What is the maximum size of the hard disk that can be installed in Xuanlong A40.

Add a mechanical hard disk, thickness interface selection: 7mm.

The steps to install an HDD are as follows:

1) After the hard disk is installed on the host, turn on the computer and select Enter My Computer - Management;

(2) Select Disk Management on the left, if the newly installed hard disk is detected, a dialog box will pop up to initialize the hard disk, click MBR and then OK;

(3) This is disk 0, right-click this disk and select New Simple Volume;

(4) The wizard dialog box pops up, click Next;

(5) Choose the size of the partition, the upper limit is more than 900g, generally 400g is enough;

(6) Name this new hard disk, if there is only one C disk at the beginning, then the system is D disk by default, and go directly to the next step;

(7) The following is the formatted partition, which must be formatted to be used, if it is a large capacity, only NTFS can be. Use Quick Format. Click: "Next", the first partition is completed;

(8) Repeat the above steps to continue adding new volumes, after completion, as shown below;

(9) Turn on my computer again and you can see that the new hard disk has been installed.

SATA, which is connected to the original hard disk bit;

or msata, connected to the reserved bit;

or SATA, connected to the optical drive bit.

There is no optical drive position, and there is a hard disk compartment.

Hello landlord.

At this price, Xuanlong T1 is not bad in terms of cost performance, online games are basically all-inclusive, and there is no big problem with special effects in a single machine. The average can be played.

However, the biggest shortcoming of this computer is the hard disk, if you buy the one with a 500g mechanical hard disk, it is highly recommended to install an SSD to improve the smoothness of operation.

Hope it helps you and good luck.

Try to choose a large SSD, the smaller the performance, the worse the performance, so it is recommended to choose a 128g one.

It's very general, this Intel high-speed CPU is just laughing and peeing, 1T hard disk didn't say the number of revolutions, 7200 rpm, it's okay, and then the memory didn't say anything, there was no way to evaluate it

In the BIOS, set the SSD as the primary drive or the primary drive!

Swap directly with hard drives. Other methods will affect the operation of the computer. If it's a desktop, there's still a way, so don't think about it so much.

Reinstall the system,Install the system in the SSD,Or restore the system backup in the mechanical disk to the SSD,But it's not recommended to do this,It will be a blue screen or something,The fundamental solution is to reinstall the system,I hope it can help you。

Personally, I don't think it's needed for SSDs, but if it's 5400 rpm, not 7200 rpm, I mean, my personal opinion can be ignored.