Boot detects that the hard drive is stuck at Energy Star 10

Hard drive bad sectors? Removing the battery on the motherboard can only restore the boss factory settings, which is useless. You go to the next hard disk detector and check the hard disk handle, there may be bad sectors so there will be loss and card when reading data.

If it's a bad sector, the problem is not big, you can fix it with software by yourself.

Motherboard problem,Just sent for repair,That's the case,Boot is particularly slow,Welcome to use the interface to read the disk for 10 minutes before entering the system,Finally, take a look,It's a problem with the motherboard,Restore the motherboard to try,If it doesn't work,You have to find a professional repair。

On which disk is the system mounted?

How many years of motherboard? The current disks are all SATA disks, and if the old motherboard does not have its own SATA driver, the system needs to be equipped with SATA driver, and if you can't enter the system without a driver, it is a blue screen. (Vista and Win7 are systems with SATA drivers),XP,The original does not bring,There are netizen packaging tapes。

If there are 2 hard disks, one should be the master disk and the other should be the slave disk. Need to set up, the specific hard drive has instructions pasted on it, or you take it.

No way, the motherboard is stupid, reinstall the system, and restore the motherboard at the same time, it's important to look at the heat dissipation problem.

It may be that there is a problem with the circuit board of the hard drive......

Product model.

Hard Disk Hard Disk.

When the computer is reading and writing operations, the hard disk will send out a "rattle". The ringing sound.

According to the failure analysis, the hard drive emits a "quack. The noise is generally caused by the physical bad sectors of the hard disk. You can back up the important data in the hard disk first, and then format the hard disk at a low level, so that the hard disk can be used for a while.

The following describes how to troubleshoot a crash that occurs when loading the operating system on your computer.

1) First of all, judge according to the displayed error message. If you get a message that the system files can't be found at startup, the system files may be missing or corrupted. During repair, you can copy the lost files from other computers with the same operating system to the faulty computer (some system files are not common).

2) If a blue screen appears at startup, indicating that the specified file cannot be found in the system file, it is caused by the bad sector of the hard disk and the computer cannot read the system file. Start your computer with your boot disk, run the "Scandisk" disk scanner, and detect and repair the bad sectors of the hard disk.

3) If there is no fault above, first use anti-virus software to check for viruses, and then use "Safe Mode" to boot the computer. If it doesn't boot, it may be mainly due to system file corruption, reinstall the operating system.

4) If you use "Safe Mode" to start the computer, then exit and restart the system to see if it freezes.

5) If it still freezes, then use the backup Windows registry to restore the system (if the system cannot boot, then use the boot disk), and see if it is normal after recovery.

6) If the phone is still frozen, then enter "Safe Mode", open the "Start Running" dialog box, enter SFC and press the Enter key, start the "System File Checker", start to detect the system, if the error is found, the screen will prompt the name and path of the specific corrupted file, then insert the system CD, select the "Restore Files" command, the lost or lost files will be restored.

7) Finally, if the system still freezes, reinstall the operating system.

If the hard disk has a logical bad sector or 0 track damage, it is recommended to use Samsung's hard disk special tools to see if it can be repaired!

The hard drive is unreliable when it starts to have bad sectors.

You can only buy a new hard drive and copy the data.

Amen, may your old hard drive rest in peace! Fighting all my life, scarred, it's time to rest.

Seagate 1TB ST1000DM003 7200 rpm 64M SATA 6GB SES Desktop HDD.

Single-disc 1TB technology! All brands of 1T hard drives have the best performance!

Recommend! 429 yuan!

First try to fix the bad road, if it doesn't work, then include the approximate place where the Huaidao appears in the area inside, for example, it is estimated that the approximate location of the first 3G has a bad road, so that the front 5G is divided into a zone, so that the bad road is included in it, and then hide this area, so that the computer does not use this area with Huaidao, and the rest can be used,

It is recommended to back up the hard disk data with a mobile disk, and then try to repair it with a hard disk tool, if it is a fake bad sector, it can generally be repaired, if there is really a bad sector, it can not be repaired, so the part with a bad sector is divided into an area (before and after the large point), the area is hidden after partitioning, the windos system does not recognize that area, and skips it when reading the disk, the hard disk can continue to be used, but do not store important files, because the hard disk life of the bad sector is not long.

Don't try to fix the bad sectors anymore, the more problems you have, the more you will either fix it or replace it with a new one.

If you have physical bad sectors, it is better to repartition them, and separate the bad sectors from the surrounding areas, and if you don't build a file system, the system will hide the bad sectors.

Format at low speed and then repartition to avoid those bad sectors.

Make a backup of your important data, then repartition, format, and repair your hard drive.

HD has not been used.

You can use the erase command in mhdd or the advanced format in dm or thdd to fix it (specializing in x bad sectors).

If you can't fix the bad path, it's basically a death sentence.

It is recommended to format all and then repartition the installation system.,If you don't, let the installation system help you get it.,Ten dollars to get it.。

Go to the computer shop to repair it, the hard drive needs to be formatted and repaired.

Buy a new hard drive and put important information in

I'm going to plan to plan for Ace Ann.

First test whether the hard disk has bad sectors, if there are no bad sectors, it should be good to format the hard disk, it is possible that the hard disk partition table is wrong and other problems, first find a way to back up the data, and then throw it to a professional to get it.

It is very likely that the system program is chaotic, or it may be a virus, if it appears many times, it is recommended to go to the place where you bought the computer to reinstall the system.

I'll tell you, the computer is installing something, some things are installed without a normal reboot after the power is off, which is very dangerous, now you can go to repair, restore the system, if not, you have to reinstall, I often have such a situation, you also run my computer to play, he is too, the power is off and turned on, several times the system can not be turned on, if it is just a power failure, you can repair it through the system installation CD, if I install a lot of things, such a power outage is basically the end of the system, reinstall, Personal computer personal use is used to it, to install the system once, restore in the place you were used to before, you have to spend a lot of time, no way, but, now I use the shadow guard, now I'm not afraid, hehe, I hope to share my experience with you.

It is estimated that there is a problem with the hard disk, first reinstall the system to see, if it doesn't work, the hard disk has a bad sector, if there is, congratulations on winning the lottery, change the hard disk to 1! 1

Hello, this situation occurs because the system of the disk is faulty and cannot be repaired! At this time, you should use the system CD, the system CD to be installed, put it in, read the file and then press R as prompted, enter the system repair program to perform the repair!

If you only have one system on your computer, press 1 to select the first system, and if prompted, enter the administrator password to enter the system repair! Then execute chkdsk r p to repair, in your situation, it is generally recommended to perform 2 chkdsk r p repairs to ensure that the repair is complete, and you can boot normally after waiting for the repair!

There is no need to reinstall the system, and this logical bad sector can be fixed with a disc! Good luck!

As for such a situation, it may be caused by a sudden power outage or abnormal shutdown! Just remember to pay attention next time!

That's your system in order to protect and manage your computer more securely, the default boot time self-test, self-detection of the hard disk, if you feel troublesome can cancel it, let it boot without it: click start - run enter cmd OK; Then in the command prompt that opens, type chkdsk f enter; This eliminates the need to detect disks;

Maybe it's a bad sector on the hard drive.

If it's an XP system, just run it on the fly:

chkntfs /t:0

chkntfs /x c:

That's it. chkntfs t:0 sets the self-test waiting time"Zero", of course, you can also customize the waiting time.

chkntfs x C: Cancel the automatic scanning of the C disk at startup, and you can also change it to another disk.

When detecting the disk, it will be stuck, because the system finds that there was an abnormal shutdown last time, and after rebooting again, the system will automatically check the system as a protected file for security, and when a certain step is detected, the system will find that the normal file has been corrupted or modified to a non-certified version, and the system will replace it with a file that can be authenticated and used normally.

In this process, if the card is stuck at 0, it should mean that the system has finished reading and writing the file index, and when a file is ready to be read and written, a disk error occurs, if a disk error occurs or the file is in a non-writable state (such as virus self-protection), the system will continue to try to rewrite again, which will cause a fake crash and nothing will be answered.

If you skip the disk detection program, the computer starts up as normal, and you ignore the error for a while, and if the error is in a critical file used in the system, an error will occur when the system is referenced, causing the system to crash.

Therefore, if there is a problem that cannot be repaired automatically, the system will basically be reinstalled, otherwise it will be more troublesome.

Since you can also self-test. The system should be fine, but there may be not enough page space, just click, if there is a backup, rewrite the system. If not, go to safe mode and see if you can enter the system. and fixes.

Stupid way: Remove the hard disk, hang it on another machine, if you identify it, back it up quickly, and then repair it! Formatting, repairing partitions, low-level formatting – no more, change the hard drive.

The hard disk has a very large possibility of bad sectors Find someone to take a look at it I also had this situation in my previous notebook Later, it was determined that the hard disk was broken And don't force it to shut down anymore.

Try to see if the fan is not spinning fast, whether the book is overheated, if it is very hot, wait for it to cool down, if it cools down, there is no problem, and the dust is decisively cleaned.

Then there is the problem of bad sectors of hard disks, which is generally uncommon, if it is a logical hard disk, bad sectors can be solved by low grid, if it is a memory problem, decisively change the memory.

However, the most common thing to do is overheating.

The first possibility is that your hard drive has been corrupted. There's something wrong with your system. It's best to take it to the repair station or, if you have a warranty, take it to the repair station.

Reinstall the system first, if it still doesn't work, it may be that the hard disk is broken. Let's get a different hard drive!

Don't force the shutdown like this, it is easy to cause the hard disk partition table to be corrupted.

First of all, you have to make sure that you are really dead, because sometimes the test takes too long and looks like it is dead, but it is not, I have been tested for dozens of minutes.

Second, if the test fails, you can press esc to skip the test before the test starts, and then go to Windows to find some third-party detection tools to detect.

If it crashes like this repeatedly, you should consider whether the hard drive is damaged and think about backing up important data in advance.