Yes? My hard drive, important data is missing a disk, and the computer is stuck 100

In this case, it may be that there is an error in the partition table, and the software fails to fix it, and as a result, you have re-established the partition on the basis of the wrong information, so that the partition information is messed up, so there is a problem one disk after another.

If you want to restore the original state, you don't need any paid software, many of which will meet your requirements. Gives you two options.

1.Use DiskGenius, EasyRecovery, FinalData and other software to recover data, and then copy all the data you find to other disks, then delete these two disks, re-establish partitions, reformat, and then copy the data back, which is the safest.

2.After recovering the data using the software in 1, rebuild the partition table with software such as diskgenius, search for the partition again, and then see if you can find the correct partition, you can find it and repair it directly, as long as the partition information is normal, save the changes. Of course, before repairing the partition, you must back up the current partition table to a USB flash drive or mobile hard disk to avoid losing more data by mistake.

If you try the above two methods and still don't work, don't create a new partition, don't format the hard disk, can't write any data, leave your QQ, I can help you deal with it remotely.

Repartition it or install the system.

See if the power supply is plugged in. or loose. or the voltage is unstable. Whether the fan is working properly. (CPU temperature is too high and it will automatically restart), 3Whether the graphics card and memory modules are plugged in or have problems. Unplug and reinsert. Erase the memory head with an eraser.

Get the CPU fan out. Loosen the CPU and plug it back in. It is also possible for the CPU to be loose. 5.Hard disk reason. There are bad sectors. (Slow speed, difficult to boot, often crashes).

6.Remove the COMS charger and let it short-circuit and discharge for five minutes, then install it again. If none of the above are the same. Reinstall the system. Check whether it is a system cause.

Remember to install anti-virus software and firewalls...

The following problems can be solved to avoid most computer crashes or"Fake your death"phenomenon:

1. Installing too many operating systems on the same hard drive will cause the system to crash. It is best to format and clean it with PQ before reinstalling.

If the computer runs slowly and there is a situation of one card after another, the easiest way is to detect whether it is a hard disk failure.

It may be a hardware problem, you need to reinstall the system first to troubleshoot the software problem, if it doesn't work, just try.

If not, it may be a malfunction caused by poor hardware contact.

1. Turn off the power, open the case, clean up the dust, especially the dust of the CPU fan, and check whether the CPU fan is rotating normally.

2. Power off, open the chassis, plug and unplug the memory, wipe the gold finger part with an eraser, and plug it back in (don't reverse it).

3. Plug and unplug the graphics card, wipe the gold finger part with an eraser, and reinsert it tightly (the buckle should be buckled).

4. Unplug the power cord, cut off the motherboard button battery, wait for three minutes, and then reinstall the motherboard.

5. If the above operations cannot solve the problem, it is recommended to send it to the maintenance center.

The landlord can provide more clues, it may be a temporary problem with the system file, disk, system, sometimes caused by incorrect operation, if it doesn't happen often, don't care about it, if it happens often, what did you do before it? What software, plug-ins, and patches have been upgraded? If I try to uninstall them all, is it also a hardware issue?

That is, the hardware has been upgraded? Is there something wrong with the hardware? First soft and then hard, it is recommended to check and kill the Trojan horse first, and try to repair the system.

Reinstall the system, save the important files, repartition the hard drive, format the system, and if so, you can increase the memory and replace the hard drive. Of course, if the internal heat dissipation is not good, such as the fan is not running properly or the radiator and air duct are blocked, it will also cause the CPU temperature to be too high and the freeze will be stuck, you can go to the next Master Lu to observe the CPU temperature, if the CPU temperature is too high, clean the radiator and air duct, replace the silicone grease and replace the fan.

1 All 1There are many reasons why the computer is stuck, and there may be reasons such as system settings and unstable disks. the reasons for the configuration of the computer, etc.;

2.The specific problem needs to be analyzed by the landlord to upload the computer configuration, 3On the problem raised by the landlord, the hard disk is few, but it is very stuck, the analysis may be caused by the instability of the disk, the following gives the basic self-rescue treatment method;

4.Option 1:

Try to deal with it using the self-help tools of computer rescue.

Procedure. 1.Turn on the computer rescue and click on the self-help tool rescue;

5.Solution 2: Open 360 Security Guard, click the Optimization Acceleration module, select the Startup Items tab, and set the startup type of infrequently used processes and services to Prohibit startup (random software does not recommend disabling startup).

6.Solution 3: Check whether the disk has bad sectors or the transfer rate is too low.

How it works: 1.Open 360 Security Guard, select Functions Daquan and add "Master Lu" module 2After installation, select "Disk Detection Tool" in the software performance test

Manager cleans up C drive that occupies large files already in the memory of the computer.

First of all, make sure that the C drive has enough space. Insufficient space on the C disk will cause the computer to freeze, so in the process of installing the application, it is necessary to pay attention to the installation of the program in other disks other than the C disk, and then to ensure that the computer card is not caused by memory, the best way to view the system is to use the computer manager to accelerate, for example: when the memory is used more than 90%, the computer will have a more obvious jam, at this time you can click to accelerate.

If you still have high memory usage even when you have few open programs, you should consider adding a memory module.

1. It may be poisoned.

2. Too many programs are allowed.

3. Hidden programs in the background are allowed to cause computer stuck.

4. There are many plug-ins.

5. The motherboard is aging.

6. The memory is too small, and the resources occupied by the system are too large.

7. The CPU temperature is too high.

Your so-called new hard drive seems to be a bit of a problem, the model is very old, it seems to be an IDE interface, beware of profiteers shoddy! Since there is a problem with the original hard disk, you should replace it with a new blue disk and replace it with an old one for you, which is really unreasonable!

Don't use that broken software of yours! Use Everest or HDTune to check the status and usage time of your hard drive!

Your old dual-core isn't strong, but it's not so bad that you can't do anything!

Only you know how to get stuck! It's better to go into more detail about whether the hard drive is connected separately on a single cable? Or is the same cable connected to the optical drive?

The C7 error is a problem with the hard disk interface or data cable, and it is recommended that you replace a data cable or replace a motherboard hard disk interface.

As follows:

1. Are you an all-in-one machine? Western Digital hard drives are very susceptible to breakage.

2. It is recommended that you back up your important documents to a portable hard drive and then repartition them.

Note: This sector can be isolated, or it can be left untreated (equivalent to hidden) when partitioning

3. But the best way to deal with it is to change a hard disk, such as a solid hybrid hard disk.