-
Simple: Drain the water, the depth of the water can withstand the gravity of the eggs falling.
A more effective way: of course, it is to put cotton.
-
Does throwing an egg from a high place break? Self-made cushioning device, let's see it together!
-
Wrap the eggs tightly with more shock-absorbing material. For example, foam, cotton, various filling materials, etc. Through the cushioning effect of these materials, the purpose of protecting eggs is achieved.
-
It can be designed with a round bubble wrap so that it can fall from the 4th floor without breaking.
-
Using a parachute, the air resistance is increased so that the egg and the entire device can land smoothly. Wrap the eggs tightly with more shock-absorbing material. For example, foam, cotton, various filling materials, etc.
Through the cushioning effect of these materials, the purpose of protecting eggs is achieved. Make the whole device into a polyhedron, and fix the egg on the ** of the polyhedron with a strong rope so that the whole egg is suspended. After the device lands, no matter which side hits the ground, the egg will not hit the ground, and the egg will be intact.
-
1.Cut off the bottom of the bag, then cut both sides to get two squares, then fold the square in half twice to get the upper fan, and then use chalk to draw an arc from the corner of the fan, and cut along the arc to get a circle (I folded the four squares together into a fan shape and cut it, so as to ensure that the four circles are the same.)
2.Tie the line (the plastic bag is easy to break, and it is better to tie it than to pierce it), first fold the circle in half 3 times to divide the circle into 8 parts, use chalk to mark each crease foot again, tie a small knot at each mark, and then the rope is fixed in the knot, and the eight ropes should be the same length, so that four are done.
-
Use cotton and cartons as cushions!
Outer packaging type: The outer packaging type is to use more shock-absorbing materials to wrap the eggs tightly. For example, foam, cotton, various filling materials, etc. Through the cushioning effect of these materials, the purpose of protecting eggs is achieved.
This is also easier to think of. I believe everyone has seen the method of protecting valuables with various filling materials in daily life. This is indeed an effective method.
This scheme is highly accurate because it is less affected by air resistance. Since the materials used are extremely dense, the weight of the entire unit can be reduced to a minimum. But the fly in the ointment is:
The whole device is in a free-falling state, and the speed when it reaches the ground is larger, so the rigidity and cushioning effect of the device are required, and the safety is slightly worse.
-
Put it in the refrigerator and freeze it, and it won't break no matter how you throw it away.
-
Put the egg into a balloon without blowing up, then blow it up, throw it from the air, and it will slowly fall down, and the egg will definitely not spoil.
-
Definition: The state in which the raw egg falls directly from the 4th floor and then the yolk and egg green fly out with a bang, which is not called smashing.
Once the definition is in effect, just throw the eggs down
-
You are not a secondary school shelf, only a secondary school can engage in this so-called small invention.
Since it's a competition, you should try it yourself, and the method is easier than you think.
Because it's not an invention.
-
In the belly of the hen, and then drop the hen down, it will fly down against the wind, and it will never break!
-
Just put it in the refrigerator and ice it!
-
I have a plan, but I don't know if it will work.
If you want to know it, you must know why it is true, the reason why the egg will break when it falls from a high place is mainly because the part of the egg touching the ground is very small at the moment of collision, and the pressure is very large in an instant, and the eggshell is very fragile, so it will break. I think to make the eggs not broken, the first problem to solve is not to let the eggs and the ground in direct contact, the landlord can first wrap a layer of cotton outside the eggs, and then use newspaper to wrap the cotton and eggs together, it does not need to be too thick, but must make the eggs have a sense of security, the outermost is wrapped in waterproof paper, the next step is the finishing touch, find a bowl with a radius of no more than 5 cm, the rounder the bowl, the better, the inside is full of water, the Bi Potato Hall put the wrapped eggs into the sailor teaser, note, regret is in the middle, and then put it in the refrigerator to freezeto make sure the eggs are frozen. Hehe, now it's time to witness the miracle.
However, release the eggs with the thick ice facing downwards.
-
1.Swallow it, then jump off the building.
2.Stuff someone else to eat, and then push him down.
3.gave the pig to eat, and then pushed the pig Xingming down without telling him.
4.Dig a pond under the fourth floor.
5.It's all troublesome... Don't drop it, take it up the stairs, check the stove
-
1.When I was a child, I used laterite --- is a kind of clay, and after mixing it with water, kneaded it into the shape of an egg, and then dried it for a few days, but be sure to wait until the inside of it also dries out, in the figure lacquer. It's hard.
Or take a block of wood, use a carving knife (if you don't have one, you can use a knife you think you can), cut it into an egg shape, of course, and then sandpaper it afterwards and then spray paint.
2.Make ten 1 square meter boxes, 9 of which are pasted with a square meter of newspaper (a thin and fragile one), and one of the boxes nailed with a sponge, then folded up, and placed at the bottom of the sea mat so that the eggs will not break if they fall.
3.Packed with n-layer foam.
-
Put the egg in a styrofoam hole, fixed with tape around it, if you fall from a high place will not break, the styrofoam is elastic to resist the impact of friction with the ground, and when it falls, it will not fall in a straight line and reduce the impact force, because the egg will not break.
-
I think it's balloons, or inflatable toys.
Then glue the eggs with clear glue.
For example, with three or four balloons, the egg is in the middle.
I'm just dreaming.
Didn't try it.
Good luck!
-
Native eggs, reed eggs, wild eggs, mountain eggs, black eggs, wild eggs, reed chickens, hemp chickens, pheasants.
Free door-to-door delivery in Jinan city.
For freshness, we do not accept out-of-town.
So that you can enjoy the green while sitting at home.
Need a pro m me.
Welfare for pregnant women, children, and the elderly at home!!
Jinan City can be sent.
-
Add a repellent around the eggs, such as foam, wrap the feathers, and get a parachute!
-
There are many ways to do this......
For example, put a foam cushion on the ground, and the egg will not break if it falls down, for example, the egg is wrapped in thick foam, and the buffer will not be broken when it lands, such as putting the egg in a water bottle, the buoyancy and buffering force of the water will protect the egg from breaking, such as making a parachute, and the egg will not break if it falls precariously, such as putting the egg in a plastic bag, inflating, and then making a double-layer inflatable structure, it can also buffer and protect.
-
Wrap the eggs in ten layers with air cushion film, wrap two layers in a cardboard shell, wrap them in a wooden box outside, and put them in the iron box as a whole, filling them without leaving gaps, so that they should not be broken if they are thrown down.
-
There are many ways to do this, such as wrapping cotton on the outside, or wrapping it in a few small balls, or using a parachute, etc.
The division of these majors is merely focused on learning. If you make your profession your goal in life, you are wrong, you can only be a design worker. >>>More
1.Royal Academy of Art.
The Product Design programme at the Royal College of Art aims to provide students with a more professional academic guidance for students who have already established a strong foundation in a wide range of design fields, providing students with a variety of research topics through a three-dimensional matrix teaching structure, as well as corresponding mentors and projects. >>>More
Chang'an University has a graduate student in industrial design. It belongs to the industrial design category of engineering. School of Engineering Machinery, Chang'an University recruits full-time (professional degree) industrial design engineering master's degree postgraduate subjects: >>>More
I have the whole design panel. --Acting as an agent for the graduation project of industrial design.
Furniture design belongs to the Department of Wood Science and Engineering. >>>More