HP computer system hard drive problem, HP computer hard drive error cannot be turned on

Are you sure it's the most recent machine? Also don't know what system your machine comes pre-installed? You try to enter the BOIS to adjust the mode of the hard disk,Generally the default is SATA,You can change it to the IDE to try it Very old version,You use it on the current computer hard disk at will,It's easy to turn the hard disk into a corpse But this will affect the read speed of the hard disk It is recommended that you go to the nearest after-sales service to install a system It is better to give some money than to do it yourself

If you have a new machine, it is recommended to contact the after-sales service, and you can repair it for free!

It is recommended to look for a pure version of the *** system installation CD, press F9 to select the optical drive to guide after booting to see if the machine can enter the system installation interface, if not, contact the HP repair center directly to test the hardware; If you can enter the system installation interface, then there is no problem with the optical drive hardware, and the problem may be in the optical disc.

It should be a mistake and the boot is broken, directly remove the hard disk and connect it to other computers is partition and then re-boot, it can be solved, PQ often has such problems, small problems are fine.

In this case, you can try to install it with a Windows installation disk CD-ROM drive.

Use windows tools to partition, no PE and no ghost.

In this way, the installation of the general brand machine custom system can be completed.

After this can be installed, you can slowly try PQ, DM partition and PE to install the ghost system.

Yesterday to the computer system,Halfway through the installation of the computer turned off,After that, use the U disk to install the system,PE system under the look is not 2、If the detection of the hard disk is wrong, you need to contact HP's after-sales service for testing and maintenance,HP maintenance center contact。

Dear, your HP computer encounters the problem that the hard disk error won't turn on, you can try the following methods to troubleshoot:1Check the hardware connection:

First of all, you need to check whether the hardware connection of the computer is in good condition, including hard disks, memory modules, power supplies and other components. You can try plugging and unplugging these components to make sure they are tightly connected. 2.

Use the built-in repair tool of Windows: When the computer is turned on, press the F8 or F12 key to enter the startup options screen. Select "Repair Computer" or "Startup Repair" and follow the prompts to have the system automatically detect and fix hard drive errors.

3.Enter Safe Mode: When the computer is turned on, press the F8 or F12 key to enter the boot options interface.

Select "Safe Mode" and check if the hard drive can be used normally after entering the system. If so, it may be a problem with the system software or drivers. 4.

Use hard drive detection and repair tools: Some third-party hard drive detection and repair tools, such as CrystalDiskInfo, HD Tune, and other software, can be used to check the health of the hard drive and perform repair operations. If none of the above methods can solve the problem, you may need to consider replacing the hard drive or contacting a professional hardware repairer for repair.

It should be noted that before doing any hardware operation, it is recommended to back up your important data and files first to avoid data loss.

Hello, landlord, can you first try to see if the motherboard can detect the hard disk when you boot up? Or go to CMOS to check if there is a hard drive. If not, it's a hardware problem with the hard disk, and there is a test of a different hard disk data cable.

If you can't do it, take the hard drive out and take it to another machine to test the installation system. If it doesn't work, you have to buy a new hard drive, more than 500g and 300 pieces. Hope that helps.

If you can't find it, it's hanging.,,If you can find it.,Change SATA to IDE and there won't be a black screen in the final stage.。

Install directly with a CD, select "Custom" to install, and format the No. 1 driver!