My computer is always dead, and it is dead 4 or 5 times today.

First of all, get the memory strip down, use the eraser to put the lower part of the sassafras, press it, check whether the other parts are loose, put some lubricating oil on the CPU cooling fan, and turn on the machine after these are done, to see if it is still dead.

If it's still dead, it's poisoned, and it should be a variant of the rose virus, which crazily occupies your memory and causes a crash. It is recommended that you upgrade the virus database of your antivirus software and scan it all over the board.

The easiest way to restore the BIOS is to remove the silver-zinc battery, wait a few minutes and press the power to start it up.

Absolute virus phenomenon, do system or antivirus. It is recommended to do the system.

Supplement; The hard disk is not abnormal to see if there is any abnormal noise, and it may also be a problem with the hard disk.

The interface of the memory or hard disk is loose, take it out and get it, clean up the dust by the way, and then store it back as it is. If you're lazy, just take a few clicks on the connector and tighten it up.

Factory reset the BIOS.

The temperature is too high, or the temperature of the CPU alarm you set in the CMOS is set to be low, you can change it, just boot it into the CMOS.

2.If there is a problem with your graphics card, reinstall the graphics card driver, if it doesn't work, unplug the graphics card and erase the gold finger with an eraser.

3.If you try it in a different memory, there may also be a compatibility issue.

Remove the motherboard's battery, and then put the BIOS power according to the motherboard's instructions to restore the default state.

Your symptoms are obviously caused by the CPU temperature is too high, or the CPU warning temperature setting is too low, restart immediately after the crash and enter the BIOS to see if the CPU temperature is too high, generally no more than 65 is normal. If it is more recommended to change the silicone, just clean the fan.

See if the graphics card is loose.

1. Poor heat dissipation: If the display, power supply and CPU work for too long, it will cause a crash, dust and oil the fan.

2. Dust killer, poor contact: too much dust in the machine, poor contact will cause crash failure. Clean the chassis regularly and plug all connections in tightly.

3. Memory module failure: mainly due to loose memory module, the quality of the memory chip itself, the memory module contact fault should be eliminated according to the specific situation, if there is a problem with the quality of the memory module, the memory needs to be replaced to solve the problem.

4. CPU overclocking: Overclocking increases the working frequency of the CPU, and at the same time, it may also make its performance unstable. Go into the BIOS and turn the CPU back to the normal frequency.

5. Hard disk failure: If the remaining space of the hard disk is too little and there are too many fragments, the machine is easy to crash when it is running. It is necessary to develop a good habit of regularly organizing your hard drive and removing junk files from your hard drive.

If the hard disk is aging or due to improper use of bad sectors and bad sectors, it is necessary to use the tool software to troubleshoot, and if the damage is serious, the hard disk can only be replaced.

6. Incompatible software and hardware: 3D software and some special software may not be able to start or even install normally on some microcomputers, find and delete incompatible software and hardware.

7. Driver installation error: When some hardware such as the driver of the graphics card is installed incorrectly, it will suddenly crash with a blue screen or black screen when the system enters the desktop, check and delete the problematic driver.

8. Defects in application software.

9. There are too many programs to start.

10. Illegal operation: Illegally open or release relevant programs with illegal formats or parameters.

11. Deleted system files by mistake.

1。Restart the computer, after the computer brand is out, press F8, Safe Mode, the last correct configuration, Enter, Enter!

2。Software conflicts, incompatibilities: redundant similar software installations! The computer is overclocked or there is too much software installed, and the system memory is insufficient!

360 Butler, Software Uninstall, Find Uninstall, Again: Powerful Cleaning!

Or: Start Menu, Programs, Find Excess Software Uninstalled!

3。The computer system is interfered with by stubborn viruses and Trojans or worms, or you have lost your system files!

360 system first aid kit, start first aid, after finishing, restart the computer!

After booting up, [File Recovery Area], click on: suspicious startup items and Trojans, delete files completely!

Again: [System Repair], select all, fix it now! [Network Repair] to start the repair. Restart your computer!

Antivirus, Full Scan, Quarantine, Trojan and Suspicious Viruses, Point: Completely Removed!

5。Do it when necessary: restore the system or reinstall the system with one click!

6。Hardware problems, hard disk or motherboard or fan problems, send it for repair!

90 degree crash is a self-protection program for the CPU for too high temperature, the CPU temperature is too high to affect the service life of the CPU, but also affects the usual Internet speed, so it is recommended that you change to a fan with better heat dissipation.

I don't know what kind of fan you use, why is it so cheap, it is recommended that you buy a better one, the kind with refrigeration is better, summer is coming, pay special attention to the temperature of the CPU, your computer crash should be related to the cup, it is recommended that you clean up the fan of the case, remove the dust, unplug the memory module and wipe off the gold finger, it should be fine.

Hope it helps you, thank you.

Can you pay attention to see if the temperature of the CPU is normal, or is it not normal for the computer in summer? If so, it should be a heat dissipation problem.

The best thing to do is to turn on the air conditioner to cool down.

1. Generally speaking, the biggest possibility in this situation is that there is a problem with the quality of the memory module or the contact is not good, open the case, take out the memory module and clean it with an eraser. If it doesn't work, test it with another memory, and then check whether the inner slot is not in good contact with the copper sheet or loose.

2. Take a look at whether the CPU fan is not rotating or the speed is slow, add some lubricating oil to the fan, because the fan loves to have problems in winter, and once the CPU workload increases, it will automatically protect the crash.

There may be something wrong with the hardware!

Speaking of my own experience, my computer used to be similar to yours. It turned out to be a voltage problem. Just buy a voltage regulator and install it.

You can test the voltage first or borrow a voltage regulator to connect it and try it later. Another point may be that the memory is aging, and if there is more memory, change it and try again, and try it without borrowing it from a friend. Find the right problem before you move the money.

Inspect the connectors on the motherboard, remove the memory, graphics card, sound card, etc., and use the eraser used by the students to wipe the metal contact surface. Try. If not, change the power supply and see.

If there is a problem with your motherboard, open the case to see if there is any explosion.

There are too many reasons why a computer freezes, for the average user.

The least technical is the replacement method, the order is generally hard first and then soft1 to see if the CPU is overheating (the most basic, similar to taking body temperature) 2, clean the memory Replace the memory (this is the easiest replacement step,) 3If you have an external graphics card, try to change it (whether the fan of the graphics card is stopped4, change the ghost image (the ghost image may not be fully driven)5 change a power supply (the power supply is bad, the voltage is unstable)6 change a hard disk (the frequency of accidental errors in the hard disk is too high)7 change a motherboard (it has reached a very serious point, such as the aging of the regulator capacitor on the motherboard) This chance is not very low, I have encountered it several times on brand machines).

Here are some small probability events that I've come across a few times.

1 If you have 2 RAM, try to switch the installation slot (generally the first one is used as the frequency standard for computers).

2.Try a different computer name (ridiculous isn't it, I've come across a dell!).)

It's not about playing 3D games.

If you crash frequently, you need to consider the problem of hard drive.

Be sure to be right, the wrong BIOS settings will freeze you while running Windows.

2 Always check the contact status of computer accessories. Running in the case of poor board contact will cause the system to crash, so when replacing computer accessories, be sure to make the board fully contact with the motherboard.

3 Clean the chassis regularly. Too much dust will cause poor contact between the boards and cards, causing the system to crash during operation, so the chassis should be cleaned at all times and not let too much dust accumulate in the chassis.

4. Insist on carefully checking and killing viruses. Do not use CD-ROMs or floppy disks from unknown sources, and check attachments in emails with anti-virus software before opening them.

5 Shut down in the correct order of operation. Do not turn off the power before the application software finishes running normally, otherwise it will cause system file damage or loss, and cause a crash during startup or operation.

6 Avoid multitasking at the same time. Do not run other software during defragmentation or checking your hard drive with anti-virus software, as this will cause a crash.

7 Don't be overly innovative. The drivers of various hardware do not have to be updated at any time, because the drivers that have just been developed often have bugs in them, which will cause damage to the system and cause the system to crash, and the latest is not necessarily the best.

8 When uninstalling the software, use the built-in anti-installer or the installation and uninstallation method in Windows, do not delete the program folder directly, because some files may be shared by other programs, once these shared files are deleted, the application software will be unusable and crash.

9 When setting up a hardware device, it is best to check for Interrupt Reservation (IRQ) and do not let other devices use the interrupt number, so as not to cause interrupt conflicts and cause system crashes.

10 When surfing the Internet, do not open too many browser windows, otherwise it will cause insufficient system resources and cause the system to crash.

11 If your machine memory is not very large, do not run a program that takes up a lot of memory, such as Photoshop, otherwise it will easily crash when running.

12 For system files or important files, it is best to use hidden attributes so that these files are not deleted due to wrong operation and cause system panic.

13 When modifying the master boot record of the hard disk, it is best to save the original record first to prevent the original boot record from being unable to be restored due to the failure of the modification.

14 CPU, graphics card and other accessories generally do not overclock, if you really need to overclock, pay attention to the temperature of the board after overclocking, CPU, graphics card, etc. work at abnormal frequency and temperature for a long time, it will automatically restart or crash, and burn the CPU, graphics card, and motherboard.

In addition, the virtual machine group is on the product**, which is super cheap.

Is it that the fan of the graphics card is broken, and the heat dissipation is not good. Or it's a problem with the power supply, I don't know if you have changed the power supply.

What about CPU temperature? AMD chip CPU temperature to be controlled.

If you don't use a discrete graphics card, it won't freeze. That's the problem with the graphics card, try it for a different time.