Can I continue driving if the water temperature in my car is high and there is no shortage of water?

The car can't continue to drive because the water temperature is high. Under normal circumstances, the normal working temperature of the engine is about 90 degrees, which can make the engine have good power and economy, and at the same time reduce wear and prolong service life.

The engine temperature is too high or too low will cause: wear and tear, power decline and other phenomena, especially if the temperature is too high, if the engine is easily damaged if it works at high temperature for a long time, and even the engine will be scrapped in serious cases.

If you encounter high water temperature or alarm, you can simply check and judge it yourself:

1. You must immediately pull over the roadside parking lane, turn on the double flashing lights and place a warning triangle after parking to remind the rear oncoming vehicles to pay attention to avoid (especially on the highway).

2. Don't turn off the engine immediately, turn on the heater air conditioner to the maximum gear, which can help the engine dissipate heat, because the cooling water pump is driven by the engine, if the fire is turned off, the water pump will stop, and the coolant will not be able to continue to circulate, which is not conducive to engine heat dissipation, and then continue to observe the water temperature gauge, if the temperature will not drop and then extinguish the engine.

It is not recommended to continue driving if the water temperature is too high, it will reduce the engine life and cause engine failure, it is recommended to stop and turn off the engine as soon as possible.

As long as the water tank is not boiling (boiling), you can continue driving. But still pay attention to the lack of cooling nights. Check that the cooling fan is working properly, and try not to drive at high throttle at this time

If the water temperature is too high, it is not recommended to continue driving, so you should stop immediately and turn off the fire, stop in a position that does not affect traffic, and wait for rescue.

The water temperature of the car is high, there is no shortage of water, if the water temperature is particularly high, you can't continue to drive, because it will cause driving or cause engine failure.

The car has to stop when there are two problems. One is the high temperature, and the other is the oil lamp is on. These two problems can easily lead to engine damage! Be sure to troubleshoot before driving.

It's a good idea to check what is causing the water temperature to be too high, and wait for the water temperature to cool down before continuing to drive.

Answer: The lack of water in the car makes the water temperature high, and you can make the engine to continue driving"Tile hugging crankshaft"Serious consequences!

Hello, the car water temperature is too high to continue driving, the car water temperature is too high to cause the engine water temperature to rise is generally not just one factor, but a number of factors, and different factors caused by the car water temperature is high, in the degree of high temperature because of its speed and other aspects will be different.

It is possible that the cylinder head gasket is not well sealed.

1. Insufficient coolant.

A coolant leak can cause its temperature to rise. At this time, you should check whether the coolant is leaking! If there is, then the leaking pipes should be repaired quickly, etc.

If not, add the same brand of coolant in time! It is not advisable to add water, especially in winter, as it will have a diluting effect on the coolant, even if it does not cause a breakdown.

2. There is a problem with the cooling fan.

The heat fan will cause the heat generated to not be transferred to the antifreeze in time when the vehicle is running at high speed, which will affect the heat dissipation, and then cause the temperature of the antifreeze to rise, resulting in problems such as boiling the pot! In this case, if you are driving, reduce your speed first. Check if it's a fan problem, if so, repair it in time, don't wait for the pot to boil before repairing.

3. Circulating water pump failure.

Once the water pump fails, the water circulation on the thermal side of the engine cannot be carried out normally. As a result, the engine cooling system fails, and the phenomenon of "boiling the pot" will arise! Be sure to detect it early and solve it early.

Generally, if there is a problem with the water pump, it may be that the bearing is locked or the shimpeller is damaged! It is unlikely that the axle trouser lift will imitate the lock-up. If the Hu fiber shutter wheel is broken, just replace it.

The reason for the low water temperature of the car is usually that the thermostat is damaged or the cooling fan is constantly running. When the water temperature of the car is low, it is necessary to check the coolant level and whether it has deteriorated; Check the oil level of the oil; Check the water radiator for foreign matter blockage; Check whether the fan blades are deformed; Check whether the water temperature sensor and circuit are normal; Dismantle and inspect the thermostat.

The thermostat is a part that automatically acts as a valve according to the water temperature of the engine, and is generally installed at the outlet of the radiator and the inlet of the water pump. When the coolant temperature is low, the thermostat blocks the low-temperature cooling water from the radiator so that it cannot enter the engine water jacket, and the water temperature in the water jacket can rise quickly, which is a small circulation.

If the water temperature rises to a certain temperature, the valve gradually opens, and the coolant in the radiator begins to circulate again, so that the coolant flows through the radiator, begins to slowly increase the water temperature, and dissipates heat to the atmosphere through the radiator, keeping the engine water temperature at the appropriate temperature, which is the big cycle.

If the thermostat fails, the valve does not close, and the coolant is always circulating high, the water temperature of the engine may be too low. Or some cars simply remove the thermostat in order to lower the temperature when the water temperature is high in summer, so that the water temperature of the engine will also be very low.

The cooling fan rotates frequently. For electronic fans, circuit failures cause the electronic fans to rotate constantly; For silicone oil fans, damage to the silicone oil clutch will also cause the fan to rotate constantly, and these faults will cause the water temperature to be low.

1. Check the coolant level to see if the coolant is significantly less, if it is less, add an appropriate amount.

2. Check whether the coolant has deteriorated, if it has deteriorated, replace the antifreeze after cleaning the waterway.

3. Check the oil level, if the oil is too little, it needs to be added or replaced.

4. Check whether the water radiator is blocked by foreign objects and whether the air duct of the radiator is blocked.

5. Check whether the fan blades are deformed, or replace the fan or adjust the belt.

6. Check whether the water temperature sensor and circuit are short-circuited or open-circuited.

7. Disassemble and inspect the thermostat, put it in hot water to observe the opening of the thermostat, if it cannot be opened normally, replace the thermostat.

Hello, find the nearest safe parking place, stop to check the reason (is the lack of water in the water tank, or other reasons), check must ensure that the vehicle is turned off, and the front of the car is not hot, so as not to steam fumigation, if the water temperature is high for unknown reasons, drive to the nearest maintenance point after sufficient cooling, if you can't drive to the point of maintenance.

1. The water temperature of the car is too high, it is not recommended to continue driving, if the water temperature is high, it is easy to cause deformation and damage to the cylinder block and cylinder head, and it is necessary to replace the new cylinder block and cylinder head when it is serious.

Second, the reason for the high water temperature of the car:

There are many reasons why the water temperature of the car is too high, most of which are caused by water seepage from the water pipe and insufficient cooling water. Common ones are: broken fan belt, leaking water tank or water pipe, thermostat failure, oil leakage, etc.

If the engine power disappears during driving, it is due to violent knocking, cylinder knocking and other sounds, mostly because the engine is overheating. The specific reasons are as follows:

1. The cooling fan is not **The cooling fan may be controlled by the temperature control switch, or it may be controlled by the water temperature sensor.

2. Insufficient cooling medium

1) Antifreeze: High-end cars are required to be filled with antifreeze all year round;

2) It can be used as a substitute for temporary water or distilled water;

3) Leaking water tank cover.

3. Thermostat damage:

1) If you want to remove the thermostat, you should plug the small circulation at this time, so as to ensure that all the coolant is dissipated by the water tank;

2) When installing a new thermostat, attention should be paid to the water holes;

4. Water tank blockage:

1) External blockage: water or gas should be used to remove the dirt;

2) The internal blockage will affect the circulation of the coolant and at the same time generate pressure, at this time there will be two results, one is the water tank leakage, and the other is that the water temperature is particularly high at high speed.

5. Pump failure:

1) The impeller slips or gets stuck, resulting in the timing belt breaking;

2) Impeller deformation.

6. Cylinder corrosion:

1) The combustion chamber and the waterway are flushed, and the white smoke will be drained from the drainage pipe, resulting in frequent water shortage in the water tank;

2) Water channel and oil channel flush (oil is white with water);

3) The waterway and the waterway are rushed, resulting in poor heat dissipation of the cylinder block, especially at high speed; Blocked waterways.

7. The ignition timing is incorrect (corrected with the timing lamp) and the oil pressure is too high.

Clogged water pipes, damaged water pumps, damaged water tanks, fans not turning, etc. First, check for water leaks. If there is no water leakage, it may be that the thermostat cannot be opened at 90 degrees, resulting in a large amount of water circulation and high temperature failure.

This can also be due to poor pump operation. First, remove the thermostat to see if there is still a high temperature. If not, replace the water pump, it cannot be ruled out that the high temperature is caused by water blockage.

Need to inspect and repair If there is no lack of water in the main water tank [i.e., the cooling system and engine are not found and there is a pure water leak], first check the following aspects:1. Check whether the cooling system piping is unobstructed, and clean the inside and outside of the water tank to make it unobstructed.

2.Check whether the water in the cooling system can be circulated when the engine is working at room temperature; Check whether the pump is running normally, whether the pump belt is loose, and whether the pump blades are damaged or falling off. Check the thermostat for damage.

3.Check that the cooling system dissipates heat well. Whether the cooling fan is working normally, whether the electronic fan circuit is normal, whether the temperature control switch and its circuit are cracked normally, whether the fan coupling is faulty, and whether the fan cover is damaged.

Is the fan too far away from the tank? 4.Check whether the engine is flushing the cylinder.

If the cylinder is flushed, check that the contact surface between the cylinder block and cylinder head is flat, grind the contact surface, and replace the cylinder gasket. Inspect the cylinder block and head for cracks or damage. 5.

Check whether the engine's valve timing is correct, whether the valve clearance is appropriate, and whether there are faults in the engine, gearbox, differential, chassis suspension, braking system, etc. 6.Try not to let your vehicle drive at low speeds for long periods of time, especially when driving uphill.

Can you keep driving if the water temperature is too high? The water temperature of the car is too high to continue driving. The increase in engine water temperature caused by excessive water temperature of the car is generally not only caused by one factor, but by multiple factors, and the high water temperature of the car caused by different factors will be different in terms of high temperature degree and speed.

There are several common causes: Insufficient coolant: A leaking coolant or insufficient coolant can cause the engine water temperature to rise.

At this point, check the coolant condition. If it is insufficient, add it to a suitable place first, and then check whether the liquid level has dropped seriously after a few days. If there is, locate the leak.

Cooling fan failure: When the car is driving at high speed, the heat generated cannot be transferred to the antifreeze in time, which affects the heat dissipation, which in turn leads to the increase of the temperature of the antifreeze and the boiler boiling. Thermostat malfunction:

The thermostat is used to automatically adjust the amount of water entering the radiator according to the temperature of the cooling water, change the circulation range of the water, so as to adjust the heat dissipation capacity of the cooling system and ensure that the engine works within the appropriate temperature range. If the thermostat fails, the car's cooling system may not be able to circulate, causing the water temperature to rise. Circulating water pump failure:

There are several kinds of pump failures, bearing locking, impeller damage, etc. Bearing locking is rare, and impeller damage often involves impeller cracking or impeller coming loose from the pump shaft, resulting in slow coolant circulation and engine overheating. @2019