VS2008 installation issue, the controls in the VS2008 toolbox are not available and VS2008 is also r

Open the VS2008 installation ISO file with UltraIso, extract the Setup file to the hard disk, open it with Notepad, empty the contents, and copy the following contents to the file.

version]

signature = "$windows nt$"

provider="microsoft visual studio 2010 professional edition - enu"

version=

nullstring=null stringlang=1033

scenario list]

scenario factory information]default scenario=11e4c8f3-425e-43b9-b689-8bfdf03342e2

Then select Save As, note that the text encoding format is applied ASCII, and save as a file with the same name overwritten.

Replace the modified file with ultraiso and save iso I also had the same problem last time, but I followed the above steps and it was able to open.

Do you have any more questions to keep asking me.

There is a problem with the installation software under you, you are under the updated version of VS2008, your computer is not even installed with VS2008, and you still need to update, so something went wrong! You can re-install the software of VS2008!

The controls in the VS2008 toolbox are not usable and are also reinstalled with VS2008 is caused by a setting error, the workaround is:

1. First of all, make sure that you are not in the ** writing interface as shown in the figure below, because there are no controls in the toolbox window on the right under the interface, this is because it is impossible to drag the controls directly into the ** window, so VS does not display the controls.

2. Even under the ** window, right-click on the blank space of the toolbox window and select Reset Toolbox, and you can't see the controls.

3. Or right-click on the blank space of the toolbox window to select all display, although there are controls displayed but they are gray and cannot be dragged, these are still caused by not being able to drag the controls into the ** window.

4. Switch to the design window and then look at the toolbox, there are controls, if you don't right-click on the blank space of the toolbox window and select Reset Toolbox, it will come out. If it still doesn't, restart the software or restart the computer, and then reset the toolbox.

.Open your file browser, click on "Tools", and set it to "Show hidden files and folders" in "Folder Options".

Delete"", "", "toolbox_", "toolboxindex_"Four files.

Restarting Visual Studio, here you might have to wait a little longer, vs configuring the toolbar. Then you can see that the toolbar is back.

What does it mean to not be able to use, and what does it not prompt?

Is it a control that doesn't have any, or can't it be dragged up?