-
Why would you plug such a thing, if you want to plug it in, you have to plug it all the same.
The old and new operating parameters of the same frequency are not the same, let alone different brands.
Let's remove the 512m one and try it slowly for the others.
-
2It's not the same as the memory module brand.,It may be a compatibility problem.,Desktop computer compatibility is better than this one.,Desktop 2 strips are not the same, and there may be a re-start blue screen drop.,You said your book won't go back.。
Suggestion: 1. Since the landlord has tried to insert 512M memory alone, it is not running normally, so it can only be replaced with the same memory as the original book.
PS: Sometimes anything can happen when something goes wrong with the machine. For example, the 512 single plug did not run normally at that time, but it may be normal when the CMOS settings are cleared.
Personal advice, please give points if it helps)
-
The brand and frequency of the memory are not the same, it should be a problem of memory compatibility, it is recommended to find an expert friend to help you change the memory, or take your computer to the store that sells memory, and let the technician help you deal with it.
-
Could it be that the memory module is not plugged in properly and checked. It's also possible that there is a compatibility issue.
-
You are sure that your system, the hard disk is okay in the case. That's definitely incompatible, just change it to memory.
-
This kind of old memory, it's hard to say, two brands, it may be a compatibility problem, however, this configuration is indeed a bit poor, and another reason is that your memory is not bad, the motherboard is not installed, open it again to see if it is loose. Otherwise, it's a compatibility issue.
-
You put the previous one close to the CPU slot, and the latter one tries to do it.
-
If you want to know if it's caused by you adding memory.,You use a boot first.。。 If there is no problem with one entry, it means that there is a memory mismatch.
It may be that the speed is not the same.
Also, when you can install the system, you use one, and then add another one, only to have a problem, you may redo the system when the two memory is fully installed, if the system can be installed smoothly, it may be fine.
-
How much is the blue screen** to help resolve the cause of the freeze. First unplug the newly added memory, see if it can start, and use the minimum system method to query the hardware problem.
-
It is also possible that the same brand and frequency are incompatible.
Unplug one and try it.
Can you tell us a little bit about the brand and model?
512 for 350 is definitely expensive. >>>More
Don't think that the power of virtual memory is too great, too much is a complete waste. >>>More
Please don't mislead others on the 2nd floor, the general virtual memory is set to be just right.
Ӱ 7950GT Great!
GT is the high-end, GS is the mid-range, GE is the low-end, LE is the limited version, and GT is the best. >>>More
1024m, put it in other disks except the system disk, if your system is equipped with a c disk, then put it in the d disk.