Samsung i900 flashed into an animated interface and did not move

Shuangqing, if you don't have Shuangqing, there is a certain possibility that you can't get stuck in the interface.

Double clear and then re-brush it will generally solve the problem.

It is because there is an error after the phone enters the system, which causes it to restart, and the vibration is a prompt that has just entered the system. Restart it repeatedly, and it will vibrate repeatedly.

There are many reasons why it won't turn on, please check them in turn:

1.Have you ever had a wipe before flashing? If you do not wipe, it will cause repeated reboots.

2.What ROM is flashed, if it is not the Samsung i9000 version, it will cause problems. CM, Lizhuo's ROM is very good.

If it can vibrate, you have been able to skip recovery and enter the system boot step. You can deduct the battery and then press the volume up + down + power on to enter recovery

If you haven't flashed the recovery (e.g. flashed the package with odin). Then you can only go into digging coal and rebrush it with odin.

Brush it again, if it doesn't work, dear, you're going to dig coal.

It may be that the system you are brushing is unstable or has a conflict with the hardware, causing a crash.

Hello !

According to your description of the problem after flashing your Samsung Galaxy S2 i9100, we recommend you to try it as follows:

When the phone is fully charged, remove the battery and put it back on, press and hold the [Power Button] and [Volume +] buttons for 10 seconds.

After entering recovery mode, move the cursor with [Volume+], Volume-] (see figure below).

Operate 2-wipes again

Select Wipe Data Factory Reset > yes, home] to confirm.

Select wipe cache partition > yes , home] to confirm.

Select reboot system now > yes , home] to confirm.

After doing this, the phone restarts, and you're done.

If the problem persists after 2-wipes, it is recommended that you flash the official ROM to repair the system.

Hope this helps you!!

Hello:1It is recommended that you press and hold the power button of your phone for 8-10 seconds to see if the machine can be turned on normally.

2.It is recommended to take out the battery, expansion card, and SIM card vertically, clean the battery contacts, then reinsert the battery into the phone, and tap the power button again to try to turn it on.

3.If this is the case with some third-party software installed, it is recommended to enter the safe mode and uninstall some third-party software.

1) Turn off the phone first, when the phone is displayed again, when the phone is displayed, quickly press and hold the menu button until the word "safe mode" is displayed at the bottom left of the phone, and then release your hand.

2) After entering the safe mode, go to the Task Manager option and uninstall some third-party software installed.

3) After uninstalling, reboot the device and observe if it is still stuck in the Samsung interface.

If the problem still exists through the above methods, please bring the purchase invoice, repair card and machine to Samsung service, and the engineer will check the machine

In coal digging mode, you and odin try to brush an official firmware into it, if there is no error, it is OK, if there is an error, it means that there is a problem with the font.

Hope it helps.