Questions about the Internet connection of the road rover

DNS settings: , and then ping the following, if you can get through, then rely on the external network, for example: ping

If not, the gateway is not connected to the Internet.

If the ping does not work, there is a problem with the cable connection, or the cable itself is also faulty.

You can enter the router management interface, which means that the computer and the router are connected. After the route logs in to the network, a DNS address will be generated, have you filled in the DNS of the computer network connection?

First of all, confirm the two problems, the network cable is good, and the routing IP is good.

Both computers must be set up with DNS, which can be set to a faster DNS address in your local area.

You don't have DNS, you ask telecom for this.

The wireless router has a transmission speed of 54Mbps

There is a line by the general 100mbps+

The current internet speed is up to 10Mbps for basic home use

So wireless wired is not very different for home use.

A wireless router is simply a wired router that adds wireless transmitting and receiving capabilities.

Since the wireless signal may be limited by the wall, the distance.

There are also interferences from other appliances.

So it may cause the signal to be unstable, generally speaking, if you use this book, it is better to use wireless.

If you're playing an online game, play with a cable plugged in, because online games care about connectivity.

You first check whether the crystal plug of the network is loose, click on the computer, and then open the device manager to find the network adaptation.

If the orchestration point is deactivated and restarted, it may be fine. If not, don't be angry!

Sit back, have a cup of tea, and cheer up.

It's a hot summer, the temperature is high, don't you feel hot? Devices (devices are: cats, routers, network switches, Hubble, computers, etc.) also feel hot and can't work; You may wish to refer to the following methods and adopt measures that you feel are acceptable to reduce the temperature of the working environment of the equipment.

A: Users who often surf the Internet for up to half a year should open the shell of the device after the power is off and clean up the dust in the device.

b: Place the equipment in a safe place for people, open the lid of the equipment, and use air convection to strengthen the contact surface with the air for natural heat dissipation;

c: Install a micro fan to the equipment to increase the convection of air and force heat dissipation;

D: If you are doing IT, I suggest that you install a heat sink on the heating part of the device after disconnecting the power supply.

e: After the equipment is disconnected from the power supply, use a 3mm drill bit to drill many holes up and down the equipment to strengthen the air convection flow and improve the heat dissipation conditions;

F: As far as the equipment is dry for air to pass through the rock, it is best to make an insulating bracket to support the equipment for natural heat dissipation;

H: Let the adsl cat sync first: power off the cat and restart it.

i: The software settings are reasonable, so that 3 do not install: do not install informal software, do not install P2P (occupy resources) software, and do not install commonly used software. Turn off all unnecessary internet connections, such as Thunderbolt.

BT donkeys, etc.;

j: Optimize the network.

Personally, I recommend using some spikelets to carry tools.

For example, Super Bunny, Optimizer or 360, etc.

K: At least one valid anti-virus software should be installed on your computer.

l: NIC problem: The NIC bandwidth is appropriate and the operation is stable.

As long as you do a good job in the above aspects, your failures will be eliminated;

Thank you for my answer!

Thank you: friend!