How to transform the primary filter of centrifugal air compressor?

Filter base plate modification.

The bottom of the original filter is about 10cmm from the ground of the steel mesh structure, the dust falling from the filter is all in the lower part of the steel mesh, because the height is too low, it is very inconvenient to clean and clean, in order to improve this situation, galvanized iron sheet is installed at the bottom of the original steel mesh to increase the strength of the bottom, which is convenient for replacing the filter element and maintenance, and convenient for cleaning.

Air compressors are now the main safe energy source for large-scale industrial production. But the air compressor contains a lot of impurities. Such as:

Water, rust, granules and oil, etc. Filtration through a compressed air filter is required. A precision filter is a device that filters and purifies compressed air.

So how to choose the air compressor filter?

1.The selection of the flow rate of the precision filter should be selected according to the flow rate of the air compressor, and the flow rate of the air compressor is generally greater than or equal to the flow rate of the air compressor.

2.According to the maximum working pressure of the air compressor, the pressure of the precision filter is determined.

3.The size of the diameter of the precision filter is generally the same as that of the inlet pipeline.

4.All walks of life have different requirements for precision, so choose the precision that suits your own enterprise. Different materials are used for precision filters in different environments. Therefore, it is necessary to choose the material of the precision filter according to your environment.

We often encounter customers who consult us, what is the appropriate size of the filter for the air compressor? In fact, there is no difference in the size of the compressed air filter, and the general air compressor filter only has a difference in grade, which is mainly divided into pre-filter, primary filter, pre-filter and other filters with low precision.

So how should the air compressor filter be configured? Generally, the accuracy of the pre-filter is 3-5 m, which can remove large solid particles and liquid water of a larger diameter, while the accuracy of the primary filter is to remove impurities that are small relative to the diameter of the pre-filter.

In order to meet the high-quality requirements of some enterprises for compressed air, DPC will install a precision filter behind the dryer, and everyone has questions about pneumatics.

This one is relatively simple, and it usually has a piece number. You can buy it directly, there is really no part number, and it can also be customized according to the size. It's just a little troublesome, a little bit. Kunshan Quanshuo automation equipment--Hangong will answer for you.