The hard rod network speed is slow, my home should be 600K network speed, why is it only more than 2

Lowercase kb and uppercase kb are not the same,,8kb==1kb。。 You can take a look at it and convert it again

Because the gigabit connection speed is 1Gbps, some routers are nominal gigabit routers, but the LAN port is actually 100 gigabits, so you should pay attention to it when buying a router!

The 100 Gigabit router is equipped with a 100 Gigabit network port, which does not support more than 100M broadband, and even if it is accessed, it can only be limited to 100 Gigabit, which is the most, so it can be solved by replacing the Gigabit router, and it is necessary to identify the full Gigabit, that is, the Gigabit WAN port and the Gigabit LAN port, and the wireless rate should also be more than Gigabit.

First of all, the customer should find out the environmental reasons, routers, switches, network cables, etc. are not gigabit, see if the device connection router is 100M, if you connect to the switch to see if the LAN port of the switch is Gigabit, the speed is only 3M, the mobile device is connected to 5Gwifi as much as possible in the LAN, and the speed can not be reached You can see the rate of the mobile phone connecting to the wifi.

The network cable limits the internet speed.

The Category 5 cable is only connected to the crystal head with four cores, that is, the previous network cable that only connects the four cores of 1236, and can only support a maximum transmission speed of 100Mbps. If your home network cable is like this, you can only reach 10mb s. If you want to run to a network speed greater than 10MB s, you need at least five types of lines and eight cores to connect, and the quality of five types of lines is better.

Hello, the slow speed may be related to the local cautious carrier, the connected server Xiangzhi and the network situation, it is recommended that you check the network situation or try again at another time**.

The first point is the speed of the network bandwidth, the second point is the speed of the other server, and the third point depends on the network medium.

If so, problems with the network media can lead to an unstable situation.

If the other party's service bridge is limited, and you only allow 40k or 80k, then, no matter how superior your first two conditions are, you can't speed up.

That's the problem.

There are many scenarios of network slowness, and further testing is necessary to find out the fault point before targeted troubleshooting, and the specific steps are as follows:

1. First of all, the stand-alone device is connected to the telecom optical modem and other equipment to ping the gateway or DNS server address of the telecom, and a numerical value is obtained;

2. Connect the router again (unplug the other network cables) and then ping;

3. Then connect to other computers and ping when it is in normal use;

Get 3 values, which is larger or has packet loss, it means that it is the problem of **, the first time is that the line of the telecommunications company is not good, the second time it means that there is a problem with the router, and the third time if it is abnormal, it means that there is a problem with the local area network.

If the three test values are normal according to the above test methods, it means that there is no problem with the local network and the operator's network, and the fault point is on the ** server. Generally, when the number of users is large, the processing capacity of the server is not enough or the egress bandwidth is insufficient, which can easily cause the stuck phenomenon, which cannot be solved, and can only be changed when the network traffic is small.

There's only one way to fix it! Complain to them until the internet speed is normal.

First of all, the total bandwidth after you install the router is still 400KB.

In this case, there are two reasons why you are slowing down.

1.There are other people who are also using the Internet to use their internet speed. The "other person" here may be the person who is using the router with you, or it may be someone you don't know is secretly using your wireless router to surf the Internet.

2.The router settings limit the internet speed. If that's the reason, log in to the router management page and set it up. Please refer to the manual for specific operation.

It's not a problem with the router, it may be that you have a program running in the background that occupies resources, you look at the task manager, or it may be that you are poisoned.

Why are you using routing!! Is it a speed limit, or someone else is using it.

The speed of Internet access is not unrelated to the software and hardware of the computer or mobile phone, but it has little to do with it. It's like you usually only hear people complain about the bad signal, but you don't change your phone or computer because of it.

The speed of Internet access is mainly related to the following factors:

One is the transmission medium; The second is the transmission rate. At present, the medium of the backbone network is optical fiber, which is the best medium at present, and most places have realized optical fiber to the home, so the medium of the backbone network is beyond question. The problem is that the quality of the indoor line is worth it**, although it has been fiber-to-the-home, but the network speed from the indoor to the terminal is 4m.

In addition, the transmission rate is related to the service provider, fortunately, China Mobile has entered the 4G era, and other service providers have also reached 3G and are actively moving towards 4G, and are improving their network speed, which is also good news for users. But China's internet speed ranks 98th in the world, why? I think most of the reasons are:

First, the line is aging, the quality is not high, the layout is unreasonable, and the key is that the "last mile" problem has not been solved; The second is that the maintenance service can not keep up, many service providers only know the charge, but less service quality improvement; Third, from an objective point of view, China has a large number of users, and there are relatively many problems of network congestion, especially at 8-12 a.m. and 3-6 p.m. during the peak hours of Internet access. It is recommended that you avoid rush hour surfing.

Good luck!

Maybe it's a signal problem.。。 Make a ** ask to move.

It should be said that there are more people who use it at noon, so the network speed is slow.

The more people there are, the slower the internet speed will be allocated to you, and the fewer people will be assigned to you, the faster it will be assigned to you.