Is it a problem with the compressor capacitance that the fan of the Gree air conditioner is turned o

The fan of the air conditioner outside the air conditioner is normally turned on for half an hour and then stops, it should be that the frequency of the compressor is reduced after the inverter air conditioner reaches the predetermined temperature, so I think the compressor has stopped working.

If it can be started, it is not a problem of starting capacitance, but more protection caused by poor ventilation and heat dissipation.

There are two possibilities for Gree air conditioner to stop for half an hour, 1: after the indoor temperature reaches the set temperature, the host will stop, and when the indoor temperature rises, the host will start working again. 2：

If it stops after half an hour of start-up, it may be overvoltage protection. Find a professional after-sales personnel to come to see.

It has a certain relationship with the compressor capacitor, you can replace a compressor capacitor to try, of course, it is not excluded that the internal mechanical card of the compressor has just caused a crash or shutdown, if the capacitor is still shut down after replacing the capacitor, check whether the compressor is faulty.

It may not be a problem with the compressor and fan, it may be normal. Because the air conditioner turns on the energy-saving or automatic mode during operation, the air conditioner will start and stop the compressor and fan according to the indoor load situation.

This problem should be that there are some problems with the external unit, which may be the cause of heating, or the reason for the failure of some lines.

Judging from your description, is there something wrong with the capacitor? It's really hard to say, it's best to go to a professional repair shop and let a professional master check it for you.

When the fan of the Gree air conditioner is turned on normally for half an hour, the compressor stops is a problem with the compressor capacitance, so please ask the maintenance personnel to take a look.

In this case, it is likely that there is a problem with the control panel, it is likely that it is due to some faults in the control panel, or it may be a problem with the compressor and capacitors.

After the Gree 1P inverter air conditioner is turned on, the fan of the external unit is running, and the compressor does not rotate for two minutes, and the external unit will automatically shut down, hello! When the inverter air conditioner is powered on, there is also a common fault phenomenon that the external fan is running, the compressor cannot be started, the CPU cannot detect the operating current of the compressor, and the external fan will stop running, and the CPU will enter the protection state. Chongqing Grechen Zheng Air Conditioning Maintenance Center reminds that this phenomenon indicates that the fault is in the external unit, and it is in the frequency conversion control circuit, and the main control circuit of the external unit is normal, otherwise, the external fan will not run, and all the detection parameters before the compressor starts are normal.

This fault mainly inspects the IPM and its driving circuit, output circuit, compressor, etc., as well as the variable frequency drive power supply circuit of the switching power supply. The external fan can turn, indicating the fault in the IPM control, output first talk and detection circuit. To measure whether there is AC voltage at the three-phase output terminal of the IPM, you can unplug the three leads of the compressor to determine whether the compressor is damaged or the IPM has no output.

Measure whether the DC high voltage of the IPM is normal. Measure whether the IPM drive voltage +15V of the switching power supply is normal. Measure whether there is a change in the voltage of the 6-channel signal (DC voltage is very low) in the time from power-on to 3min.

Find the IPM protection detection terminal of the CPU, whether there is a large change in the voltage after power-on and after power-on, if there is a change, it is the protection action, find the cause of the change, whether it is IPM or peripheral components are damaged. Hope it helps!

The fan of the Gree inverter air conditioner stops after a while, and the compressor does not work. What a glitch this is.

Hello dear, happy to answer your <>

If your Gree inverter air conditioner fan stops running after working for a period of time, causing the compressor to stop working, there may be the following faults:1Fan motor failure:

A faulty fan motor may cause the fan to work for a short period of time and then stop running, which in turn will cause the compressor to stop working. You can check whether the power supply of the fan motor is normal, whether there is an open circuit or short circuit, etc. 2.

Fan electric Sakura Zenno capacity failure: Fan capacitor is an electrical component necessary for the motor to start and run, if the capacitor is faulty, it will cause the fan to only run for a period of time and can no longer start. You can check if the capacitor is dead or burned out.

3.Faulty control panel: If the control panel of the aircon fails, it may cause the fan to not work properly and cause the compressor to stop working.

You can check whether the wires of the control board are loose or the plugs are not in bad contact. 4.Heat exchanger clogged:

If the heat exchanger is clogged, it can cause poor air flow, which in turn affects the normal operation of the fan and eventually causes the compressor to stop working. You can clean the inside of your air conditioner regularly to keep the equipment working properly. In short, when the fan of the external unit of the Gree inverter air conditioner stops running after hitting the dust room for a period of time, causing the compressor to stop working, there may be faults such as the blockage of the fan motor, fan capacitor, control board or heat exchanger.

It is recommended that you contact a professional aircon after-sales maintenance personnel for inspection and repair.

The fan of the Gree inverter air conditioner stops after a while, and the compressor does not work. What a glitch this is.

Hello dear! <>

The fan of the Gree inverter air conditioner stops after a while, and the compressor does not work, and there is a fault under the bright qin: 1Faulty thermostat:

The thermostat on the unit outside the air conditioner may malfunction, causing the fan to stop and the compressor to not work. 2.Fan motor failure:

There may be a fault in the fan motor itself, which prevents it from running continuously. 3.Power issues:

There may be unstable power supply** or poor power line connections, causing fans and compressors to stop working. 4.Control Board Failure:

The control panel of the external unit may malfunction, and the volt key will cause the fan and compressor to not work properly.

The situation that the compressor fan of the external unit of the Gree air conditioner 2 hp cabinet machine is turned on for about 10 minutes may be caused by the following reasons: 1External Faults:

It may be that there is a problem with the external wiring and power supply of the air conditioner, which causes the air conditioner to not work properly. 2.Internal Failures:

It may be that the internal components of the air conditioner are damaged or there is a problem with the circuit, such as a faulty fan motor, compressor motor, etc., which causes the air conditioner to not work properly. 3.Thermostat malfunction:

If the thermostat is faulty, it may cause the air conditioner to stop working. 4.System Protection:

If the temperature inside the air conditioner collapse is too high or other abnormal conditions occur, the system may automatically stop operating to avoid further damage. In this case, you can try the following solutions:1

Check the power supply, wiring, etc. of the air conditioner to ensure that it is firmly connected and the power supply is normal. 2.Check whether there is any abnormal noise or abnormal situation inside the air conditioner, and check whether the fan motor and compressor motor are working properly.

3.Check that the thermostat is set correctly and that there is no fault. 4.

Try restarting your aircon and see if the same issue still occurs. 5.If none of the above methods can solve the problem, it is recommended to contact the manufacturer or professional and technical personnel for maintenance.

Hope mine works for you! Have a great day! Give a thumbs up in the bottom left corner! Thank you!

Hello dear <>, the reasons why the compressor fan of the external unit stopped for about 10 minutes after the Gree 2 HP cabinet machine was turned on are as follows: 1Power or line failure:

The power supply or circuit of the external unit of the air conditioner is faulty, causing the compressor and fan to fail to start normally, or stop working after being turned on. 2.Clogged tubing:

Due to the presence of dirt, frost and other substances in the pipeline, the refrigerant cannot flow, and the compressor and fan will stop working. At this time, the air conditioner will have an uneven effect of heat and cold, and the cooling effect will be significantly reduced. 3.

Sensor failure: If the sensor of the air conditioner is faulty, the compressor and fan will stop working. In addition to turning off the power of the air conditioner host, you can contact the air conditioning maintenance master Wei Pants Sui Chaichai.

4.Capacitor failure: The failure of the capacitor of the external unit of the air conditioner will cause the compressor and fan to stop working.

This fault is common and requires capacitor replacement. The above is the main reason that may cause the external compressor fan of the Gree 2 HP cabinet to stop for about 10 minutes. It is recommended to find a professional repairer for inspection and repair after encountering problems to avoid additional damage or danger caused by personal disassembly or other factors.