Make a sliding door, measure the door cover, the difference between the left and the right is 4 cm,

For irregularities that are not done horizontally, with cement mortar or blockboard, customers and construction personnel must be present, the measurement must be signed by three parties, corrected, measured at the minimum point-to-point distance to measure the height, width, thickness, finished door sleeve installation needs to leave 10-25mm installation glue seams, the door stone must be paved first, to avoid deviation of the installation door, the customer blank wall thickness, width or height in the measurement with the surveyor to determine the size of the ground after completion, and mark on the measurement sheet, To prevent errors during installation, the decoration level line is the only reference standard for the ground completion size and the actual height of the hole, therefore, the decoration level must be clearly and accurately marked when measuring, and sometimes the base layer is not in place to communicate with the construction party.

It is required that the thickness of the left and right wall stacks is consistent and on a vertical horizontal plane, otherwise there may be improper installation of the door as a whole or there are gaps and uneven size between the sleeves.

The surveyor will put forward the corresponding rectification requirements according to the actual measurement of the hole size on site, and ask the customer to confirm the size of the hole installed in the product, and the customer will implement the construction team to carry out the rectification construction.

The easiest way. It's the time to make the door. Adjust it over. Because the floor tiles have been laid. If I adjust a floor tile. The floor tiles are broken. It will also affect other floor tiles. Door casings and sliding doors. Packages are fine.

In the traditional decoration, the balcony is installed with sliding doors, look at the different designs of my balcony, which attracted a lot of neighbors!

In fact, the function of the balcony is not only to wash and dry clothes, which is a waste of space. Now the commercial housing is very high, and the space of the balcony should also be effectively used when designing. The reason why sliding doors are installed on the balcony is mainly to speed up the refrigeration function of the air conditioner when the air conditioner is turned on, so as to avoid mosquitoes and insects flying indoors.

Installing a sliding door on the balcony also has the effect of heat and moisture insulation and mildew resistance, and most people may only use the balcony as a place to dry clothes.

When my house was designed, the living room and balcony were directly connected, so the design was not only beautiful; It also improves the utilization of space.

The balcony has good lighting and view, the overall sense of space increases, and a relaxation area can also be designed on the balcony. Therefore, when decorating the house, it is not necessary to install sliding doors on the balcony. The disadvantage of installing sliding doors on balconies is that the space looks closed, which also affects the overall aesthetics; It is inconvenient to take care of it in daily life.

Nowadays, small houses should improve the utilization of space in the design, do not install sliding doors, and can design the balcony as a leisure area, tatami mats, study rooms, etc. The above is through the decoration of my home, summarized about the experience of decoration, to share with you, I hope you can learn and learn from the decoration in the future.

Whether it is a sliding door or a swing door, the installation of the door is generally the final process, and the sliding door can also be installed after the house is decorated.

A sliding door is a common door used in the home, which refers to a door that can be pushed and pulled. With the development of technology and the diversification of decoration methods, the function and scope of use of sliding doors are constantly expanding from the traditional plate surface to glass, fabric, rattan weaving, aluminum alloy profiles, from sliding doors, folding doors to partition doors.

Whether it is a sliding door or a swing door, the installation of the door is generally the last process, and whether the sliding door is used for the balcony aisle or the kitchen bathroom, you can complete the decoration of the whole home and then install the sliding door.

I hope my answer can help you.

Due to the first installation of the track box and then the brick, the junction between the exposed track box and the brick is not easy to handle, which brings certain difficulties to the construction. Because the track is under a certain pressure, the bricks are also stressed, and it is easy to cause the bricks next to the track to crack over time. In addition, if it is in the kitchen and bathroom and other spaces, it is easy to hide dirt and dirt at the track box, and oil smoke and dust will fall on it, which will cause trouble for cleaning.

The size of the rail box on the upper part of the sliding door should be guaranteed to be 12 cm high and 9 cm wide. Like the curtain box, the track box is installed inside the track, and the sliding door can be hung on the track. Nowadays, most doors or openings are up to meters in height.

Experience has shown that when the height of the door is less than a meter, no matter what the height of the person is, it can feel oppressive and uncomfortable. Therefore, when making a sliding door, the height should be at least 195 + 12 = 207 cm or more, and there is enough space to make a track box before you can consider making a sliding door. Otherwise, it can only be hung externally, that is, the track box is exposed, which is definitely not beautiful, and over time, the gap between the door and the wall will become larger.

The width of the sliding door is particular. The ** size of the normal door is about 80 cm to 200 cm, and under this structure, the door is relatively stable. If there is a height higher than 200 cm, or even higher, it is best to narrow the width of the door or make a few more sliding doors under the premise of maintaining the same area, so as to keep the door stable and safe.

Be cautious of sliding doors from the ground to the top (open-hanging track box). Due to the excessive swing amplitude when pushing and pulling, the sliding door is easy to deform after a long time, and the door cannot be opened after deformation, which means that it cannot be repaired and cannot be used.

Since the sliding door is in contact with the wall or both sides of the cabinet, there should be no other objects in the contact position.

Blocking the closing of the sliding door. For example, the drawers in the cabinet should be positioned away from the intersection of the sliding doors and higher than the bottom plate.

At least 1cm; The drawers in the cabinet with folding doors are at least 15 cm away from the side walls, and special attention should be paid to the power supply on the wall here.

Switches and sockets, if they block the closing of the sliding door, the position of the switches and sockets should be changed.

No matter what material you make for the floor, make sure that it is horizontal, and the four walls of the door opening should also be horizontal and vertical.

Otherwise, the door will be skewed after the installation is completed. The adjustable error is not more than 10mm.

Please do not install the kicking line in the installation position, the plaster line can be installed on the sealing plate above the wall cabinet, if the door is direct.

Do not install plaster lines to the top.

Carpets with a thickness of less than 5 mm will be cut off and directly pasted on the lower rail. Carpets with a thickness of more than 5 mm can be directly fixed to the carpet with screws if the double track is installed: if the monorail is installed, the carpet must be cut off at the location and a 3-5 mm thick wooden strip must be placed on the carpet in advance, so that the monorail can be directly attached to it.

The combination of wooden floors and tiles, this situation mostly appears between the balcony and the living room and the bedroom and the living room, and the solution is as follows: 1. Try to install the lower rail on a material. 2. Add a wooden board or marble with the same width as the lower rail between the two materials.

Kitchen parts can also be made with sill stones.

It depends on the location, if there is something in the way, if not, it is completely fine. You'd better let the door look at it when you measure it.

Yes, although there will be more installation before decoration, but you can choose the sliding door according to the style after decoration.

It is recommended to install sliding doors first, and then lay floor tiles. This conforms to the law of the overall decoration from top to bottom, from the inside to the outside.

The reasons are as follows: from the perspective of installation and coordination, after the door sleeve is installed, the baseboard of the floor is installed, and the top door sleeve is cut and fixed, which is easier to fit tightly, and there is no need to spend a lot of time for the finishing of the baseboard;

From the perspective of finished product protection, it is relatively easy to install the door first, and the finished product protection is relatively easy, whether it is the dripping of styrofoam, the pollution of glass glue, the power tools used to install the door, the packaging garbage, sawdust, the impact of drilling and nailing, directly operate on the cement floor, and do not affect the floor tiles.

First of all, it depends on what kind of sliding door you bought If your sliding door is with a surrounding frame and a dao door cover, install the door back first, and then pave the floor. If you choose a sliding door that only has upper and lower rails and door leaves, you must wait until the floor is laid to measure the most accurate size and installation. Nowadays, there are many categories of sliding doors on the market.

You can also consult your sliding door manufacturer.

Agree with the upstairs statement, install the door frame first, so that the problem of joints can be solved when laying bricks.

This is universal, mainly depending on the style.

1.There are pros and cons. The sliding door has a good seal, but it takes up more space, and the door can only be opened halfway.

At the same time, the sliding door will be more difficult to clean after a long time because the track is below; In addition, the large area of glass used in general sliding doors makes it unsafe to have children at home.

2.Swing doors are slightly less sealed. But when it is folded, it does not take up space, which will make the room appear more spacious and airy, and it is relatively cheap.

Swing door (closed door): refers to the door with a door handle, which can call all the wardrobe doors and then close the door. For example:

Sliding door (sliding door): It is the door that can not be opened all the doors that can be opened left and right, and it is the first sliding door.

Swing doors are further divided into one-way opening and two-way opening. A single door means that there is only one door panel, one side serves as the door axle and the other side can be opened and closed, while a double door door has two door panels, each with its own door axis, which opens in both directions.

Handan sliding doors originated in China and were transmitted to Korea and Japan through Chinese culture. Originally, sliding doors were only used for bedrooms or dressing room wardrobes, but with the development of technology and the diversification of decoration methods, from traditional plate surfaces to glass, fabric, rattan weaving, aluminum alloy profiles, from sliding doors, folding doors to partition doors, the function and use of sliding doors are constantly expanding.

In this case, the use of sliding doors began to become diverse and abundant. In addition to the most common partition doors, sliding doors are widely used in bookcases, wall cabinets, living rooms, exhibition halls, sliding doors, etc. The plastic steel sliding door has the characteristics of good sealing and heat insulation, no deformation as a whole, and the surface is not easy to age.

Which is better, sliding doors or swing doors for your wardrobe? It would be nice to know sooner, don't choose blindly.

When it comes to interior decoration, we generally do the laying of floor tiles before installing sliding doors. There are several reasons for this order.

With the decoration device, you only need to enter the area + city, and calculate the most affordable local market in 3 seconds**: [Tuba Rabbit Big Platform Counts**].

No longer worry about the company's price increase, omission and price increase.

First of all, the laying of floor tiles involves a relatively large amount of work, and a series of work such as ground cleaning, leveling, and priming need to be carried out, and if the sliding door is installed first, it may have an impact on the installation position of the door, and may even damage the door that has been installed. Secondly, after the floor tiles are laid, it takes a period of time to dry and cure, and in this process, if there is a sliding door opening and closing operation, it may have an impact on the curing of the floor tiles. In addition, after the floor tiles are laid, the sliding door can be selected according to the color and texture of the floor tiles, so that the matching between the door and the ground is more harmonious.

In the local market, the floor tiles generally range from 30 to 300 yuan per square meter, depending on the material and brand of the floor tiles. The ** of the sliding door is between 200-2000 yuan per square meter, mainly depending on the material, style, brand and so on of the door.

When decorating, it is recommended that owners should not only consider **, but also consider their matching with the overall decoration style, as well as the comfort of use and other factors when choosing floor tiles and sliding doors. At the same time, it is also necessary to pay attention to the choice of regular decoration companies and brands to ensure the quality of decoration and later services. In the decoration process, you can also ask a professional designer to guide you to achieve the best decoration effect.

Is it better to have a sliding door or a swing door in the renovation? How to choose is a real problem!

Sliding doors and swing doors have their own advantages, so it is impossible to judge which is better, when purchasing, you can buy according to the size of your own space, for example, your own area is relatively large, and the grade of decoration is also relatively high, then you can buy swing doors, whether you choose swing doors or sliding doors, you must pay attention to the material of the door frame, because the good or bad of the frame will affect the service life of the door.

First of all, let's get to know the characteristics of the sliding door, the sliding door wardrobe is also known as the sliding door wardrobe, which can be divided into two types: internal sliding and external sliding doors. The external sliding door is to place the slide rail on the outside of the wardrobe, which can improve the use of the internal space of the wardrobe to a certain extent.

The sliding door is fashionable and beautiful in style design, and at the same time saves space, but the sealing of the sliding door is not good. With the continuous improvement of people's aesthetic meaning, the use of patterns is more novel and fashionable, and the creative patterns have greatly enhanced the visual effect of the swing door. In the selection of hinged door wardrobes, we must pay attention to the hardware instructions, and the hardware has a direct impact on the service life of the hinged door.