Should I get rid of the layer of adhesive tape on the newly bought refrigerator?

Precautions for the use of the newly bought refrigerator:

1. Check whether the location of the refrigerator meets the requirements

The refrigerator should be placed in a well-ventilated place, at least 10 cm away from the wall, so that the refrigerator can quickly dissipate heat when working and prolong the life of the refrigerator. It is closer to the kitchen, it is more convenient to take food, shorten the time to turn on and off the refrigerator, and can save electricity. Avoid direct sunlight and make sure the refrigerator is flat.

2. Check the packing list.

3. The refrigerator should be equipped with a special three-pin socket and be wired separately. For users who do not have a grounding device, a grounding wire should be installed.

When setting the grounding wire, you can't use tap water and gas pipes as grounding wires, and you can't connect the first line and lightning rods.

Above; Check whether the power supply voltage meets the requirements. The power supply used in the refrigerator should be a 220 volt, 50 Hz single-phase AC power supply. If the voltage is too high, the motor coil will be burned out due to too much current; If the voltage is too low, it will be difficult for the compressor to start, resulting in frequent start-up, and it will also burn out the motor;

4. After checking that it is correct, the refrigerator should stand for half an hour, turn on the power supply, listen carefully to whether the sound of the compressor is normal when starting and running, whether there is the sound of the pipes hitting each other, if the noise is large, check whether the refrigerator is placed smoothly, whether the various pipelines are in contact, and make corresponding adjustments.

5. It should be noted that before storing food, the refrigerator should run no-load for a period of time, and then put in the food after the temperature in the box is reduced.

Tearing it off may also affect the heat dissipation of the refrigerator.

Summary. Kiss, this is a <> to be torn off

Kiss, this is a <> to be torn off

If you buy a new refrigerator, you should tear off the thin film on the outside. The function of the film of the refrigerator shell is to protect the outer hall from the <> of scratching during the production and transportation process

The film behind the refrigerator is directly pasted on the heat dissipation net, which not only affects the heat dissipation of the refrigerator and wastes electricity, but also shortens the service life of the refrigerator<>

1. Use a hair dryer to blow on the film at a certain distance, and after heating, the film should expand and can be easily torn off. 2. Sprinkle ice water on the protective film, wait for a while, and slowly tear it off. 3. Use wind oil essence to apply the inner protective film around the hunger stool, and then wipe it with a wet towel, which is effortless and the effect is very good.

Kissing can also be torn off directly, but it may be more difficult to tear <>

It was supposed to be the place where the foaming agent was injected, so I had to stick it so that I couldn't see it.

Abstract 1, use an eraser to wipe in little by little along the edge to easily remove marks. But depending on how sticky you are, it may take a different time. If possible, alcohol + eraser works very well.

2. You can take a dry cloth stained with vinegar to cover the entire double-sided tape traces, and wait until the sticky stains of the double-sided tape are completely soaked, and you can easily remove them with a ruler.

3. You can also use heating to soften the adhesive of the double-sided tape: blow it with a hair dryer to soften the adhesive, and when the adhesive of the double-sided tape becomes weaker, it can be easily removed. If there are still small marks, wipe them off with polish remover that removes nail polish.

4. When clearing, whether you use glossing water or vinegar, you must let these supplies completely soak the double-sided adhesive marks to remove them easily and effectively!

6. Use soap and a little ammonia and turpentine to mix liquid, which can remove a lot of dirt and make the glass surface more shiny (this article is applicable to ceramic tiles, ceramics, glass, etc.).

7. Use transparent adhesive with good viscosity to repeatedly stick and tear, and you can remove some of the surface.

8. Wipe it off with a little sodium water, or use paint thinner

9. Wipe with a cotton swab dipped in nail polish remover.

10. Wipe with wind oil essence.

11. Use a special cleaner or sneaker stain remover to wipe.

The protective film of the refrigerator is old, and after removing it, there are still traces of glue on the refrigerator, and how can it be removed.

1. Use an eraser to wipe in little by little along the edge to easily remove marks. But depending on how sticky you are, it may take a different time. If possible, alcohol + eraser works very well.

2. You can take a dry cloth stained with vinegar to cover the entire double-sided tape traces, and wait until the sticky stains of the double-sided tape are completely soaked, and you can easily remove them with a ruler. 3. You can also use heating to soften the adhesive of the double-sided tape: blow it with a hair dryer to soften the adhesive, and when the adhesive of the double-sided tape becomes weaker, it can be easily removed.

If there are still small marks, wipe them off with polish remover that removes nail polish. 4. When clearing, whether you use glossing water or vinegar, you must let these supplies completely soak the double-sided adhesive marks to remove them easily and effectively! 6. Use soap and a little ammonia and turpentine to mix liquid, which can remove a lot of dirt and make the glass surface more shiny (this article is applicable to ceramic tiles, ceramics, glass, etc.).

7. Use viscous transparent glue to repeatedly stick and tear, you can remove some of the surface 8, wipe it off with a little sodium water, or use paint thinner 9, wipe it with a cotton swab dipped in nail polish. 10. Wipe with wind oil essence. 11. Use a special cleaner or sneaker stain remover to wipe.

Try what you have at home.

The adhesive tape inside the newly bought refrigerator should be removed, and the heat dissipation of the refrigerator is on both sides of the refrigerator, and this film will hinder the heat dissipation of the refrigerator.

Proper way to use the refrigerator:

When placing the refrigerator, you should generally reserve a distance of 5 to 10 cm on both sides of the refrigerator, 10 cm on the top, and 10 cm on the back side, so as to help the refrigerator fully dissipate heat. Otherwise, the heat of the refrigerator will be stored in the back or sides of the refrigerator and will not be well dissipated. In addition, there should be vents around the refrigerator, or there should be vents not far away that can form a backflow with the heat dissipation channel of the refrigerator, so that the heat of the refrigerator can reach the vents.

In addition, the refrigerator should not be placed together with other household appliances such as stereos, TVs, microwave ovens, etc., as the heat generated by these appliances will increase the burden on the refrigerator and increase power consumption. Also stay away from heat sources and avoid direct sunlight, as this heat can also put a strain on the refrigerator. In short, when it comes to placement, we must keep the refrigerator away from the heat source and fully dissipate heat.

Good placement can also be effective in reducing noise. To place the refrigerator in a flat and firm place on the ground, adjust the bottom corner balance so that it is on a flat surface, you can also raise the refrigerator by 3-6 cm and adjust the corner balance to increase the air convection space at the bottom of the box and reduce noise, in addition, check whether the parts are loose to avoid resonance.

It is best to tear it off and reuse it, because the outer wall of the refrigerator will heat up during use, and the thin tape will melt on it and it will be difficult to clean.

If you want to tear it off, the outer wall of the refrigerator will heat up during use, and the thin adhesive tape will melt on it and it will be difficult to clean.

It's best to tear off the useless tape, because the tape will no longer be sticky after freezing

It's best to tear it off, it sticks after a long time, and you can't tear it off if you want to.

The film on both sides of the new refrigerator should be torn off, and the current refrigerator has heat dissipation on both sides, and if it is not torn, it will have poor heat dissipation and damage the refrigerator.

What should you pay attention to when you buy a new refrigerator:

1. If you just bought the refrigerator, you should leave it for a while, let its refrigerant flow back to the head (the bottom of the refrigerator), and then turn on the power. Because in the process of handling, the refrigerator may be placed on the side or flat, if it is flat, it must be left upright for a long time before it can be energized. Before using the new refrigerator, you should tear off all the adhesive stickers inside, and you can put a lemon or put some tea wrapped in gauze, which can remove odors.

2. Don't put things with special odors, and then items with large water content or high temperature, try not to put them directly in the refrigerator, and try to reduce the number of times you open the door at ordinary times.

3. Pay attention to whether the position of the refrigerator is reasonable and whether it is convenient for the refrigerator to dissipate heat. It is also necessary to check the power supply of the home, whether it is grounded, and whether it is a dedicated line.

4. Before use, the user should carefully read the attached product manual and check whether the various parts of the refrigerator are intact.

5. After turning on the power supply, listen carefully to whether the sound of the compressor is normal when starting and running, whether there is the sound of pipelines hitting each other, if the noise is too loud, check whether the product is placed smoothly, whether each pipeline is in contact, and make corresponding adjustments. If there is a loud abnormal sound, the power should be cut off immediately and a professional repairer should be contacted.

6. When starting to use, it is necessary to run with load reduction, because the moving parts of the new machine have a running-in process. After running for a period of time, add a large amount to prolong the life of the refrigerator.

Hello! Rongsheng.

The fridge is happy to answer for you!

The Rongsheng refrigerator delivered yesterday, the tape plate and seal in the box were cleared, and it was found that there was also a layer of film on the walls on both sides of the ice box, extending from one side to the top of the machine, and then to the other side, should this film be torn off? Will not tearing affect the heat dissipation? ”

Rongsheng refrigerator, simple life, enjoy the original ecology!

The protective film on both sides must be removed.

Nowadays, many refrigerators have condenser lines attached to both sides of the refrigerator.

Fever at work. If it is not torn off, it will affect its heat dissipation effect and cause the cooling effect to be unsatisfactory.

Summary. It's best to tear it off, but it doesn't necessarily affect the heat dissipation, the heat dissipation of the refrigerator is mainly on the side, and the bottom has little impact, however, this kind of thing is originally a package, so there is no need to keep it.

The refrigerator I just bought is glued with a layer of cardboard box under the tape, which needs to be removed or not used, which will affect the heat dissipation.

I've seen your question, wait a minute! Serve you immediately and provide a satisfactory reply.

Sticking without tearing will not have an effect.

May affect heat dissipation.