How to do sound absorption in a home PC recording studio?

You are now clapping your hands in the room, if there is an echo, it is sure to do sound absorption, otherwise you can't record, put some furniture is the way to improve, you can try it, wooden furniture, do not use furniture and bookcases with glass panels, put a few bookshelves will have a good effect, it is best to have carpets, curtains are thick, these are simple and practical methods, if you still can't improve the sound field, you can consider using a little professional sound absorption materials, Dr. Sound Acoustic Materials Factory, National Free Acoustic Heat Line: 4006-43-4006

If the pyramid sound-absorbing cotton is really attached to the wall, it can only absorb high-frequency sound above 2000hz, then the sound will be very dry after you finish it, and it will sound worse than not doing it, if you want to do a recording studio.

The first is to do a good job of sound insulation, what should be replaced with double-layer soundproof glass for windows, otherwise the neighbors complain that you are endless, and the second is the room reverberation time processing, about between, it is recommended that you use environmentally friendly sound-absorbing materials such as polyester sound-absorbing panels at home.

Thirdly, your room is so small, and the handling of low-frequency standing waves is also very important.

1. The best way is to seal the windows tightly, whether you are a single window or a double window, sealing is the most important.

2. The use of thick curtains to consume part of the energy of sound is also a relatively simple method, of course, it is not a very effective method.

3. Carpets, fabrics and even sound-absorbing (insulation) cotton can be used to reduce the impact on them.

4. Make a sandwich on the wall that is filled with absorbent (insulation) sound cotton in the gypsum board of wood square (light steel) and paper, and then use wallpaper and other decorative surfaces (of course, ordinary wall paint can also be used to treat the surface).

Many people have different opinions and preferences about building their own recording system at home, and many people are keen on expensive equipment. But if you're just starting out and you may not need "a lot of money" to set up your own home studio, learn from the experience of others.

It depends on what you're going to do, and there's no answer to this question, the simplest, for example, some people need a keyboard, some people don't, some people need a tambourine, some people don't...

Personally, it is not recommended to do external recording in the home environment, and the acoustic environment and volume are not up to it.

The next cubase+amplitube will record it, and it's the same if it's good.

It is recommended to go to Yinping** and ask the professionals there, they will give you a configuration plan according to your requirements.

You also need to make a synthesizer for MIDI, and install Adobe Audition CS6 software on your computer.

1. The recording studio is divided into a control room and a recording room, the control room is equipped with recording equipment, and the recording room is used for actors to sing and musical instruments to play. Between the two rooms there is a soundproof wall (preferably masonry) with sealed glass windows to facilitate communication. The glass window needs to be 3 layers, each layer is 6-8 mm, and the middle layer should be installed at an angle of 20 degrees to improve the sound insulation effect.

Special attention should be paid to the sealing of the joints when installing glass windows. 2. There should be a cable between the two rooms to transmit the microphone signal and the return signal, and the cable needs to be drilled through the wall, which should be as small as possible, and should be filled to avoid sound leakage. 3. The recording studio should be as quiet as possible (30db(a)), the door should be sealed with a sealing strip, the door should be specially customized to meet the requirements of no sound leakage, and the window should be sealed with masonry, or a removable partition should be added, and then a thick curtain should be added.

Fourth, in addition to sound insulation with the outside world, the decoration of the recording studio should also be sound absorption, so as to reduce the reverberation sound of the room, prevent the generation of standing waves, and the sound absorption volume and shape need to be designed and calculated. 5. Simple wall decoration can be treated with soft packaging, filled with sound-absorbing materials (sponge, etc.), and nailed cloth outside. If the requirements for sound insulation are high, consider adding another layer of sound insulation to the wall.

6. In addition, adding sponge soft packaging on walls and doors is also a simple and effective way to absorb sound. 7. The light in the recording studio should be as soft as possible to avoid eye fatigue. Generally speaking, the recording studio decoration should be in the case of investment permitting, comprehensive sound and appearance requirements, for most recording occasions, the above decoration can fully meet the needs, and the quality of the recording studio environment directly affects the attractiveness of customers and the play of actors.

Why should recording studios do sound-absorbing treatments, see what the professionals have to say.