How many volts is the additional DC for mobile substation detection leakage?

Generally speaking, the additional DC amplitude is about 20 volts to 30 volts, which is mainly within this range, and it is fully suitable for its use.

The added value of mobile substation detection leakage should not be greater than, 24 volt voltage.

Mobile substations generally spend money to measure the added value of leakage, and if there are them, they are 220V, which is a little more normal voltage.

This kind of need depends on the power of your substation, and the additional DC voltage is generally 24 volts or 110 volts.

The mobile substation detects the leakage of the additional tributary is 38 volts, which must be carried out in a certain correct house, and cannot be exceeded.

It should be between 24 and 32 volts, which is relatively normal and a common condition.

Consider from the following three aspects: 1. The switch is generally marked C16, C20 and so on, and the numbers behind it indicate that the ZD is opened....2. Leakage is the insulation of the phase wire of the electrical power supply part, and Xiangtai Electric prompts if it comes into contact with the metal shell

There is a national standard for the safety voltage of direct current, and the safety voltage below 36 volts should be the safe voltage.

What is the home DC when the mobile substation detects leakage? Submit. This must be a big Buddha, and I can't find it out. Professionals read it.

1. First observe whether the plugged place is still leaking, and then spray the oil leakage prefect, and continue to check it within 12 hours;

2. Secondly, observe whether the oil level of the oil injection equipment is constantly decreasing.

Two possibilities: 1. The insulation degree of the main line cable of the explosion item exceeds the standard, or it is not exceeded but there is a situation of poor insulation You must know that the three-phase reactor is a short-time working system.

It depends on the size of your own motherboard's power supply, and then look at your own power supply, so that you can calculate how much DC power it is.

How much is the additional DC for substation monitoring? He should be 220 volts, right?

Under normal circumstances, it should be between 24 volts and 12 volts, which is a relatively normal range in this case, and it is also an uncommon model, so in this regard, it has such a situation.