pcsx2 2 200 set Final Fantasy X

3 In the global configuration, turn on acceleration Pay special attention to disable the "Acceleration Interrupt Control Register".

Some image settings require PS2 native resolution, and the renderer needs to be adjusted to at least direct3d9 hardware (direct3d10 if you can).The speed correction needs to be adjusted to the right to the middle of the vu loop steal.

In addition, other unfamiliar ones should not be randomly ticked, which may slow down the speed.

Final Fantasy X has high requirements for graphics cards, and I am afraid that it will not meet the requirements of the landlord in terms of speed.

config image display turn down the resolution interlacing off in the config cpu speed column select skip frames, and then set it in the details column, generally custom run 70 frames, less than 50 takes effect, skip 2 to 3 frames, and the number of consecutive frames before skipping frames is 1No matter what you do, it's going to get a little stuck, especially in big scenes. The configuration is not too high.

I play Final Fantasy Ten with all the same, I think you should have two versions when you install it, in fact, the performance is about the same, I haven't used it. So I can only tell you so much, and others may have answers.

This is not a problem with the configuration of the computer, but the emulator is not so high, and the technical content is not so high, such as the special PCSX of the Lianza Oak Department, which will not be stuck at all, in addition, Devil May Cry, you use the model banquet to train the side, it is better to go directly to the PC version, with your configuration, it will definitely not be stuck.

For Final Fantasy X2, the EZ forum is more professional, and there is also a dedicated emulator in it.

If you turn off the limit steal for the latest PCSX2, you can turn up the image in D3D or the exact ratio but the speed will be reduced, so take your own choice.

It's better not to play PS2, and even if the play configuration is good, there is a D card. You also have to set it up yourself.

There's a problem upstairs... Does Wii have a martial arts club 3? Landlord、I suggest you change the simulator。 Don't use this.

This is an emulator for PS2 You need a PS2 game disc or disc mirror to fail if you have a disk, you can set up a disc drive At present, the PS2 emulator is not very mature Not a game that takes all The computer configuration requires high sock tremor The simulation effect is still not ideal.

It's an emulator.,It should be opened directly after installation.,And then the file opens the iso file of the PS2 game.。

As far as I know, the emulator is not as supportive of FF10-2 as FF10, but the LZ configuration is OK, it should be okay, you can refer to the following post Talent's evaluation and teach you how to set it up.

There are also ff10, ff12, and vp2 settings.

Just unzip any of them.

You can't play FFX-2 enough.

My machine is better than yours, barely 40 Zhen Full Zhen 60 should know.