first gear, and when the vehicle walks, it should be changed to second gear, because subject 3 is examined.

There is a requirement that the driving distance of the first and second gears cannot be more than 500 meters in a row, otherwise it will be judged as a failure in the exam. When driving in second gear, when the speed is 20 kilometers away from refueling, you can change to third gear. When the speed exceeds 30 kilometers, you can change to 4th gear, and you can change to 5th gear when you go up 40 kilometers, but general subject 3 does not use 5th gear.

Of course, you can observe the steering wheel while driving.

The following speedometer, give a little oil before shifting, so that the speed reaches the speed required by you to change gears, release the accelerator, and then press the clutch pedal to change gears. After engaging the gear, slowly lift the clutch pedal, lifting too fast will make the car shake, and 10 points will be deducted; Release the clutch pedal and start with oil. The same principle, when you want to downshift, first release the throttle, click the foot brake, let the speed of the car down, when the speed of the gear is reached, then press the clutch pedal and downshift.

Otherwise, if the speed does not match the gear, the engine will shake and cause points to be deducted.

Summary: When subject 3, remember to start in first gear, turn in second gear, run the whole process in third gear, and run in 4th gear in good road conditions in the middle, because 4 gears are required to operate in subject 3.

The whole process of the third subject exam is three gears: 1. At the beginning of the subject three exam, "one dozen steering, two stepping on the clutch, three gears, four horns, five looking at the rear mirror, six loose brakes, slowly lifting the clutch, and refueling lightly; Rise to second gear and turn the way"; 2. The car starts smoothly, the body is right, the direction signal is back, if the steering wheel rotation is relatively large, the direction signal will automatically return to the original position, and then it is time to shift: the left foot quickly steps on the clutch pedal, the right foot lifts, the left hand holds the steering wheel, the right hand pulls the gear to the position of the second gear, slowly lifts the left foot, and the right foot lightly steps on the accelerator to accelerate driving; 3. Shift gears according to the above steps, and shift to five gears in turn, and never overstep the gear until the end of the shift, but the speed of the vehicle should not be too fast.

The speed of the road test is controlled below 50 kilometers per hour; 4. When changing gears, the left hand must hold the steering wheel tightly, not deviate from the direction, end the gear shift, drive smoothly for a while, keep looking at the left and right rearview mirrors, and pay attention to the road conditions.

Subject 3 is generally enough with the second grade.

The general subjects are enough for three or two gears, but in the road sections with special requirements for acceleration and deceleration, it is necessary to change the third and fourth gears according to the regulations. The reason for the whole second gear is that if the speed is too fast, it is easy to panic in case of emergency. If it's too slow, it will delay time.

Of course, students should pay attention to deceleration and downshifting. If the speed of the vehicle drops below 15 km h after passing through a school, gas station, etc., it is judged to be dangerous driving if you do not downshift. In short, the most important thing is to use it flexibly, and choose the right gear according to the specific road conditions.

The test mileage of large buses and medium-sized buses shall not be less than 20 kilometers, of which the test mileage shall not be less than 10 kilometers during the day and shall not be less than 5 kilometers at night. The test mileage of tractors, city buses and large trucks shall not be less than 10 km, of which the test mileage shall not be less than 5 km during the day and shall not be less than 3 km at night.

The test mileage of small cars, small automatic transmission vehicles, low-speed trucks, and small automatic transmission passenger vehicles for the disabled shall not be less than 3 kilometers, and no less than 20% will be selected for night testing; If the night test is not conducted, the test shall be conducted to simulate the use of night lights.

For large buses, tractors, city buses, medium-sized buses, and large trucks, the traffic management department of the provincial-level public security organs shall, according to the actual situation, increase the content of complex road driving tests such as mountainous areas, tunnels, and steep slopes. For other quasi-driving types of automobiles, the traffic management department of the provincial-level public security organ can increase the test content according to the actual situation.

During the test of subject 3, the driving test requires the test car to start in 1st gear, transition in 2nd gear, and 3rd and 4th gears for normal driving speed. And it is required to use 1 gear no more than 50 meters, 3 gear no more than 300 meters, when the student driving the vehicle encounters a U-turn and turn, should play the turn signal, reduce to 2 gear and slow down. The following is an introduction to the Subject 3 exam

1. The content of the road driving skills test of subject 3 generally includes: preparation for getting on the bus, light simulation test, starting, driving in a straight line, adding and decreasing gear operations, changing lanes, pulling over, passing through the intersection with a straight chain, turning left at the intersection, turning right at the intersection, passing the pedestrian crossing line, passing the school area, passing the bus stop, meeting the car, overtaking, making a U-turn, and driving at night. 2. The content of the test for safe and civilized driving generally includes:

Safe and civilized driving operation requirements, safe driving knowledge under adverse weather and complex road conditions, emergency disposal methods such as tire bursts, and disposal knowledge after traffic accidents.

Subject 3. Introduction to the requirements for gears in the road test: add a gear with one foot of throttle after starting.

The first gear cannot exceed 2000 rpm. The second gear cannot exceed 2500 rpm. The third gear is not less than 20 yards and not more than 40 yards.

Fourth, the search file is not less than 30 yards and not more than 50 yards. (Section III.)

Also known as subject 1 theory test, driver theory test, the test content includes driving theory basis, road safety laws and regulations, local regulations and other related knowledge. 2. Subject 2.

Also known as the small road test, it is a field driving skills test subject.

The abbreviated test items include reversing into the garage, side parking, ramp fixed-point parking and starting, right-angle virtual cornering, and curve driving. 3. Subject 3: Poor road test, also known as road driving skills, is the road driving skill in the motor vehicle driver test.

It generally includes: getting on the bus, starting, driving in a straight line, adding and decreasing gear operations, changing lanes, pulling over, going straight through an intersection, turning left at an intersection, turning right at an intersection, passing a pedestrian crossing line, passing a school area, passing a bus stop, meeting a car, overtaking, making a U-turn, and driving at night. 4. Subject 4:

It is also known as the subject four theory test and the driver's theory test.

Section fiber destroys three. How many gears are used for the exam? Subject 3 exams.

The requirements for use are as follows: 1. Use.

In the first and second gears: the driving distance cannot exceed 500 meters continuously, otherwise it will be judged as unqualified in the exam. 2. When using three gears:

The content of the road driving skills test in subject 3 includes: preparation for getting on the bus, light simulation test, shouting regret to start, driving in a straight line, adding and decreasing gears, changing lanes, and pulling over.

Go straight through the intersection, turn to Zheng Zheng Zheng Zheng right bend, meet the car, overtake, make a U-turn, and drive at night. @2019