Why is my acceleration so low when I m running?

Are you running a time trial, running a time trial has no post-bonus speed, and the first place in multiplayer games also has no post-bonus speed.

However, even if there is no additional speed in L1, the speed will definitely exceed 260, and if you think about the situation at that time, is there another factor affecting the speed.

260 is almost, L1 accelerates almost 260+, PT this car is designed to accelerate the maximum speed down, acceleration time up, so 260 is normal!

Happy gaming.

The reason for your low starting speed:

1 .Poor connection ・Spitfire after drifting After the Spitfire ends, it does not accelerate immediately after the Spitfire ends, resulting in a pause in the middle and thus slowing down.

2 .Shaking the head ·As we all know, the shaking head grip can be the fastest to mention the maximum speed pt straight grip speed 219 You pay attention to whether you usually open the straight road has been to 219 It should be very little because you don't pay attention to shaking your head

The master starts to shake his head when he starts, because they have good technology, drift and deceleration, and the speed is not lower than the maximum speed of the straight before applying nitrogen, so they can also reach the maximum speed when accelerating.

Solution: Pay attention to the grasp of the best drift Try to reduce the drift deceleration· Shift press a small point to pull back the head of the car quickly after drifting.

Let's give you a palliative but not a cure: pay attention to the timely shaking of the head After the drift is over, the deceleration is very strong and there is a grasp of the ground in front of you, then you will shake your head and shake your head at the beginning It is a reason to raise the speed to the maximum speed in the shortest time and then shake your head in the process of acceleration The speed will naturally go up

The above is only a personal opinion, where there is a mistake, the high watch laughs).

Happy gaming (*.)

Oh, your car doesn't fit

Clutch slip is mainly when the car accelerates while driving, the speed of the car can not increase with the increase of engine speed, and the power of the engine can not be completely transmitted to the driving wheels, resulting in driving weakness, especially when going uphill. The main reason for clutch slippage is the lack of friction on the clutch friction plates. When the clutch is not in place, either grab the gear or take it off.

Stepping on the semi-clutch state sports car for a long time, the clutch slides. If you can't hang up the gears or take off the gears, the car will be hit hard by the throttle when the gears or gears are not completely in place, and the clutch plate will be abnormally lost. Of course, the speed of the car at the gas throttle does not increase.

We also have to turn our eyes to the engine. The power source is the combustion of fuel, and the engine is the fuel that provides the fuel and converts chemical energy into mechanical energy.

Because the addition of low-grade gasoline will weaken the acceleration force, resulting in a decrease in engine power and an increase in fuel consumption. Then there's the engine oil system. The importance of engine oil is self-evident, it can fully lubricate, reduce resonance, and improve the smoothness of engine operation.

If the engine oil is low for a long time, Kyoko's power is insufficient, and fuel consumption will increase. The heavy piston slammed into the door, causing mechanical damage to the connectors in question. In addition, when the gasoline pump fails, the fuel filter can also reduce engine power.

Then the intake system of the engine, the engine needs air in addition to oil. When parts such as air filters and air savers become clogged or have problems, it can lead to insufficient air intake, slowing down the acceleration of the car, and creating frustration.

In addition, if smoke comes out of the exhaust pipe, producing black smoke, the problem can be determined based on the symptoms of the car, including problems with the combustion chamber, ignition system, and valves. If blue smoke comes out of the exhaust pipe, the oil may have gone to the combustion chamber. That is, it should be the combustion chamber we are talking about.

Many people think that car refueling can't be slowed down, but if you don't pay attention to small things, it will cause big things, so car owners don't think that after the symptoms appear, they should go to a professional repair shop or 4S shop for maintenance in time.

It is likely that the power of your car is not very sufficient, so the acceleration will be slower when running, which is determined by the performance of the car.

Because I have run such a long distance, my body is already very tired, and my physical condition has also decreased, so I can't accelerate.

Because there is no gas, when the car is almost out of gas, it will run slower.

Hello, I have seen your question and am sorting out the answer, please wait a while Oh It is most obvious when going uphill.

Hello, the problem of the oil circuit, clean the oil circuit, focus on checking the oil pump. Insufficient oil supply, that is, insufficient oil pressure. You can measure the oil pressure.

You still have to go to the repair shop to check this out.

The oil pump filter element has also been replaced.

Van. None of the fault codes were detected.

That is the quality of the oil, change it.

I also went to add 95 oil a few times, and I tried it again, and the clutch plate three-piece set was also changed.

This is troublesome, if you van 4s shop.

It's not a 4S shop, and I can't find a fault with 56 repair shops.

Then go to your van 4S shop to see, maybe there is a harvest, sometimes the fault of this car is not a big problem, and the average person is not good at repairing.

The slow acceleration of a vehicle is usually caused by too much carbon build-up in the engine.

It is necessary to remove carbon from the engine. Every 30,000 kilometers traveled, the engine needs to be cleaned of carbon deposits.

According to the existing technology, the combustion of gasoline cannot achieve complete combustion. Therefore, as long as the engine is running, carbon deposits will be generated, which is an unavoidable problem.

The main parts of carbon deposition are: combustion chamber, Luzheng intake valve and its surrounding area, three-way catalytic converter, lubrication system, etc.

If the carbon deposition is severe, there will be problems such as high fuel consumption, difficulty starting, weak acceleration, engine shake, and excessive exhaust gases. What's more, if carbon deposits fall into the combustion chamber, the cylinder may be pulled and the engine needs to be overhauled.

There are currently two ways to remove carbon:

1.The traditional method is to operate the engine. All parts of the engine will be removed for cleaning, which is harmful to the engine, time-consuming, labor-intensive and costly, and the cleaning effect is not very good.

2.Hydrogen oxygen carbon removal. It's a high-tech approach to carbon removal. Water is used as raw material, and it is decomposed into hydrogen and oxygen after being electrified. By taking advantage of the catalytic and combustion properties of hydrogen and oxygen, the carbon is removed from the inside of the engine, eliminating the need to disassemble the engine early and saving time and money.

As the heart of the car, it is recommended that you pay attention to the maintenance of the engine.

Millions of car purchase subsidies.

1.The slow acceleration of the vehicle is generally caused by too much hidden carbon deposition in the engine.

2.Engine carbon removal is very important, and every 30,000 kilometers of the car travels, the engine carbon deposition cleaning needs to be done once this year.

3.With current technology, gasoline combustion cannot achieve complete combustion. Therefore, as long as the engine is running, carbon deposits will be generated, and this problem cannot be avoided.

4.The main locations of carbon deposition are: combustion chamber, intake valve and its surrounding area, three-way catalytic converter, lubrication system, etc.

It is possible that your car does not have enough air intake or fuel supply. It should be a sensor problem, just read it with a decoder.

Acceleration is the ratio of the amount of velocity change to the time it takes for this change to occur δv δt, and is a physical quantity that describes how quickly an object's velocity changes.

The acceleration is getting smaller and smaller, which can only mean that the speed is getting faster and smaller, but the speed is still accelerating.

For example, at the beginning the velocity is 4m s acceleration is 3m s, after 1s the velocity becomes 7m and then the acceleration becomes 2m s, and after 1s the velocity becomes 9m s, the acceleration is smaller, but the speed is still getting bigger and bigger.