-
5000+ CPU can still be used, you won't overclock, try not to overclock, there is basically no effect on software overclocking. It is also easy to blue screen, and the easiest way to overclock the hardware is to increase the voltage of the CPU in the coms. I advise you not to try it, it's easy to burn the CPU if you don't have experience.
Hard drive rings, I don't know if you are using Seagate hard drive, Seagate hard drive is prone to this problem. Most of them are caused by bad sectors, find a bad sector detection software to see if there are any bad sectors. Generally, Tomato Garden, and Rainwood Forest Wind system installation disks come with this software.
It's called HDD or something. The detection speed is greater than 100ms, and it will be replaced for you according to the three-pack standard.
-
I've experienced it.
You're going to flash the motherboard BIOS.
As for how to brush, it is best for non-professionals to take it to customer service and consult why it is so hot first.
If you are perfunctory, you will be asked to flash the motherboard BIOS to the latest version.
-
Temperature: Processor (Cup) 63-65 degrees is the surface temperature.
Temperature: CPU1 Core 1 2 degrees.
Temperature: CPU2 Core 2 5 degrees These two are the core temperatures, obviously there is a problem with the software, it is recommended to change to the latest optimization or everest to test again, it is also possible that your measurement system is wrong, you can see this in the BIOS to be more accurate.
-
The fan is about to be replaced, and the hard drive has bad sectors.
-
The fan is going to be replaced, the main thing.
-
If it is the original box, it should be used for heat dissipation, and it can be used in ordinary times, and if it is unpacked, it has to be replaced with a fan. In the case of Seagate, it should be a firmware problem, but it can be used normally, and the manufacturer will not replace it! Seagate has a large production volume, there are a lot of problems with quality, choose Western Digital is better, buy it now, will use it, the manufacturer will not change it, because there is no bad point!
Manufacturers only recognize bad pixels.
-
1 All are now about to enter the summer, and the CPU is higher than some time ago is for sure. Of course, it is necessary to see what position it is high to, and whether it has any impact on the system, if it is too high, it is recommended to change the CPU for heat dissipation for desktops, and add a heat dissipation base for laptops. If the hard disk rings, you must first use software to check whether the hard disk has any bad sectors.
After repairing, there is still a problem to prepare for backup replacement as soon as possible, and the sound is that the hard disk is about to break.
-
Clean up the dust of the chassis, if it doesn't work, there is no way, the reason for the aging of the machine.
-
Clean up the dust plus the radiator.
-
Clean up the dust, or replace the cooling fan, it still doesn't work, it's your power supply, buy a better power supply and you'll be fine.
-
The hard drive is super loud! There must be a bad way to do that, so let's change it.
-
Generally, the temperature of the hard disk is a little lower than the temperature of the CPU, unless the hard disk reads and writes a large amount of data for a long time, the temperature of the hard disk may be high for a period of time.
Your situation is most likely due to inaccurate test temperatures caused by changes in the temperature sensor and associated electrical resistance of the hard drive. The principle of electronic temperature measurement is mainly that the temperature change causes the change of the resistance value of the circuit and the current change of the circuit. The software converts the temperature value into a value based on the magnitude of the current.
If your computer is normal and the hard drive doesn't look very hot when you touch it with your hands, you don't have to worry about these minor problems.
-
Absolutely normal !
My summer hard drive is normal 74 degrees.
-
Because the hard drive does not have a fan to actively dissipate heat, it is normal for the temperature to be a little higher.
-
The temperature is fairly normal.
Even in the summer, the CPU is 30 degrees, which is too low, and the hard disk temperature is higher than the CPU, which is not very normal.
Do you have your air conditioner turned on at a very low temperature.
-
It's totally normal. It's summer, and it's going to be lower in other seasons.
-
It's normal, it's so normal, it's very normal.
-
Don't exceed 50 hard drives, so as not to cup!
Don't be afraid of the rest, just don't exceed 45 power supply.
-
60 shouldn't be too high and you can go on!
-
The temperature is high but it's okay.
-
First of all, be clear about what brand of CPU and graphics card you are. (Some CPUs, such as the old Intel, generally reach fifty or sixty degrees, while graphics cards generally 60 degrees is not high).
In addition, the temperature of these components is not too high, basically high, but it is not outrageous.
If the temperature is too high, you can add two front and rear case fans to increase the air volume in the case if the case itself is properly ventilated. This should be a few degrees or so lower.
-
It's a normal temperature. Mine is around 60 degrees!
It would be nice to add more fans and vents.
-
Is the heat dissipation silicon of the fan gone, if it doesn't work, turn on the host and blow it with a fan.
-
……CPU50, graphics card 60 is still high? I play games for a while, and if the CPU is not higher than 70 and the graphics card is not higher than 80, it is impossible to ......
Your temperature is very normal!
-
Better than me, I have this cpu50, graphics card 75, hard disk 30 or so.
-
The case plus the fan, the air path is very important.
-
It may be that there is a foreign object in the fan, clean it up
-
The TDP of the CPU is 65W or even lower, the fan speed is low, the temperature is too high may be due to installation problems, or the speed set is too low, the original speed is generally nearly 5000rpm, which can ensure a lower temperature.
The high temperature of the hard drive can only mean that the heat dissipation of your case is purely a huge problem, and it is even much hotter than the northbridge, and you can consider adding a case fan to improve the heat rejection.
The temperature of the graphics card is normal, and below 90 is acceptable - by the way, G94's 9600GSO is very bad, and the Sempron 2300 is also a low-end dual-core a few years ago, and I am afraid that it has not been cleaned and maintained after a few years, and it is normal for problems to occur.
-
1. The temperature can be within the normal range.
2. How to reduce the temperature to do a fierce calendar, regular cleaning of dust is more than necessary.
3. Hezhi Huili sets up the air duct of the chassis.
4. Replace the heat dissipation equipment with a better pure search and backup.
-
Below 85 degrees is normal.
Don't worry.
High-rise bar. If the north and south are transparent, it should be about the same.
The flame formed by the mixed combustion of acetylene and oxygen is called an oxygen-acetylene flame. The oxygen-acetylene flame has a very high temperature (about 3200 °C) and is heated intensively, so it is the main flame used in gas welding. The combustion process of acetylene (C2H2) in oxygen (O2) can be divided into two stages, firstly, acetylene is decomposed into carbon (C) and hydrogen (H2) under the action of heating, and then carbon reacts with oxygen in the mixture to form carbon monoxide (CO) to form the first stage of combustion; The subsequent combustion in the second stage is an oak grinding based on oxygen in the air, in which the oxygen beam reacts with oxygen to form carbon dioxide (CO2) and water (H2O), respectively >>>More
More than 80 degrees?! Isn't your CPU fan turning? If the fan moves, there must be a problem, maybe the CPU you bought is bulk, flip bag, so the radiator is very poor, you have to change the radiator! >>>More
The internal energy of an object is the sum of the total kinetic energy and the potential energy of the molecular thermal motion. Macroscopically, the internal energy is related to the number of molecules, temperature, and volume of the object. >>>More
Air expansion and contraction You know.
The same is true here. >>>More