The main reasons that affect the use of water heaters

It's solar, as it says upstairs. The others are generally water quality.

First of all, the temperature of the external environment will directly affect the power consumption of the water heater. The power consumption of a water heater with the same capacity of cold water and the same power deficit rate is different in summer and winter. For example, in the summer, when the temperature of the external environment is high, the water temperature is also high, and the heating water is fast and energy-saving, and the water temperature does not need to be too high.

In winter, it's the opposite, where the heating time is longer and the electricity is consumed. And in the summer, 40°C already feels very hot, and in the winter, it just feels slightly hot. Therefore, the daily power consumption of storage electric water heaters is closely related to the temperature of the outside environment.

Secondly, it is related to the set holding temperature. When the temperature in the storage tank drops below the set temperature, the water heater will automatically start to add heat to the water heat, and it will continue to circulate. It is equivalent to boiling water, and after a period of time when the cold water is heated to 90 degrees, the temperature will automatically decrease and then become cold water, and the next round of heating will be carried out.

Therefore, if the difference between the temperature of the external environment and the set insulation temperature is too large, the power consumption of the water heater will be greater.

Again, the power consumption and usage are directly proportional. There is no doubt about this, just like everyone drives to work every day, the longer the driving trip, the more fuel will be consumed, and the same is true for water heaters. The less hot water is used, the less electricity is consumed, and the more hot water is needed, the greater the power consumption.

The same is true for electric water heaters of different powers, the higher the power, the more electricity consumption.

Summary. Hello, dear, happy to answer your <>

Answer: The water heater has a lot of water and it is related to the sufficiency.

Does the water heater have anything to do with the abundance of water?

Hello, dear, happy to answer your <>

Answer: The water heater has a lot of water and it is related to the sufficiency.

The capacity of the water heater actually refers to the maximum amount of hot water energy that can be heated per unit of time. Take 8L as an example, when the fire is maximum, the water inlet temperature is specified as 25 degrees, the water outlet temperature is 45 degrees by default, and the maximum water output in one minute is 8L, the same reason, if it is 12L, the current front table is also in 25 degrees of water intake, 45 degrees of water, its maximum water output per minute is 12L. The heating power of the water heater is fixed, so when the water volume is small, the more heat energy is obtained, and the water temperature is higher.

When the water flow is high, less heat is obtained per unit of water, and the water temperature is low. The normal heating water volume of the water heater is fixed and has a maximum value, so when the water volume is adjusted, the adjustment is too large, and the water temperature will be low when the water volume is bent sharply and the water is greater than the heating speed of the water heater.

It's okay to show you.

It's okay to kiss It's normal.

1. How much heating depends on the ambient temperature and water consumption in the season, generally in summer, it can meet the temperature of the bathing water at about 40 degrees, which is more energy-saving, and the water temperature must be adjusted to the highest in winter, otherwise the hot water will not be enough.

2. The hot water in the tank of the storage electric water heater is pushed out by tap water (cold water) into the water tank, that is, the cold water enters from the bottom and the hot water comes out from the top, so the water in the tank is always full, the principle is that the hot temperature rises, the cold temperature drops, the hot water is always on the top, and the cold water is below. A 50-litre water heater is only enough for one person to bathe in winter, but it can supply multiple people with water in summer. It is recommended to take separate baths in winter, and there is no problem if you do not wash them at the same time.

3. As long as the electric water heater has a reliable grounding wire, there is no need to cut off the power supply when taking a bath, and there is no problem in always keeping the electric heating state. If the power of the water heater is within 3000W, it is recommended that you replace the power socket with a 16A switch, so that when the water heater is not in use, you can directly turn off the switch on the power socket, so as to avoid the phenomenon of poor contact when frequently plugging and unplugging the power plug.

4. I don't know what structure your water heater water valve is, usually when you don't use the water heater, you can just close the tap water valve, and the adjusted water temperature should not be adjusted frequently, so it is more convenient to use.

In addition, the water tank should be cleaned regularly according to the operation method of the local water quality to ensure that the water heater can be used normally.

Answer: 1: The bath temperature varies from person to person, you can burn the temperature a little higher, and others can use mixed water to adjust the water temperature.

2.This is normal, especially if women have long hair and therefore use a lot of water. The solution is to take a bath at different times (there is no need for your wife to wash it as soon as she finishes washing, you can wait a while to wash).

3.Not feasible. First, the leakage protector on the plug must be reinstalled if there is no leakage protector. Second, if the power needs to be cut off, it is necessary to install a cable switch and control the AC controller.

4.Not feasible. Since it is a daily bath, why do you need to cut off the electricity, the electric water heater has the function of automatic heating and heat preservation, which may not be more electricity-consuming, and it may cost you more electricity to reheat every day (you can install an electricity meter to measure).

5.I don't know what that means. Do you have other valves installed in front of your water heater? The correct way is to install an angle valve (to control the inlet water flow), and at the end of the installation of a control valve (open directly to the maximum, which reduces damage to the valve), and finally use a mixing to adjust the temperature of the hot and cold water.

Just follow the instruction manual.

Is the questioner Chinese?

Judging from the information displayed in ** combined with the description, this has little to do with the water heater itself, and it should be an abnormality on the water system pipeline.

In the process of heating water in the storage electric water heater, the water pressure in the water system pipeline will rise, and a connection on the water system pipeline will leak if it is not well sealed.

It is recommended to consider replacing the water heater with a new pressure relief valve on the tap water inlet line, and at the same time consider disassembling the leaking part and re-winding the raw meal tape and sealing it.

Small problem, the air pressure is insufficient, just change the pressure reducing gate valve!