How to wake up the flowers that I bought, and do I need to wake up the flowers?

1. Prepare a larger container in advance, such as: bucket (large bucket), put 1 3 2 3 water in the bucket (depending on the variety of flowers and the length of the rhizome), which is used to hold the flowers that have just been separated from the packaging carton.

2. Remove the outermost layer of the bud that is decayed and yellowish, and the petals that are obviously damaged, don't feel a pity, it is a protective petal during transportation, just remove all the petals from the roots, otherwise it will infect the bacteria and affect the opening of the flowers. Because of the fresh cut flowers.

In order to ensure that there is minimal wear and tear during transport, all the old petals of the flowers are not peeled off. Then cut off at least 2 cm at the base of the flower stem at an angle of 45 degrees, so that the whole flower will be full of water. Remember to remove the leaves from the part of the stem that has been soaked in water.

Especially for roses, try to remove all the root leaves, and it is recommended to leave 2 to 3 leaves under the flower buds. The main reason is that the leaves are very perishable when soaked in water for a long time, breeding bacteria, which will destroy the whole bucket of flowers.

3. Put the pruned flower branches in the prepared container and soak them, and slowly you will find that the flowers and leaves are quietly stretching, and it will take about three or four hours to wake up, which depends on the degree of water shortage of the flowers.

Awaken above. The method is suitable for roses, lilies, carnations.

and other mainstream varieties of flowers, but there are a few varieties of flowers that are particularly water-loving, such as hydrangeas, in order to quickly replenish water, a special way of awakening is required, that is, the flower stem together with the flower head is soaked in water, and the flower can be awakened for more than 4 hours.

This one is a bit harder! There was a tutorial for waking flowers in the peony I bought last time.

Flower awakening means that the following things need to be done after the flower is purchased so that the flower can be maintained for a longer time.

1. Flowers after long-distance transportation, in the high temperature season, flowers will appear wilted or dehydrated, at this time the end of the flower stalk can be cut off a little, and then soak it all in clean water. To keep the flower heads out of the water, (the water level depends on the dehydration), use the pressure of the water to encourage the flower branches to absorb water. Leave 1-2 leaves for each branch.

2. The flower branches are soaked in water for about 2 hours (depending on the dehydration situation), and the flowers will slowly stand upright, and the branches and leaves will become bright and straight again. (It is very important not to throw it away because of its ugly appearance).

3. Flowers are cut from the base, and the outer layer of damaged old petals is not removed, in order to protect the petals inside, and the outer layer of old petals can be removed after receiving flowers. Do not see the outer layer of old petals and throw away the whole bunch. Remember, remember.

Very important, the beauty of the flowers is pruned).

Flowers bought in the florist need to be awakened, because after long-distance transportation, the internal moisture is depleted, and it needs to be replenished in time. When waking up, it is necessary to cut off the flower branches by about 3 cm and prune off the excess withered leaves. Then put it in a clean container, pour in clean water, and let it rest for about 4 hours.

It can then be inserted directly into a clear glass bottle for curing.

It is recommended to wake up the flowers, just bought flowers to wake up in order to restore the activity of the flowers, prepare a large bucket when waking flowers, add 2 3 water to the bucket, sleepy guess and then put the flowers into the bucket to soak for about 4 hours, after waking the flowers, and then 45 degrees oblique cutting of the roots, and cut off the excess Zhaoru leaves and the upper part of the flowers in the lower part of Wang Xiang's excess leaves and the upper part of the dead leaves, and finally insert them into the vase.

Want. In daily life, so the fresh cut flowers need to be awakened, the method of awakening flowers is relatively simple, only some steps need to be paid attention to, the bottom of the flowers should be cut obliquely at about 45 degrees when awakening. When pruning Zheng rolling, it must be oblique cutting can not be flat cutting, oblique cutting is conducive to increasing the water absorption area of flower roots.

When flowers are awakened, the time of awakening should be judged according to the different varieties of flowers. Generally speaking, the time spent on flowers should be limited to about 4-5 hours, but not more than 10 hours.

Precautions for flower awakening.

Flower awakening is to replenish water to the flowers, so that the flowers can maintain a normal growth state. Most of the flowers are sent after a long time of transportation, most of them are transported by air, and in the process of transportation, the flowers are basically in a state of water shortage without sufficient moisture. After receiving the flowers, you need to hydrate them in time, but the time to wake up should not be too long.

When waking the flowers, be careful not to let the flowers touch the water. After waking up, the water in the flower body is relatively sufficient, and the leaves can be picked. It is necessary to remove the excess leaves on the branches, and leave about 2 leaves under the balance bush at the bottom of the flowers.

In the later period, during the maintenance period, it is necessary to change the water frequently and prune the branches, generally pruning once between 2 days and 3 days.

The above content refers to Encyclopedia - Awakening Flowers.

After buying back the flowers, you can destroy the leaves under the flower branches to remove some of them, and the bottom of the flower branches should also be cut at 45 degrees obliquely, and the tender green part should be exposed after cutting. Prepare another vase, add water to it, and then put the flowers in it, and it will take about an hour to soak in the bucket wheel. Note that in the process of waking up the flowers, do not soak the flower head in the water, the water level is almost 5cm below the flower head is the best, and you can also add a little bit of Bika potassium dihydrogen phosphate to the water to make the flowers more colorful.

The purpose of waking up is to allow the flowers that are dehydrated during the long journey to reabsorb water and become full and straight.

The effect of waking up flowers is very large, because after buying, the flowers will be dehydrated for about 2-3 days, so they will become very soft when they arrive home. Therefore, after waking up at this time, the flowers will slowly drink enough water and will wake up. When waking flowers, you need to soak in water for 4-5 hours, if the soaking time is relatively short, the effect of waking may not be very good.

Prune: Cut off the leaves at the base of the flower branches, then cut the base of the rhizome diagonally by 45°. Prepare the container:

Prepare a bucket of water at the right height. Start to wake up: Soak all the parts except the flower branches in water for 3-4 hours.

Vaping maintenance: Insert the flowers into a transparent vase and move them to a ventilated place for maintenance.

1. Prune

Most of the flowers bought back, most of the branches and leaves wilted, before waking up the flowers, it is necessary to prune them, cut off the yellowed and damaged leaves, and cut off the lower leaves, and then cut obliquely at the bottom of the flower stem to increase the water absorption area.

2. Prepare the container

When waking up flowers, prepare a deep bucket with the same height as the flower branches, and then fill it with clean water, pay attention to use clean and pure water, do not soak in tap water, rainwater, and river water.

3. Start to wake up

In the process of waking up flowers, soak all the flower branches directly in water, pay attention to the flower heads should be exposed outside the water surface, not in contact with water, otherwise they will be black and rotten, and ensure that the plant soaking time is about 3-4 hours.

4. Bottle insertion and maintenance

After the flowers are awakened, prepare a transparent glass bottle, put the flower branches in, then add water to the third of the rhizome, and finally move the flowers to a well-ventilated environment with sunlight scattering for maintenance.

<>1. Remove the water storage cotton wrapped in the roots, and cut off the yellowed and damaged leaves.

2. Use scissors to cut the root at an angle of 45 degrees by 3-5 cm to expose the tender green part.

3. Soak the flower branches in deep water and wake up for more than 4 hours, and the flower heads are exposed outside the water.

4. After the flowers wake up, put the flower branches into the bottle, then add water to one-third of the rhizome, and finally move the flowers to a well-ventilated environment with sunlight scattering for maintenance.