Homemade water conditioning questions, ask an expert to answer 50

You should be equipped with the commonly known environmental protection air conditioner, the use of tap water, there is a wet curtain in the equipment, tap water is poured on the wet curtain, evaporation takes away part of the heat in the wind, the air temperature of this equipment will be 1-5 degrees lower than the air temperature, the effect has a lot to do with air temperature and air humidity, this equipment will also humidify the indoor air a lot when it is slightly cooled, if the things stored in your warehouse can not be wet, or don't use this kind of thing.

Replacing tap water with deep well water will cool down better, but it will not be the same as a real air conditioner.

Now the legend of water air conditioning, the equipment using fan coil unit and other equipment, and the real air conditioning terminal equipment is the same, the difference is that the cold source is not from the air conditioning host, but directly from the deep well water, if your deep well water temperature is low enough, can reach the air conditioning 7-12 degrees of water temperature, then congratulations, as long as the number of your terminal equipment is enough, then you can fully enjoy the real air conditioning effect, if the water temperature is not so low, or the end equipment is not so much, This water air conditioner will also work much better than the equipment you are using now. The most critical thing is the temperature of your deep well water temperature.

The core of a water air conditioner is the water temperature. The well is not deep, and it needs to be driven into the constant temperature water layer, which is different from place to place, generally 4-10 meters. The lower the water temperature, the more effective the water air conditioner will be!

At the same time, two wells are punched at the same time, and the wells that are not too far apart are in and out of the circulation. It not only solves the cold and heating supply of water air conditioning, but also solves the circulation and reflux of water! It is best suited for plain areas.

In the northern region, it is advisable to solve the problem of wellhead insulation. The distance between the two wells should not exceed 5 meters, mainly for the water cycle and the full use of water resources. Depending on the number of water air conditioners, the power of the pumps used will be different.

The water air conditioner should first set the appropriate temperature, and then choose the appropriate angle of the air outlet to clean the air filter.

1. When using the air conditioner for the first time, you should read the "Instruction Manual" in detail and operate it according to the methods introduced above.

2. Set the appropriate temperature: generally set in the range of 26 -27 is more suitable for people's feelings, because many air conditioners now have an economic sleep function, so it is best to start the function before going to bed to ensure that you will not feel too cold when you fall asleep and wake up.

3. Choose the appropriate angle of the air outlet, and try to avoid aiming at the human body, especially when people directly blow cold air during sleep, it is easy to get sick. At present, the two-way scientific air supply function of the air conditioner can generally solve this problem, and the angle can be automatically set to face up when cooling and down when heating.

4. Use the timer effectively. When sleeping or going out, use the timer. Make it run only for as long as necessary to save power.

5. Clean the air filter frequently, the filter will reduce the operation performance if it is blocked, which will lead to an increase in electricity costs, and it should be cleaned once every half a month.

6. Do not let sunlight and hot air enter the room, and it is best to use curtains or blinds to block the sunlight when the air conditioner is open; At the same time, after turning on the air conditioner, try to open the doors and windows as little as possible to reduce the loss of cooling capacity and save electricity.

7. There are objects to block the air inlets and outlets inside and outside the city, otherwise it will reduce the cooling and heating effect, waste electricity, and cause the air conditioner to fail to work normally.

8. Turn on the air conditioner only when necessary, which can not only make the air conditioner be effectively used but also save electricity.

9. When turning on the machine, first turn on the cooling or heating in the strong gear, if your air conditioner does not have a strong function, then it is best to turn on the high wind gear, and then change the setting to the middle gear or resist when the temperature is suitable, so as to reduce energy consumption and noise.

Advantages of water air conditioning:

1.Comfortable and healthy: moderate dehumidification is not excessively dry, and the relative humidity always maintains the most comfortable level of 60-65% of the human body, which overcomes the defects of excessive drying of freon air conditioners and can reduce the occurrence of air conditioning diseases.

2.**Low and low power consumption: Because there is less of the compressor part of the outdoor unit like the general air conditioner, and the power consumption is only 1 10-1 25 of the general air conditioner, the water air conditioner is a more economical and practical air conditioner.

3.No pollution, no noise: water air conditioning does not need to use freon as a refrigerant, without any chemical pollution and exhaust gas and heat emissions, so it will not produce substances that pollute nature. In addition, the water air conditioner uses an air-water separator to completely eliminate the noise of the water flow in the air conditioner.

1. Water air conditioning, also known as water-cooled air conditioning, uses groundwater as a circulation, the water temperature of about 15 meters underground is usually about 18 degrees, and the water is pumped up with a pump in summer, and the fan coil unit in the room is used to achieve the purpose of refrigeration, and the return water flows back to the ground through the pipeline. In winter, this cycle can achieve the purpose of heating.

2. The use of water circulation of air conditioning, which is commonly known"Water air conditioning", which not only saves electricity but is also more comfortable than ordinary air conditioners. "Water air conditioning"Once the technology matures, the market penetration rate rises, which is a fatal blow to the traditional air conditioner. How to spend the summer smoothly in a safe and cool environment is the expectation of all city residents.

When there is no way to escape the heat, electric fans and air conditioners have become necessities. However, electric fans cannot completely solve the problem at high temperatures, and the air conditioning diseases caused by air conditioners still affect people's health. Utilizing simple water pump technology"Water air conditioning"It has been in the Chinese market for more than a decade.

This power consumption is equivalent to the electricity consumption of an electric fan, but it has the same cooling effect as an ordinary air conditioner"Water air conditioning"。Although it faded out of the market a few years ago, it resurfaced in the summer of 2006. Due to factors such as promotion and technology,"Water air conditioning"The penetration rate is low, and the coverage area is only in some small and medium-sized cities in the south.

The use of water air conditioning is actually very simple, and the water air conditioning of Handler Bao is also a very good way to use: 1. The water inlet and outlet interfaces of general water conditioning manufacturers are designed with a diameter of 20 mm, so try to use the same thickness of water pipe docking when installing, so as to ensure the demand for water conditioning water consumption and maximize the effect of water conditioning . Some installers consider the cost and cut corners to use pipes with a diameter of 15 mm or even thinner, and the result is that the effect of water air conditioning is definitely not ideal, because the water flow is limited.

When the water air conditioning interface is docked with the pipe, the soft connection is used as much as possible, and the angle of the air conditioner can be flexibly placed when the user uses the water air conditioner, so that the indoor circulating air has no dead angles and the temperature is more uniform.

2. When the water air conditioner is working normally, the surface water needs to be continuously transported to the air conditioner, and after the heat energy treatment of the water air conditioner evaporator, the return pipe is continuously discharged back to the outside of the air conditioner. Due to the consideration of the waste of water resources, water air conditioning manufacturers repeatedly emphasize the recharge of water sources in the installation design, that is, to drill another return well. Because the water through which the air conditioner flows is not contaminated and does not require any water treatment facilities, it is directly recharged to the well through the return pipe.

In this way, attention is paid to the protection of water resources and the protection of water resources from pollution. Considering the service life of the well and the temperature of the well water when drilling the well, our design requires the minimum distance between the two wells to be 15 meters.

3. Reasonable selection of water air conditioning pump is also one of the correct use of water air conditioning, and the flow rate of water pumps of large manufacturers is sufficient and the use mission is long. The pump of the small manufacturer is cheap, and the motor is wound with water and aluminum wire, which has high energy consumption and short service life. So try to choose some brand-name products.

Answer: The location of the indoor unit of the wall-mounted air conditioner needs to be selected, not blowing at the human body, not being directly irradiated by the sun, etc., after the selection, then you need to fix the installation plate. First of all, remove the mounting plate on the back of the indoor unit, and keep it level, pay attention to the size of the ceiling and the left and right walls, and the position of the mounting plate also needs to be fixed. The next step is to punch holes with bricks and fix them with screws, this process is not simple, you need to use a level to determine the level of the mounting plate.

The model of the wall-mounted water air conditioner is different, so when playing the drill bit, you need to choose the corresponding type of drill bit, you can use an electric hammer, you can also use rhinestones, etc., pay attention to not play in the place where there are wires in the wall, or the wall is particularly hard. Note that the position of the hole through the wall should be slightly lower than that of the indoor unit, so that it is convenient for future drainage. If it is a drill, pay attention to the use of plastic cloth to stick to the wall or use other methods to prevent water flow on the wall, and the electric hammer should be used to install a dust-free device.

According to the position of the air conditioner to be installed, determine the direction or position of the input pipe, so as to determine the left outlet, right outlet, left back outgo pipe or right back outlet, pay attention to the height of the connecting pipe should be designed, and the need to fix should also be fixed.

The power cord and signal cable need to be installed, placed on it, and bandaged, taking care not to use too much force or too loose. In many cases, the length of the drainage pipe is prone to be insufficient, and it needs to be lengthened at this time, and the connecting parts should be sealed well, and there can be no bending. The extended pipes also need to be fixed and the insulating material should be covered.

The last step of installing the hanging type of the indoor unit of the wall-mounted water air conditioner is to pass the wrapped pipes and connecting lines through the wall holes, which need to be hung at this time, and pay attention to the use of a level to measure whether the inner unit is level, and should also pay attention to the firmness, and there can be no upper shaking.

The above are the steps for the installation of wall-mounted water air conditioners, and the installation and operation are quite complicated. It is necessary to ask professionals to do this work, and the quality of installation should be strictly controlled. The installation is in place once it can reduce many unnecessary troubles in future use and can reduce maintenance costs.

1. Modify the household air conditioner to water air conditioning mode: that is, connect the compressor of the air conditioner to the main engine of the water air conditioner and dissipate heat through water cooling.

2. Principle of air conditioning refrigeration: liquid vaporization refrigeration is to use the heat absorption during liquid vaporization and the exothermic effect of condensation to achieve refrigeration. The liquid vaporizes to form steam.

When the liquid (refrigeration working fluid) is in a closed container, there is no other gas in the container except for the vapor produced by the liquid and the liquid itself, and the liquid and vapor will reach equilibrium at a certain pressure, and the gas at this time is called saturated steam, the pressure is called saturation pressure, and the temperature is called saturation temperature.

It's not easy to change.

Ordinary household machines have an indoor unit and an outdoor unit, while a household water machine has a circulating water tank in addition to the indoor unit and outdoor unit, and there is also a circulating water pump inside.

Why is it not easy to change, first of all, the size of the circulating water tank you need to design, according to the different indoor load design of different sizes of water tanks, small output is not enough, large occupy space. Secondly, the design of the pump needs to be considered, otherwise it will be noisy. Again, because the indoor unit of an ordinary household air conditioner is different from the indoor unit of a household water machine, it needs to be changed.

Finally, the control of the circuit part is completely different.

The above 4 points are more troublesome to change, and even if they are done, they may not be easy to use.

Buy an air conditioner water pump, buy a car water tank, and buy a fan, depending on the size of the room.

Transformation plan: The copper pipe in the condenser is removed, then bent into a multi-layer serpentine coil, and put into a water cooling tank, and each layer of coil is separated by a partition to form a cooling channel. The refrigerant flows in reverse with the cooling water.

Then change the ceiling space of your bathroom and kitchen into a water storage tank, install the original ceiling decoration board at the bottom of the water tank, so as not to affect the beauty of the original ceiling, the hot water from the air conditioning water cooling tank is first input to the water storage tank of the bathroom, and the water tank will naturally overflow to the water storage tank of the kitchen when it is full, if the kitchen water tank is not enough, you can make the space of other ceilings at home into a water storage tank, and each water storage tank is connected with the water storage tank of the kitchen with pipelines. The daily water is discharged from the water storage tank in the kitchen, and the supplementary tap water is also replenished to the kitchen water storage tank first, so that the daily tap water used at home is first used to cool the air conditioner, and then used for daily life water, which has no impact on the daily life water. If it is a cold and warm air conditioner, it needs two water cooling tanks of the same specification, in summer, two cooling water tanks are cooled in series through the four-way valve, and in winter, a cooling water tank makes hot water, after entering the hot water tank of the bathroom, the water is fed into the floor heating or radiator heating by connecting the circulating pump from the overflow port, and then the water is input to the second water cooling box for the air conditioning refrigerant to obtain heat, and the water comes out and then returns to the water storage tank in the kitchen.

The car's water tank is pretty average! But the water temperature may be a little lower!

Copper pipes will not work! The heat dissipation area is too small! And it's hard to control all the wind passing through the copper pipes. It doesn't work well.

If it is so expensive, it is recommended that you can buy a well air conditioner directly! It's only about 800. There's no need for it.

I didn't even buy the fins! And I can't install it myself!

Compare the ** of the well air conditioner with the ** you made yourself**. 1.It doesn't work very well.

2.The cost is also high, and you can't save much money. 3.

The aesthetics are not enough to buy well! And there is no control circuitry. 4.

Just your handmade time for those gaga! With the inevitable toss, I bought it directly to save time and trouble!!