How to install the program on the computer keyboard and how to reinstall the keyboard driver

This is achieved by using the keyboard setting function in CMOS. The current 386 and most 286 are equipped with a CMOS setting function, which can be accessed by pressing the DEL key after powering on. After entering the CMOS you can see its main menu, there are a total of eight functions, select the Advanced CMOS setup and press enter, on the first line, change the disabled after Typematic Rate Programming to Enabled (with the Page Up or Page Down key), and then select the delay time on the second line (Typematic Rate Delay), optional (unit:

milliseconds, default is 250). Select the repetition rate on the third line (typematic rate), you can choose 6,8,10,12,15,18,20,24,30 (unit: character seconds, the default value is 15), select the desired value and press the esc key to return to the main menu, press the F10, Y key, and finally hot start, after booting the DOS, your keyboard speed will change to what you need.

The keyboard is driven using a universal keyboard. Generally, it does not need to be installed separately, it comes with the system. If you have to install it yourself, you can find the keyboard in Device Management and click Upgrade Driver.

Tools Raw materials.

Computer. Method steps.

1. Click "Start" and click "Control Panel" to enter.

2. In the upper right corner, select "Big Icon", click "Keyboard" and double-click to enter the property interface.

3. Click "Hardware", click the keyboard name, and click the "Properties" button below.

<>5. After the update is completed, it will show that "it is the best driving ballast with the equipment that has been installed". Reinstalling the keyboard driver is complete.

The film with the circuit board at the bottom should be pressed to the contacts, the film should be pressed on the pure white strip, and the pure white strip that plays the role of fixing and insulation should be pressed with a rubber strip to fix the contacts.

Finally, the iron sheet is the iron sheet, and finally the screws are put on, and the contacts of the circuit board film must be completely bonded to the circuit board below.

2. The first button to be removed is x, see what the situation of the architecture inside is destroyed.

3. Align the keycaps and press them against the bracket.

4. Use a little force, and the clicking sound indicates that the installation is successful.

5. Next, install the more complex shift key, the two situations are slightly different, the bracket of the X key is directly connected to the keyboard, and the bracket of the shift key is connected to the keycap.

6. Now you need to remove the white bracket from the keycap, there are three parts, two white parts, a small steel wire, the steel wire is connected to the keycap, no need to take it off. 7. Combine the two parts of white into one.

8. Then install the white bracket that has been integrated into the keyboard, pay attention to the buttons on the keyboard, and install it if you are careful.

9. Put the shift key in the right direction and press it according to the empty part of the keyboard.

10. Because the shift key is longer than the X key, you need to press it with two fingers, and you hear a click, which means that the installation is successful.

11. The X key and shift key have been installed successfully, you can try to install them firmly.

Many people don't know how to install the spacebar after disassembling the keyboard, but it's actually very simple and fast in less than a minute!!

2 4 First of all, place this small piece of wire on the keyboard.

3 4 After completion, put on the keycaps, and the bayonet must be aligned.

4 4 Press down a little hard with two fingers, and hear two clicks, and you're done.

The bayonet should be aligned.

When pressing, the force should not be too large or too small.