The piano metronome always stops walking around

If it's a mechanical metronome, just a few more winds.

1. A metronome is a kind of machinery that can produce a stable beat at various speeds.

2. If it is an electronic metronome, it may be a malfunction.

Resources.

If you are using a mechanical metronome, it needs to be wound, and if it stops, it may run out of clockwork, and you can go back and go again.

A piano metronome can be stopped and stopped for a variety of reasons, including running out of clockwork, running out of lubrication in the gears in the metronome, getting stuck on the clockwork at the base, or being misadjusted when adjusting the tempo. If the first three reasons are the same, you can refer to the following solutions:

1.If it is because the mainspring is used up, it needs to be wound before use.

2.If the metronome is not lubricated by oil, you can use a small screwdriver to remove the base, and then lubricate the clockwork gear with some lubricating oil, and then install the base.

3.If it is because the mainspring of the base is stuck, you can try to remove the base with a small screwdriver, and then lubricate the clockwork gear with some lubricating oil, and then install the base.

If none of the above methods solve the problem, you may need to send your metronome to a professional service person for repair. Before maintenance, it is recommended to record the current settings and status for subsequent maintenance work.

MechanicalMetronomeStopping is as simple as placing the pendulum pin in the position of the locator in the middle of the scale.

There are two springs on it, one is spring-loaded and the other is to control the beat, also known as the beat ruler. Then look at the pointer and cursor.

The value of the scale of the line aligned with the cracked potato above the vernier is how many beats per second. First, tighten the spring, remove the pointer from the slot, and then pull out the beat ruler with four numbers on it, pointing to two, three, and four beats.

If you're playing a piece of music that doesn't have 90 beats or 2 4 beats, first point the cursor to 90, pull out the beat tooth by a square, pull out the number 2, and then give the pointer an initial force, left and right, shake it, and it will start to wiggle. Every two clicks, the bell rings at the back, which indicates the landing point of the downbeat.

If the number you draw on the beat ruler is three, then the bell rings every three swings, four, six, and so on. It's all about the landing point of the downbeat. If the beat ruler is not drawn, the bell will not ring, that is, it is purely beat, and there is no hint of the downbeat.

How to fix the metronome if it doesn't ring:

with a screwdriver. Pry off the newly installed mechanical metronome base and remove the stuffing. This is to be shock-proof during transportation.

You can see the hand-matched gears inside. After using it for a while, you can apply some oil to prevent rust. Replace the bottom cover.

Stand on a horizontal plane. Remove the transparent panel. Slide the upper metal block to adjust the pendulum.

If we set the speed to 80, we need to move the metal block to the scale of 80 pendulum.