Razer Giant Pit Viper Set the Problem Kneel and beg!

The 2nd floor is right, this mouse now has a very strong jumping phenomenon no matter what mat it is on. It may be a year or two after the firmware will be flashed and it will be resolved. If you can't wait, it is recommended to change to Viper or Logitech MX518

It is true that Viper's technology is not as mature as Microsoft's, especially not comparable to the one in my hand.

Well, the warranty in this case has been voided, and the screws should be found under the foot pad and the sticker at the bottom, so remove it yourself.

Viper can adjust the dpi by setting a certain key in the driver, the first problem you said is a common problem, the general can be alleviated with a new driver or update the firmware, you can put it on the hard table to try to see if it still shakes.

If you don't shake, then change to a hard mouse pad.

In general, it is better to use it on a hard mat.

The scroll wheel problem you are talking about can basically be thought of as a quality problem.

It is recommended to exchange the product immediately.

Didn't the Giant Belly Snake run away on the Ant King?

If there are no giant ants. It's hard to buy a giant belly. When the giant belly came out, the laser engine technology was not mature enough.

So super super super pick mats.

The roller is temporarily out of order. Personally, I think it's a mouse problem.

Let's change it in Bao. I don't think there's much of a problem with the computer power supply.

Laser emitting port? Gaskets? It's not a big deal.

It is generally a problem with the production batch. Don't care, don't care

Isn't it possible for a viper to convert DPI by a driver?

And the button at the bottom also supports changing the DPI

Why did you change your belly? Tragedy.

If you are mainly playing FPS games, there is a Viper in the razer mouse, and there is no need to choose other models, and there is a DPI that can be adjusted under the Viper chassis.

Born to drop frames.

Sell it, go buy G9X

That is, if the brush is broken, send it to the factory for repair, and don't get it yourself.

The compatibility of this mouse is very poor, and it is risky to flash the firmware, and it has no great effect if it is brushed, so it is best not to brush it.

Bulk can also go to the boss for repair. I don't know if LZ has been buying for a long time, but you can go to the place where you bought it and try it. Tell the boss that the mouse won't move when you use it, and I don't know why, you won't sell second-hand.

If you say something like that, it's better to call someone who is very good at talking and talking with you.

Generally speaking, if the mouse is broken, you can't fix it.

Quite simply, defend your own rights and interests.

Razer one-year replacement If the time is not up, take it and get a new one, not to mention that the firmware is broken.

Install the driver first and then flash the firmware.

In other words, it doesn't make much sense to flash the firmware, install the driver, set the dpi and hz.

If you wait for a while and still don't move, just place a new one.

This is the official address.

The former and the latter are not ideal, the frame skips are relatively high, and the mat is very picky.

It's OK around 2000, and there must be an adaptation process for razer with the habitual G1. Although the giant pit is very picky about the mouse pad, it still can't hide his light, and it is still very royal to match a good mat You will love it when you get used to it.

Directly with the system's own drive.

My Purgatory Snake is the driver of the installation manufacturer, depressed and has not installed the driver. It's annoying.