My violin doesn t make a sound

After washing with soap, the rosin on the violin bow will also be washed off by soap!

Rosin is used to increase the friction between the bow hair and the strings, and only if the friction is strong enough can it pull out the sound. Your bow hair is now extremely smooth, and it is impossible to pull out the sound.

Rub rosin! It's the translucent yellow-black thing in the violin box, rubbing it against the bow hair, smearing it in all directions. At this point, you can pull out the sound again!

If you don't have rosin, you can go to the piano store to buy it, generally speaking, you can buy one for seven or eight yuan, and twenty or thirty yuan for *** point.

Pay attention to take care of your piano, the bow hair can be washed with soap and water, but the body can only be wiped with a dry rag! Note that the maintenance of the violin is just as important as the learning of the violin.

Wipe hard! It took me half an hour to get my new bow to sound.

You may not wipe long enough, it is recommended that you wipe it for five minutes and ten minutes.!

It's simple, now dry the bow, and then apply rosin, the surface of the rosin you just bought is smooth, find a way to rough it and wipe the bow hair

The bow should not touch the water, it is best not to touch the dirty fingers, and it is best not to touch the bow hair.

I feel that your bow is wasted, buy a new one, 40-50, just a normal one.

After buying it, you need to wipe the rosin for the violin before you can use it, and the new bow should be rubbed more and fully contact and absorb.

There is no research on the bow hair, if the landlord does not want to change it, wash it and dry it, and then fully wipe the rosin, a few friends upstairs said very well, smashing the rosin and smearing it on the bow hair is also a good way to give the new bow full contact.

If it doesn't work, it's waste, buy one.

Because there are small serrations on the top, it will be troublesome to wash off (you can only change a bow), you break the rosin into powder, and then relax the bow screw, stand rosin (not too much) in the adjustment bow screw pull down to try. If not, you can only replace one bow.

Your violin is a toy piano!!

Hehe, just kidding!

Rub the rosin on the bow hair a few more times, and maybe you can make a sound again!

The soap is not waved clean, re-rinse the bow hairs, and then apply a few more times of rosin.

Soap is oily!! Because people use soap to bathe and wash their hands, and moreover, many soaps nowadays have emollient properties.

Forehead. Schoolmate. The horsetail bow should not touch soapy water or anything like that.

The sound of the ponytail and the strings coming into contact is due to the rosin, the friction between the ponytail and the strings, and the soapy water you are still using, and this bow can be said to be scrapped. I advise you to buy a new bow! Come on!

Applying rosin doesn't help it, it's probably soapy water that hasn't been washed, you can clean it a few more times!

The reason why the violin can make sound is because of the friction between the bow and the strings, the ponytail on the bow is specially treated, and the rosin is used to make it more lubricated, and you use soap to destroy its original structure, which is equivalent to the treated ponytail has been restored again, it is better to buy a new one, you have just learned, at most buy forty.

Smash a small piece of rosin and spread evenly over the bow hairs. Then rub well with a whole piece of rosin.

Hello, if you want the cello to play without making a little sound, you need to take the following measures:1Use a mute:

A silencer is a small device that can be attached to a cello bridge to reduce string vibration and thus sound production. There are two types of silencers: rubber silencers and metal silencers, which can be selected according to personal preference. 2.

Adjust the posture: The correct posture can reduce the resonance of the cello and thus the production of sound. You can try adjusting the elevation of the elbows, adjusting the angle of the body, etc.

3.Use a practice mat: A practice mat is a soft cushion that can be placed on the bottom plate of the cello, which can reduce the resonance and sound **, and reduce the production of sound from Sun Kai's blindness.

4.Adjust the strength of the bow: the less force the bow has, the quieter the sound.

You can try to reduce the strength of the bow in the air, but be careful not to affect the sound quality and rhythm of the play. In short, if you want to make a cello play without making a sound, you need to take a variety of measures, such as using a mute, adjusting your posture, using a practice mat, etc. At the same time, care should be taken not to affect the sound quality and rhythm of Sun Qi's performance.

Hello dear, if you want to make a little sound when the cello is played, you can try the following methods:1 Use a mute: A silencer is a small device that can be clamped to the cello bridge to reduce the vibration of the strings and lower the volume.

There are many different types of silencers to choose from, including rubber, metal, and plastic products. 2 Practice left-hand technique: Left-hand technique is very important to control the volume.

You can gently press down on the strings while practicing to avoid too much resonance and resonance. 3 Use the Kaizhen Bow Technique: The Bow Technique can also affect the volume.

By adjusting the pressure and speed of the bow, you can control the volume magnitude. 4 Adjust your posture: Proper posture can help control the volume.

Making sure the cello is placed in the correct position and with the elbows and shoulders relaxed can reduce unwanted resonances. 5 It is important to note that it is not possible to completely eliminate the sound made by the cello, but the above method can minimize the volume.

Is your violin new?

Is it an electronic tuner?

Because of the different models and brands, they can be divided into many kinds. If it's the kind used by the key, here's how to do it:

Press the play button for 3 seconds, turn on the power switch, press the mode button, so that the small arrow on the left side of the screen is aimed at the violin, if the environment is quiet, do not connect the pickups, if the surroundings are noisy, you can connect the pickups, clip the headstock. Pluck or pull the string 2 strings, the tuner should display 2a, and at the same time, the indicator light and pointer tell you whether the sound is high or low, the pointer is on the left, and the light on the left is on, indicating that the sound is low, and the strings need to be tightened a little, if 2a is displayed at the same time the light on the right is on, and the pointer is on the right, it means that the sound is on the high side, and the strings need to be loosened a little. Generally speaking, the strings are constantly loosening and the pitch is lowered, for example, if the temperature drops suddenly, the strings will contract, and the pitch will be higher, and you need to relax a little.

In addition to adjusting the tightness, in addition to adjusting the four shafts above, it is best to consider adjusting the fine-tuning first. Other string strip adjustments are similar.

If you use an angel brand violin tuner (that is, the kind of light on, it is highly recommended for parents of children, it is very simple and convenient, and it is not expensive - about 40 yuan), after opening, directly clamp the string to be tuned, pluck. Slowly adjust to the tuner to turn green.

There are four holes in the violin tuner, which can blow different tones, according to the different pitches, and then pluck the strings with your hands to see if the sound quality is the same.

Tuning method of tuner:

1. Put the tuner on the battery, press the open button, and turn it on. Clip the tuner to the headstock.

2. Tighten the violin twist, pluck the strings, if the pointer is to the right, loosen it a little, and to the left, tighten it until the guide points to the middle, green.

3. According to the above method, tune other strings.

4. Adjust again, and the four strings are all green, which is the standard note of the violin.