I m engaged in graphic design.,Is the installation configuration recommended by a friend okay?

The configuration is basically OK, dual-core CPU is a must, the new Photoshop CS2 supports dual-core, and there will be more software and game support in the future. That is, the PD805 front-end bus is only 533MHz and cannot play the performance of dual-channel DDR2 533, adding 300 yuan to replace the PD820 800 front-end total CPU performance will be greatly improved.

PD is not much different from P4 Choose carefully! Don't think that dual-core is fast, I've tried, it's no different

The plane setting is enough, don't worry, 3D is average There is also an emphasis on it: dual-core is faster than single-core! I've also used it, and I've tested it with 3dmax

The hard drive is too small. I can't fit many renderings. The other configurations are not bad, more reasonable.

I'm computer blind! Let's get two points first! Ha ha.

Nowadays, many flat software does not support dual cores, which does not mean that it will not be supported in the future. The latter can be almost 2 times faster. Graphic design software is easily dual-core.

The "single-core performance" of the 630 is not much stronger than the 805, you can hardly see it.

Not bad. The main thing is to see.

Graphics card memory issues.

This configuration is considered a tall configuration for general flat designs, and there is no problem in terms of operation, but it is not enough to do 3D animation and the like.

If it is flat, it is not recommended to use a dual-core 805. The Pentium4 630 processor is recommended.

Because nowadays many flat software (such as PS, Illustrator, etc.) do not support dual cores.

This means that two cores cannot run at the same time. In this case, the performance will not be very good.

So let's go with a single core. Everything else is fine.

If you don't consider upgrading in a short time, the memory will use two 512M, which is also 1G, but the dual channel is turned on, and the performance has been improved.

1. Graphic design, the computer configuration requirements are not very high, the cheaper ones use i3, the more expensive ones use i5, as for the i7 and e3 high-end processing of four cores and eight threads, it is a bit of excess performance (of course, as long as the budget is enough, it can also be considered).

2. Memory is generally equipped with 4G as standard, and can be added to 8G if there are special needs.

3. Graphic design does not have high requirements for graphics cards, GT640, R7 250 versions of low-end graphics cards are enough to do the job, GTX750 2G graphics cards can basically be used for all plane drawing work.

4. The screen material of the display is recommended to use IPS hard screen or MVA panel, the picture is more gorgeous, the color distortion is less, and the viewing angle is wider. And the screen must be as large as possible, so that you can see more comprehensively when drawing, no need to repeatedly zoom out and zoom up and down left and right mobile design drawings, the large size of the display screen can bring a stronger visual impact, and the use experience is absolutely great! If your budget is not very tight, try to use IPS or MVA for the screen, ** not much expensive, but its picture effect is more gorgeous.

The display of the TN panel is not very suitable for graphic design, and some displays have strong color distortion.

5. Mechanical hard disk or solid state drive for design purposes, there is not much difference, SSD solid state drive is less time to load software, after loading software, it all depends on the processor + graphics card, the modeling and rendering of the graphics card and the processor rely on the data processing ability of the graphics card and the processor, and the hard disk is directly on the side. If you have a big budget, then buy an SSD to speed up the loading of the software, but it will not help the mapping software itself.

For ordinary graphic design, to cope with common two-dimensional drawing, the CPU can try to choose Intel Core i5 seventh-generation processor with level or above, and the capacity of memory must be at least 8G or more, otherwise when the file is slightly larger, there may be an embarrassment that the image cannot be exported, and the type is currently DDR4 as the mainstream. Be sure to bring a discrete graphics card, the video memory capacity is at least 2G or more, and the video memory bit width is more than 128bit. For disks, solid-state drives (SSDs) offer faster read and write performance than traditional HDDs.

The collaborative process of computers in the process of graphic design and drawing, and several key points to consider when buying a computer.

The configuration is divided into notebooks and desktops, and the performance of 10,000 notebooks is not as good as that of 7000 desktops, which needs to be noted.

Desktop: CPU: i5 4th generation If the economy allows, you can use the i7 4th generation.

Memory: 8GB The minimum should not be less than 4GB, otherwise you will cry if the software is turned on too much.

Hard disk: 500GB 1TB can be, now mobile storage is very convenient, hard disk storage is enough, 1TB is recommended, **The gap is not big, the solid state drive is not much necessary, now the cost performance is relatively low, it is generally used as a system disk, or mechanical cost-effective.

Graphics card: If you are a professional in graphics and web pages, the Intel 4th generation CPU comes with a core graphics card, which can save money on graphics cards.

If you are doing something related to 3D models, you need a core graphics card, N-card GTX750 and above or A-card HD7750 and above are sufficient.

Notebook:CPU:Do plane-related design,Or film and television editing learning with i5 4 or more ultrabooks with U can be,This is for compatibility and convenience considerations,After all, heavy notebooks are very tiring to bring。

If you want to use a notebook to do rendering, the configuration must be high, nearly 10,000 yuan, depending on the economic conditions, it is more cost-effective to do these jobs in the future or desktops, pure notebooks to do three-dimensional rendering? Buy an apple, but I don't recommend it.

You don't think about portability, you have to be ordinary, you don't have U, i5 with M 4 or 3 generations are enough, and if you have economic conditions, you can i7.

RAM: 8GB is sufficient, not too low and not enough.

Hard disk: The general standard configuration is 500GB mechanical hard disk, and there are also dual hard disks, the lowest is 500GB, and the performance of notebook hard disks is worse than that of desktop computers.

Graphics card: If you want better results, it's best to have a discrete graphics card, but generally speaking, it can only meet the basic modeling needs, and it's no problem to do flat classes, and the three-dimensional rendering is still the same sentence, and the laptop is not cost-effective.

Comprehensive suggestion: In the future, you still need to be equipped with a desktop computer, the notebook is suitable for portable display for customers, there is no problem to do basic graphic design, if you learn to render, you still count on the desktop to do it, time is money, this is also the advice given to me by the old designers!

It is recommended that you search the CPU and GPU (graphics card) ladder diagram on the Internet before buying a computer, and check the location of the configuration you want to buy, because a large number of models come out every year, and the ladder diagram changes every year, so you should buy a computer according to the actual situation.

What kind of computer to configure depends mainly on your own preferences. Computers are all pretty much the same.

Notebook computer (abbreviation: notebook, nb), also known as notebook, laptop or laptop computer in Chinese

A laptop computer is a small, portable personal computer that typically weighs 1-3 kg. The trend is to be smaller and lighter, but more powerful. Like Netbook, also commonly known as netbook, the main difference from PC is that it is easy to carry, referred to as "PC".

Compared with desktops, laptops have a similar structure (monitor, keyboard and mouse, CPU, memory and hard disk), but the advantages of laptops are still very obvious, and their main advantages are small size, light weight, and easy to carry. Generally speaking, portability is the biggest advantage of notebooks over desktop computers, the weight of general laptops is only about 2 kg, whether you go out for work or travel, you can carry it with you, which is very convenient.

Do you want a tabletop? Or is it a notebook? If you put it in a company, it is easier to use it on a desktop, and it is more powerful than a laptop.

If you want a notebook, you need i5, graphics card 740, etc., mainly depending on the graphics card. I'm a graphic designer, and I just went to buy a notebook for a day the day before yesterday, and you went to the computer city and told others that you were doing design, so I wouldn't recommend it to you.

i5 or above, 4G RAM or above, discrete graphics card.

I also do design, mainly interior design, but also some personal and corporate graphic design. Compared to interior design, graphic design computers don't need too high configurations, as long as the graphics card is a little better. Desktop,It is recommended to assemble,This configuration can be selected,If it's a notebook,I recommend Lenovo,Lenovo bought three years agoY460,There has not been a failure until now,The quality is still good。

You can go to the physical store and tell the staff that the main purpose of your computer is to ask the staff to recommend it for you.

Computers for graphic design should be professionally workstation in mainstream configurations.

Generally, the CPU is used by Xeon, the graphics card is used by nvidia, the graphics card chip: Quadro FX series The hard disk should be arrayed The key is the screen, and the IPS of the VA material is not good **Between 1-30,000.

Personally, if the budget is small, generally refer to the whole machine more than 5000.

The display is around 2000 with CRT.

CPU with i5 or higher.

The motherboard uses 4 memory slots (ASUS GIGABYTE) and a graphics card of 800 or more, or a graphics card of about 1200 for the Shadow.

8--16G for memory

The chassis should be large, and it is best to use a tower server.

The power supply should be in the middle and high-end of Huntkey or Great Wall.

The whole machine is about 7,000 --- 15,000 depending on the ability of each person.