Why can t you charge it if you change the charger Apple s

Updated on technology 2024-03-28
6 answers
  1. Anonymous users2024-02-07

    Because the charging interface of the Apple mobile phone is not universally used for other interfaces, the Apple mobile phone charger must also be used together, both in terms of quality and ** than other mobile phone chargers. The charger will not be charged after the Apple mobile phone has been used for a long time, so don't be in a hurry to replace it when the problem occurs, you can check the problem according to the method shared below, and find the problem point in the right medicine.

    What should I do if the Apple phone charger can't be charged:

    1. The mobile phone can't be charged, of course, you have to find out which piece is wrong, and only when you find the problem can you prescribe the right medicine. First of all, the phone is connected to the charger and plugged into the plug board to see if it can be charged. If it can't be recharged, then the current possible problem is:

    1) The charger is broken, (2) the cable is broken, (3) the mobile phone interface is broken, (4) the system problem (5) and then eliminate.

    2. Change a connecting cable or a charging plug, and then charge it to see if it can be charged in. Pay attention to the current and voltage of the original charging plug of the mobile phone when changing the charging plug to prevent harm to the mobile phone. If you can't rush, then the possible problem is:

    1) Mobile phone interface problem (2) System problem.

    Solution: 1. The charger or data cable is broken: this can replace the charger or data cable.

    Note: Please try to choose the original one for replacement, so that it will not cause harm to the mobile phone. If you think that the original one is not good, you can buy a charger with *** point, but pay attention to the parameters of the charger must be the same as your original one.

    If the current is too high, it may cause damage to the motherboard of the phone.

    Second, the problem of the mobile phone interface: This is caused by the poor charging interface of the mobile phone, such as loose. Please go to a professional mobile phone shop for repair, do not disassemble the phone by yourself.

    3. System problems: For system ROM problems, please make sure to have a certain experience in flashing or knowledge of mobile phone systems. You can choose to re-flash the device to try it or use the following method to clear the system's battery information.

    The main problem of the Apple mobile phone charger not charging is the charger and the mobile phone itself. And because of the expensive characteristics of Apple mobile phones, you must also choose a matching charger when choosing a new charger.

  2. Anonymous users2024-02-06

    Reasons why the battery won't charge:

    1.The phone battery cannot be charged, and it is possible that the battery has entered a dormant state. This is mostly caused by the user running out of power and the phone automatically shuts down.

    The solution to this situation is to remove the battery, wait 5 minutes, and then reinstall the battery. Use a data cable to connect your Mi phone to the computer, and after 30 minutes, turn it back on.

    2.In the case of sudden mobile phone battery not charging, you also need to check whether you are using a regular original charger. If you are using a different charger, you need to check if there is a problem with the charger or if the charger port is damaged.

    Switching to a new charger can solve this situation.

  3. Anonymous users2024-02-05

    If there is a problem with the charger, try to change the charger, and the charger that can be charged normally will be replaced. The power bank can be charged, that is, the mobile phone is fine, so change the charger.

    The charger output is unstable and may not charge. The charger is hot and hot, and it is easy to get worse and have problems. Unplug the charger and wait a few minutes before plugging it back in, sometimes it will charge.

    If there is a problem with the charger, the charging speed may be slow, and other mobile phones can be charged with the charger, but the charging may be slow, which is a problem with the charger.

  4. Anonymous users2024-02-04

    The Apple phone charger is not broken and there is no problem. But if you change a charger, you can't charge it, but your friend's can be charged. Then you need to check whether there is any abnormality in the charging interface of the mobile phone. Then restart your phone.

  5. Anonymous users2024-02-03

    Battery water loss, vulcanization of battery plates, disconnection of fuse in battery fuse, poor contact between battery fuse and fuse holder, etc. The following is a part of the introduction of the car battery: 1. Function:

    Car battery, also called battery, is a kind of battery, the battery plays a very important role in the use of the car, if the car battery can not be supplied normally, the engine will have problems, the owner must be checked every day of driving, once a week in summer, and once every half a month in winter. 2. Factors affecting the life of the battery: vehicle conditions, road conditions, and driver's habits; Good driving habits can extend the life of the battery.

  6. Anonymous users2024-02-02

    Summary. Hello, dear, I'm glad to answer for you: the Apple mobile phone runs out of fast charging, and the original charger can't be charged 1, and the charging interface at the bottom of the mobile phone is dusty, which causes poor contact between the interface and the power cord plug:

    Check the connector on the bottom of the phone for any foreign object blockage. 2. Charger failure: It can be solved by changing a charger.

    3. Data cable problem: change a mobile phone data cable. 4. Reasons for the system:

    Put your phone under the covers or in an air-conditioned room and let it stay at a normal temperature before charging it.

    The Apple phone runs out of fast charging, and it can't be charged with the original charger.

    Hello, dear, I'm glad to answer for you: the Apple mobile phone runs out of fast charging, and the original charger can't be charged 1, the charging interface at the bottom of the mobile phone is gray, which causes poor contact between the interface and the power cord plug: check whether the interface at the bottom of the mobile phone is blocked by foreign objects.

    2. Charger failure: It can be solved by changing a charger. 3. Oak argues about the data line problem

    Change your phone cable. 4. The reason for the system: first put the mobile phone in the quilt or air conditioning room, let the mobile phone be at a normal temperature, and then charge it.

    Under normal circumstances, Apple and Hu mobile phones can be charged normally after fast charging, if it can't be charged normally after fast charging, you can take a look at the phone settings first, if the settings are normal, then the phone may be faulty. It is recommended to take a look at the Apple Specialization.

Related questions
18 answers2024-03-28

1. If you can't turn on the machine, the biggest possibility is that it can't be turned on due to insufficient power. Check to see if the plug is plugged in properly and confirm that the phone is charging. >>>More

12 answers2024-03-28

Cables, charging heads, and tail plugs are all possible, but there is no way to rule out which one is the problem, you can only find someone who uses the same iPad as you to try to change things, and see if it is the first problem.

11 answers2024-03-28

Android can be universal.

It is better to use the original. >>>More

10 answers2024-03-28

The power adapter converts the alternating current into direct current and adjusts the voltage to the specified voltage and then outputs it to the notebook charging module, the battery charging module will control the connection between the adapter and the battery according to the charging ratio set by the computer, if the battery power ratio is not reached, the battery will be charged, and a certain amount of power consumption will be generated in this process, so heat will be generated, which is a normal situation. If the overheating affects the use, it is recommended to go to the service center for testing.

14 answers2024-03-28

Specifically, the specifications of the charger data cable of X50 are: output voltage: 11V, output current: 3A, data cable: 3A, charging power: 33W >>>More