20 minutes to find how to backup ADSL firmware with FTP command 70

Model: MT800 Software version: V100R006C01B010SP01

The version I'm using.

a) Back up the original firmware:

Go to the DOS prompt and go below C:.

c:\\ftp

Then enter the username and password (admin admin).

Then use the get command, and later, a file will be generated under C:, which is a backup of the firmware.

b) Upgrade firmware:

Rename the upgrade file to C: and copy it to C:.

Go to the DOS prompt and go below C:.

c:\\ftp

Then enter the username and password (admin admin).

Then use put to upload the new version of firmware. Be sure to pray that there will be no power outages... This process takes longer than the backup time)

When it's done, the modem will restart.

There is a reset button behind the modem, press it three times in a row, and then the indicator light of the modem will be fully on, and then it will be reset.

Disable the local NIC and enable it again, and refresh the network configuration.

Okay, that's the time.

Configure your routes!

I went to the ** area and downloaded all the firmware for the AAM6000EV. Use the method you called to dismantle the cat with 6 needles and threads to brush FW, brush into other FW, or can't use the imageupgradev214c and configuration management monitoring and control firmware upgrade program version of these 2 software, or the same. It seems that I can only use the method of 6-pin data cable to brush fw,55555555 View the original post" Radical Town.

Are you sure you can open it, I can't open it either.

Me too, I can't even decompress.

Situation 1: If you are on the internal network, you need to perform port mapping on the router, otherwise the external network will not be able to access your FTP server.

Situation 2: If you are a dynamic IP address (such as ADSL), in the FTP server software settings, the IP address should be set to "all IP addresses", and temporarily fill in your current public IP address;

Added: Port mapping, which can be turned on in turn in the management interface of the router"Rules"--Virtual servers"Set the IP address to your current LAN IP address and the port number of the FTP server (21 by default).

If the file is not very large, you can use the QQ file transfer function to transfer the file to others.

Chinese is very leather pants and easy to use! It should be a problem with the settings, I use it to set up a web server, ftp server, no problem, do port mapping, turn on dmz, you can solve the problem of disconnection. View the original post

Look at the manual of modem, enter the setting of Soju modem, and turn on the remote setting.

But if you want to connect remotely, you must know the IP address at that time.