The problem of the master slave disk of the hard disk of the Internet caf system

1. Ensure the use of high-power power supply of more than 300W, because the number of attached hard disks is too large, and ordinary power supply is not competent at all.

2. It is best to equip each tray or case with a cooling fan. Because after forming an array, each hard drive works at the same time as its companion, so the workload of the hard disk will increase.

3. Be sure to ensure that the power cords of several hard disks are connected stably, and it is best to fix them with adhesive tape.

4. Ensure that the array card is plugged and connected firmly.

5. The last point is that if conditions permit, the server is equipped with UPS uninterruptible power supply, which is more foolproof.

1.When sitting on ghost, only hang a hard disk, do not connect the master and slave disk.

2.Make the C drive as an image file (e.g. to the D or E3 of this hard driveDivide the hard disk that needs to be ghost (there must be more than 2 partitions) and activate the C drive (active).

4.Copy your image file to D or E on the new hard drive.

5.Attach the new hard disk separately and start the ghost restoration.

In a word, don't hang multiple hard disks when doing ghost, if you hang multiple hard disks, it will be a blue screen, or you can't load page files when you boot up.

You can set up the master and slave disks, and now computers have hotkeys to choose directly, such as esc, and the like, and select the one you want to boot, and you're good to go, and maxdos and the like, which hard disk is booted, which is displayed in ghost, and not what you set up in the host BIOS.

I see what you mean, I've encountered it too.

Do you want to ghost from the disc to the main disc upside down.

You can set the BIOS to boot from the disk, different motherboards have different settings, I don't know what motherboard you have, so you read the motherboard manual.

Before the ghost system, delete this value from the registry.

hkey_local_machine\system\mounteddevices

And then ghost will do.

Trust me, that's right!

I'll teach you how to carve nets, 1 host engraves all hosts

Alternatively, you can install the DOS Toolbox and set the boot sequence on the master and slave disks in COMS.

You can set the BIOS to boot from the disk, different motherboards have different settings, you can read the motherboard manual.

Do you know where the BISO setup disc boots?

HDD-0 is the primary disk boot.

HDD-1 is the secondary disk boot, because when you clone with ghost, the secondary disk is HDD-1 on the second interface of the IDE

Also, if your two disks are not the same size, the system will also have problems.

Pressing F2 when just starting is BISO's setting.

That's it. There is no way to do it.

Internet cafes are just diskless! ~