What should I do if I can t connect to the Internet under the Marvell network card in Windows 10

1. First open Device Manager.

2. Find the Marvell NIC in the Network Adapter column and right-click on Properties.

3. Switch to the event tab, click on the "Installed Device" event in the "Event", ""Driver Management" is over to install the driver for the device, the following list is the driver folder name used by the network card, this drive folder is win10 comes with, and then you have to delete it, if you don't delete it, you can't install the old version of the driver.

4. The path where this driver folder is located is C: Windows System32 DriverStore filerepository, open the filerepository folder, look patiently, you can find the driver folder, delete it, if you can't delete it, disable the local connection or restart the computer and try again.

5. Next, go back to Device Manager, right-click on the Marvell network card, click Properties, switch to the "Drivers" tab, click on "Driver Details", which lists the path of the driver that has been installed for the network card, and make a note of this path. Then go back to the "Drivers" tab of the Marvell network card properties page, click Uninstall, uninstall the driver, and then quickly go to that path to delete the driver that has been installed for the network card (if you don't delete it, Win10 will automatically install it for you later). Then the drivers that come with win10 are completely wiped out.

6. Next, you can install the old version of the marvell network card driver as you like (Marvell Yukon driver**link** down is a folder called Marvell Yukon 112243,Open that folder,There is a file called,That's the driver installer,But because this is the old version of the driver in the Win7 era,You need to modify the compatibility settings first。

7. Right-click, click on Properties, switch to the compatibility tab, check "Run this program in compatibility mode", and select Windows7, and then check "Run this program as administrator", after setting, click OK, and then double-click, you can happily install the driver, the installation may take a minute or two, please wait patiently. After installation, hurry up and test it online!

1、This is caused by the installation of win10 default driver faction shirts。

2. Solution: Open Device Manager. In the Network Adapter section, locate the Marvell network card and right-click on Properties.

Switch to the Events tab, click on the "Installed Device" event in "Events", and "Driver Management" is done installing drivers for the device. The next thing to do is to delete it, if not, disable the local connection or restart the computer and try again.

3. Finally, install the old version of the Marvell network card driver (such as version): right-click on the driver, click Properties, switch to the compatibility tab, check "Run this program in compatibility mode", and select Windows7, and then check "Run this program as administrator", set it up, click OK, collapse and double-click, the driver will be installed normally, and you can access the Internet after installation.

Since win7, it has been helping users install the driver by themselves.,It's obviously okay to uninstall the network card.,But he will install it back on himself when he checks the hardware.。 Theoretically you are not connected to the Internet, you are simply connected to the route, and the network should show restricted. The reason is that your router has opened the wireless upper cavity Lu quiet network function, and Telecom is bound to the slag broadband and cannot be used by multiple users, resulting in your wired being limited, and there are only 2 solutions.

1. Turn off the wireless function.

2. Disable local uproar connection or disable network card, and use wireless network card to access the Internet.