How to clean the aluminum cover so that it will not deform, and how to clean the underwear so that i

With Jining Hengda's auger aluminum cap cleaning machine, the principle is the same as the auger ultrasonic bottle washing machine, the aluminum cap is in the track, will not be deformed due to friction, first after ultrasonic cleaning, and then through the spray of high-pressure water and high-pressure air, the cleaning is very clean.

1. The aluminum cap is not in direct contact with the drug, and some people think that its cleanliness should not be excessively demanding. Modern aluminum caps are produced in a high environment, and they can be sterilized directly without cleaning. Because the aluminum cover is easily deformed during the cleaning process.

During use, the hospital will also disinfect the parts where the aluminum cap and rubber plug are in direct contact with the needle. But some people think that it is better to have high requirements and should be cleaned.

2. The commonly used methods of aluminum cover sterilization are dry heat, damp heat and ozone, each with its own advantages and disadvantages. The dry heat aluminum cover will change color, and the damp heat will leave water traces, but the effect is good, while ozone disinfection has no effect on the microscopic aluminum cover, but it is greatly affected by the temperature and humidity of the sterilization effect, and the reliability is not good. What do you think is the best way to do this?

3. Some people think that the cleanliness requirements of the tie-up room should be higher, and the country seems to be considering raising its cleanliness level to 10,000, because there are always some that are not tightened. Some people think that it is unlikely, because the quality of the tie is mainly determined by whether it is tightened or not, and the small amount that is not tied should be eliminated in itself.

Using the principle of Jining Hengda auger aluminum cap cleaning machine, the friction and deformation in the aluminum cap track of the auger ultrasonic bottle washer are first cleaned by ultrasonic and then cleaned by high-pressure water and high-pressure air spray.

Don't wear the underwear you just bought, it's so simple to wear again, it's clean and not easy to deform.

Pinch with pliers and squeeze a cylinder with a small diameter and cup mouth, good luck.

You can put the soybeans in the lid and soak them in water, then press the lid with something heavy, and soak it for a day or two, this method may help you. Don't forget to give points! There's no better way!

The buckle cover is lined with aluminum-plastic panels, the end is fixed with the buckle cover, and the other end extends into the other end of the buckle cover, leaving a gap of 3-5mm for glue injection.

This has a certain degree of professionalism, and you can see if there are traces of plastic surgery from the inside.

If you don't know much about the car, you can ask the 4S to show the old parts when you pick up the car.

Look from the inside! The inside of the whole will definitely not be the same as new!

Hello, the general cover hydraulic struts will not deform the top of the cover, if there is deformation, it can be installed incorrectly or position deformation, if this situation occurs, it is best to go to the repair shop to find a sheet metal worker to adjust the treatment.

This hydraulic strut, of course, will not break the cover, you can rest assured of this. His endurance is still very strong, and he won't be broken, so you can rest assured that there is no problem.

Hello, this is not going to be able to rest assured, most manufacturers are designed like this, this is a support, the others are nothing, and the weight is not particularly heavy.

This is definitely not going to happen, and since it is designed this way, many experiments have been conducted. Besides, the material strength of aluminum alloy is very large, and the strength is relatively greater.

Hello, this is not possible, many cars are made of hydraulic struts, and the strength is not very large.

The original factory is about 300 hundred, and there are wholesale less than 100