How to put XP system into a USB flash drive

Do you want to install XP system from USB flash drive to computer?

Then it's to find a system image, generally ghost system installation disk has, you copy the more than 600M of that gho format file to the U disk, start the computer from the U disk, of course, the motherboard supports the U disk boot, and then use the ghost software to restore the GHO image to the computer boot partition C;

Among them, it is also necessary to see whether the computer has a partition, the version of the ghost software, etc.;

Install PE bar,In fact, PE is also XP,It's just for players.,Due to the lack of some DLL files,A lot of games and programs can't run.。

Don't get it.

The line should be partitioned by the USB flash drive, just like a portable hard disk to use the system data.

It is particularly prone to breakage.

No, the operating environment of the XP system is a hard disk, and it is not feasible to install the XP system into a USB flash drive as a hard disk. There is a dedicated operating system for USB flash drives.

You'd better find someone by your side to teach you how to do it! Practical teaching will be better!

Write directly to the USB flash drive with PE and boot the computer from the USB flash drive.

Put the XP system in a USB stick and use it to install the system.

The operation process of the USB flash drive system is as follows:

2. Plug the U disk into the U port of the computer, open the software to find the U disk, and make the U disk into a system to start the disk.

3. After the production is successful, copy the XP system to the U disk, if the U disk is large enough, you can also copy win7 and win8 into it.

4. When the copy is completed, the U disk of the multi-operating system will be successfully activated.

5. Before installing the system, just restart the computer and enter the BIOS to set the first driver to U disk to boot.

6. Select the system you want to install in the installation interface.

Dizzy. The first floor says at least 16g

Flash drive. Pure.

If you install the system on a USB flash drive, you only need to install PE in the USB flash drive to start.

ISO image.

It's about 600m.

After decompression, find the unknown file with the gho suffix and copy it to the USB flash drive.

Go into PE and restore this file to the C drive.

You have to make an image of the USB flash drive first, or you can start the image with a CD, but the system must be GOST version.