No wireless network can be found in the area. 5

You see if your wireless router is set to hide, assuming that your mobile phone has been successfully connected to your wireless router and connected to the network before, then your mobile phone will save this access point, no matter whether you set it hidden when you turn on the router next time, your mobile phone will definitely be searchable, if this is really the case, the portable will naturally not be able to search.

Another situation is probably because of a problem with your wireless network card driver.,You're in ****.,I thought my sister's computer was just because I found a driver on the Internet and installed it.,As a result, it can't be used for a while.。 Finally, on the official website of ASUS**, a correct driver can be used. So you must go to the official **** corresponding model of the network card model driver.

You can try it in two ways:

Take your notebook to someone else's Wi-Fi network first to see if you can access the Internet, if so, it means that your notebook settings are fine;

When you come back, find a network cable to connect your book with your unlimited router, and see if you can access the Internet, if you can access the Internet, it means that your unlimited routing hardware is normal; If not, the problem is obvious, and it's much easier to check again, right?

4. Modify the MAC address of the wireless network card to the MAC address of the machine that can be used, if you can only access the Internet at this time, then your wireless network is set up with MAC address filtering or IP-MAC binding If yes, then you only have to find.

If your laptop is HP, it is likely to be incompatible with general wireless routers. You can find other information about this online.

It is estimated that it is an IP conflict, so set your native wireless IP to a private IP

When setting up TP-link, you need to turn on the bridge function!

Mine is also this problem, how did you solve it?

Check whether the physical switch of the wireless network card of the computer is turned on normally, if the physical switch of the wireless network card is turned on normally, then you can try to open it in the start-run, and find a service of wlan autoconfig in it. If the service is disabled, right-click on it and select 'Properties', click 'Start' in the startup status, and select 'Automatic' in the startup type drop-down menu after starting the service.

There are two ways to fix this:

Cause. 1. The syslog service is disabled.

Here's how.

If the event log service is disabled, the wireless network card may be displayed, and the wireless network cannot be found in the area.

After entering the main interface of 360 Guard, you can see the optimization acceleration option in the function item selection below, click to enter.

Then find the Startup Items option below the Optimized Acceleration interface, and click to enter the System Startup Items interface.

Find the key service options in the upper menu bar and click to enter the list of key service startup items of the system.

Cause. 2. The wireless network card is not turned on.

Here's how.

Right-click on the network icon on the desktop, find the Properties option, and click to enter the network properties interface. Go to the main interface and click on the Change Adapter Configuration option in the upper left corner.

Then right-click on the network you are currently using, right-click on the properties to see if the wireless network card is disabled, if it is disabled, just right-click and select Enable to complete.

Reinstall the system and network card driver to try it.

1.Check to see if your wireless network switch is turned on, or to see if you have pressed the FN+ wireless network card boot sign to turn off the network card.

The wireless network card boot sign is like a mobile phone signal sign, generally in F5 to F12 depending on your model. It's best to take a screenshot, I happen to this every day.