My home s preparation is the same as that of the Internet caf , why does the Internet caf boot up s

Updated on technology 2024-04-25
8 answers
  1. Anonymous users2024-02-08

    The landlord is so stupid!! The upstairs is full of garbage!! Don't pretend if you don't understand!!

    There are two reasons for this!

    First: The Internet café uses optical fiber, so it's fast, and the general network cable is used at home, you go and ask the owner of the Internet café if he uses optical fiber!!

    Second: that's because your system has too much junk to clean it up! Close some unused programs and you'll be faster.

    Good luck!! Hope you succeed.

  2. Anonymous users2024-02-07

    What system do you have installed? It's just a system version that is different and different! And some Internet cafes will use network management software to optimize the system! It's also normal to have a fast boot speed!

  3. Anonymous users2024-02-06

    It's not a problem of configuration, it's a problem of network speed, Internet cafes are generally 1 trillion network, and the home is only 1 megabit.

  4. Anonymous users2024-02-05

    It's not a matter of configuration!

    It's a matter of system optimization!

    For example, there are more and fewer programs to run on the boot!

  5. Anonymous users2024-02-04

    This has nothing to do with the computer, your system, just change the system.

  6. Anonymous users2024-02-03

    The next optimization master, use it, there is an automatic optimization function!

  7. Anonymous users2024-02-02

    Why is the client slow to start, and sometimes it takes 10 minutes to start? Improving the startup speed of CCBaw diskless client is considered from the following three aspects:

    1. For the selection of the client system installation package, it is recommended to use the original installation package to install the client system. Don't use piracy, and don't use the version you got from the version upgrade. For example:

    When it is installed, it is the home version, and then upgraded to the ultimate version, which will cause a large amount of data to be read when the diskless client is launched.

    1) The data of win7 64-bit normal version is as follows:

    Before the write-back data reaches 7K, it needs to be read about 50M, and the write-back data is about 80M after 7K to the desktop. The read speed before 7K is around 10M/S, and after 7K, it can reach a speed of 50M/S.

    2) The data of win7 32-bit normal version is as follows.

    Before the write-back data reaches 7K, it needs to be read about 40 Mbit/s, and the write-back data needs to be about 50 Mbit/s after 7K to the desktop. The read speed before 7K is around 10M/S, and after 7K, it can reach a speed of 50M/S.

    3) The data of WinXP 32-bit normal version is as follows.

    Before the write-back data is 1K, it needs to be read about 20 Mbit/s, and after the write-back data reaches the desktop after 7K, it needs to be about 40 Mbit/s. The read speed before 7K is around 10M/S, and after 7K, it can reach a speed of 50M/S.

    From the above data, it is not difficult to see that in addition to the speed, there is also a key parameter for the image startup speed, which is the amount of data that needs to be read at the time of startup.

    2. System optimization, system optimization of client images. The key to the startup speed in system optimization is the NIC driver and NIC optimization. Whether the NIC driver is appropriate can directly affect the throughput of the NIC, that is, the performance of the NIC.

    The second is NIC optimization, which is to set the NIC properties and parameters in the NIC network attributes. For example, traffic control in NIC properties is disabled. For details, please refer to the ccboot description or related introduction.

    3. For the server-side settings, the server-side image must be set up with a memory cache, no matter what disk is used to make the image disk. The write-back disk must use a single disk, and it needs to be formatted to 32k.

  8. Anonymous users2024-02-01

    I think it should be looked at from several aspects.

    1. The Internet café machine has the function of restoring the initial state, and after recovery, it is like a machine that has just installed the system, and there are not so many junk files, of course, it is fast.

    2. What the Internet café machine requires is speed, and it is not necessary to require the brand and quality (the quality is good and poor, but the gap is not so big, the quality is slightly on the next level, and the ** has also gone up), that is to say, the configuration of the Internet café machine is relatively balanced, and there is no bottleneck.

    3. Software problems. Home machines are often installed with a lot of software, for example, if you install a Kaspersky and at the same time install Jinshan Cleaning Zhenqin Expert, and also install 360-degree guard, repeated installation will take up a lot of memory, although some are uninstalled, but the processing is not clean enough, and it has an impact on the head of the brigade.

    Suggestions: 1. Do disk cleaning frequently (one month).

    2. Ghost your system disk, or a few times to recover.

    3. As long as the software is enough, don't install everything, try everything.

Related questions
7 answers2024-04-25

It's different, it's not the same in terms of edible efficacy. >>>More

4 answers2024-04-25

CBA is the rules of FIBA, NBA is the rules formulated by its own league, and in terms of management, CBA belongs to the Basketball Association and NBA is independent. >>>More

13 answers2024-04-25

No. The meridian, also known as the meridian, is an auxiliary line hypothesized by human beings for the convenience of measurement, and is defined as a semicircular arc on the great circle line connecting the north and south poles on the earth's surface. Everything on the earth that is formed by the plane of the earth's axis is cut off from the ground by the plane of the earth's axis is called a "warp coil". >>>More

11 answers2024-04-25

Because the frequency of the wave is fixed, when the frequency is fixed, it naturally means that the amplitude is the same, the amplitude is the same, and the period is the same. >>>More

8 answers2024-04-25

The surface hardness of aluminum alloy anodizing is up to 250 500 kg square millimeter, because the high hardness determines the wear resistance of the oxide film is very good. >>>More