What should I do if the wood floor is cracked with underfloor heating?

Personally, I think that for this kind of thing, if the wooden floor is cracked, then it is necessary to contact the relevant person in charge and inform the clear situation.

If the wooden floor is cracked with floor heating, we can buy some repair glue that can repair the cracked box of the floor, or replace it with a new wooden floor.

This is mostly because the floor heating is too dry, when encountering this situation, first turn off the floor heating, then knock down the bad plank, and then replace the good plank.

Personally, I think that when using geothermal heating for the first time or not using it for a long time, it should be set to the lowest temperature first, and then slowly heated, preferably about 1 per hour, so that the wooden floor can gradually adapt to the temperature rise. If the heating is too fast, it may cause the wood floor to heat too quickly, resulting in unstable twisting and cracking changes, and affecting the service life of the wood floor.

1. There is no reserved expansion joint.

The floors are put together piece by piece, but expansion joints need to be reserved between the two connected floors. Prevent the floor from shrinking in dry or cold weather, and if the weather temperature is high, the floor will expand, and these problems will cause the floor to crack.

2. Do not pay attention to moisture-proof.

The flooring is made of wood, and the wood absorbs moisture easily. If the floor is not properly treated with moisture, it will crack due to moisture absorption and expansion.

3. Sun exposure.

If the floor paint is exposed to the sun for a long time, it is easy to cause aging and peeling, and further cracking will occur.

4. Improper maintenance.

If the floor is not maintained immediately or improperly maintained, such as scrubbing the floor with edible alkali or soap, it will lead to the appearance of cracking of the floor. In addition, if the air conditioner is turned on very much, the ambient temperature difference during the day or night is too large, which can easily lead to the floor heating and contraction, resulting in cracking.

1. Repair of surface paint cracking.

If the total area of paint cracking on the surface of the floor is relatively small, we can use painting or polishing and waxing to repair it, but if the total area is very large or more severe, then the only way to do this is to polish the floor first and then apply a layer of paint. The specific method is to use sandpaper to gently polish the damaged position and then remove the stain after polishing, and then scrub it with a dry and soft rag, and then re-do the coating or paste the polyester film, or the customer can contact the manufacturer to carry out the repair with door-to-door service.

2. Repair the gaps between the floors.

If the gap between the floors is more than 2 mm, then it needs to be repaired. If the cracking of the floor is more serious, it is necessary to remove all the floors, and replace them again or part of the floor, at this time, it is necessary to reserve expansion joints to prevent the floor from expanding when it is wet and cold.

It needs to be maintained, if it is more serious, it can only be replaced, and it can be waxed to determine the specific situation.

1. First of all, determine whether the floor you use can be applied to geothermal heating, if the product description says that it can be applied to geothermal heating, and it is still within the warranty period, then directly find the after-sales service to ask for replacement or compensation.

2. If the product description of this flooring is not marked that it can be used for geothermal heating (some composite floors are of poor quality and cannot support geothermal heating), then you can only negotiate with the after-sales service to pay for replacement. If there are cracks in the floor in a large area, it means that the quality of the floor is really not good, and the cracks only affect the appearance, but the formaldehyde volatilization of the unqualified composite floor during geothermal heating is fatal, and it can be considered to be replaced as a whole.

3. It can be treated by the following methods: mix putty with pigment and embed cracks, which can not be damaged for many years. Cut the old newspaper into crumbs, add alum and water, boil it into a thick paste, and then use a knife to stuff the paper paste into the cracks, and when it dries, it will be very strong.

Burn it with cotton cloth or broken sack to ashes, then mix it with raw tung oil to form a paste, and embed it in the cracks in the floor. It can be firm after drying.

Let me talk about my opinion, the cracking of the solid wood floor is because the floor is mostly produced in the south, the moisture content is high, and the air humidity in the north is not enough to reduce the moisture content of the floor rapidly. The lack of normal level in the wooden floor will cause the shrinkage of the floor plate, and in the case of a certain ground area, the shrinkage of the individual dry and excessive floor plate will cause the gap to be good, and the cracking place will be gone!

<> poke all the empty spaces open, keeping in mind that they will expand and shrink in the heat. So be sure to be waterproof, the indoor impact will be a little smaller. It is best to use waterproof materials to prevent water seepage, if the consequences of water seepage are very serious.

The cracking of the floor in winter is caused by the principle of thermal expansion and cold contraction, so before construction, it should be carefully calculated to calculate the water absorption expansion and contraction rate of the material, and then carry out construction.

Partial cracking of the wooden floor, can be made of plastic in my opinion are all fake. Either hardened with fiberboard or pressed with sawdust and glue and then pasted with wood grain paper on both sides, which is also called solid wood? It's ridiculous.

However, it was called, alas, just called, and I couldn't do it with the film cover, and I could not do the operation of humidifying and moisturizing the key moisturizing to keep the relative humidity in the plastic film cover above 80%.

According to the current flooring technology, it stands to reason that this problem will not occur, whether it is a composite floor or a multi-layer solid wood floor, the stability of these two floors is the highest, and there is no possibility of cracking, and the solid wood floor, which can be selected to process the cracking of the wood floor in winter, is caused by the low moisture content in the air. So, the solution now is humidification. The specific method is to maintain humidity and prevent cracking.

In winter, the wind is high and dry, the air humidity is relatively low, the wood fiber in the wood floor will shrink naturally due to moisture loss, and the indoor humidity should be kept within a suitable range, otherwise it will directly cause the wood floor to crack.

You can spray it with that kind of foam glue to fix it.

At this time, you can do some maintenance work appropriately, for example, you can mop the floor more in winter, and you should often open the windows for ventilation, and don't let the temperature of the floor heating be too high.

We can apply some new glue to the cracked area, and then press it firmer, so that the problem of floor cracking can be well solved.

If the gaps in the floor are not very large, you can fill them yourself. It should be noted that when choosing putty, water and transparent materials must be used. Eco-friendly and color aberration does not occur, which affects the appearance.

Water transparent putty and wood chips are mixed filling, of course, you can first fill a very thin strip in the gap and then fill the putty inside. Now there are also caulking pastes for wood floor joints, glass glue, which can be directly caulked, which is very convenient, but it is necessary to choose the right product through the comparison of performance and quality. If there is a gap, but it does not affect the use, you can not do special treatment, but to strengthen daily maintenance and care.

During the rainy season, there are gaps in the floor and there is no problem of extrusion and deformation. In winter, wipe down the floor with a slightly damp towel to keep it moist. Keep the floor moist with solid wax in the summer.

You can use a brush to clean the debris in the opening first, and then wipe it with a cutting cloth to keep the opening dry and dust-free. For solid wood pizza, furniture repairers, MDF, nitrowood, sandpaper, and hand painting are available. Laminate flooring is the same color as above.

If the Madeira floor can open a regular crack, you can first clean up the debris in the opening with a brush, then wipe it with a rag to keep the opening dry and dust-free, then put it around with textured paper, squeeze the sealant domestic silicone at the opening, shave with a shaving tool and let it stay for 12 hours! To find out if a wooden pizza meets the requirements of a wooden pizza or solid Madeira, it is best to find a manufacturer or distributor that offers professionals to carry out repairs. If you even fixed it.

You can use a brush to clean up the debris in the opening first, and then wipe it with a cut cloth to keep the inside of the opening dry and dust-free.

Wooden floors usually have two cracks. This happens during the installation process. This situation can only be repeated.

By the way, please install it in the county company. Another condition is natural cracking. Natural cracking occurs mainly in solid Madeira piso, with thermal expansion and cold contraction.

In view of the current problem of cracks in the domestic floor, it is true that it needs to be dealt with on a case-by-case basis, but sometimes cracks appear unexpectedly on hardwood floors, especially solid Madeira pizza flooring and solid Madeira laminate flooring. If the laminate floor is installed in place, there will be no cracks.

In winter, when the floor cracks, you can choose some wood chips to fill it, and finally wrap it with a layer of glue.