The wipers of the original car are good, or they are good without bones

The bone-based wiper is a close fit between the wiper blade and the glass through multiple fulcrums, due to the need for strong pressure of the wiper arm, which will cause fatigue of the wiper motor, so its advantage is that the shell is relatively hard, but the disadvantage is that the swing is very poor in use.

The first advantage of the boneless wiper is light, needless to say, the second benefit is supported by a fulcrum, that is, the so-called elastic steel sheet, it and the blade surface of the wiper blade is tightly sealed, it can be pressed on the glass by a small force, there will not be a lot of strength to scrape the glass in the work, and the glass can be completely scraped clean, so the degree of scraping the glass, cleanliness and strength of the boneless wiper is much better than that of the boneless wiper.

Nowadays, there are more boneless wipers for basic high-end cars, but now low-end models are also slowly tending to boneless wipers.

Hello, the boneless wiper has less focus point, only one main force point, which is worse than the multiple force points of the boneless wiper, so if you use a boneless wiper, the wiper may not be clear. There is an elastic strip inside the boneless wiper, and the elasticity of the strip is large, if the wiper bracket cannot bear it, it is likely to cause the middle of the boneless wiper to be warped. In this case, you can switch to a traditional boned wiper, which can better adapt to the lower pressure of the wiper bracket and achieve a better wiping effect.

The pressure of the wiper bracket is large, which can completely overcome the elastic force of the internal shrapnel of the boneless wiper, and press the wiper strip on the glass surface, so that the effect of the boneless wiper can be better displayed.

Personally, I think it is better to choose the wiper bracket of the original car, which is relatively more suitable for the windshield arc of the car, and the boneless wiper installed in the rear, although it is relatively good in terms of structure, but it is not necessarily suitable for the windshield arc of your vehicle!

Hello, in general, it is definitely better to have a boneless wiper, but this kind of wiper has no support, it is easy to deform, and after deformation, it will be unclean, abnormal noise, etc.

Hello. It's best to use the wiper blades of the original car! The back is supported, which is not easy to deform and twist.

Boneless wiper blades are flexible due to their lack of support, and they are easy to deform and twist after a long time. The service life of wiper blades is generally about one year, which is a wearing part.

The wipers of the original car are good. Bone-based wipers are also better than boneless, provided that they are excellent.

Hello. If the original car is bone, then of course, it is, not as good as the boneless wipers.

Hello, the wipers are actually almost the same, if the original factory uses the wiper with a bracket, it is best to use the original factory, the wiper blades are consumables, you can replace them regularly, I am happy to answer for you!

Automobile manufacturing requires cost, and the wearing parts of the original car will generally not be matched with good things, and the wipers are still boneless.

Hello, the wiper actually doesn't matter, as long as the water stains and dust on the glass can be cleaned, or the quality of the original car can be better, and the life is longer.

Generally speaking, if you replace the wipers in the later stage, you can replace the boneless wipers, which is relatively good, and it is relatively convenient.

The effect of the boneless wiper is good, but if the wiper of the original car is still usable, there is no need to replace it.

Hello, all the same easy to use, wiper blades are vulnerable accessories, if the wear reaches a certain level, you can replace it.

Hello, the wiper of the original car is also very good, but you can replace the boneless wiper with a lower noise later.

The practicality is almost the same, but it is said that after a long time, the wiper strip of the original car is aging and the glass cannot be cleaned, and it needs to be replaced.

Hello, the function of the wiper is to scrape water, he uses rubber strips to work, as long as the rubber strips ***, the effect is good.

If you seem to be right, of course, it is a bony wiper, and the overall performance is a little better, you can refer to it.

Hello, this normal word must be the original wiper to be of better quality, but the boneless one is also good.

Hello. The one I'm currently using is a boneless wiper, which is still pretty good, and it's better to use than the boneless one.

This wiper still depends on personal use, and it is generally more convenient to replace the boneless wiper, and it can also be replaced.

Hello, this actually doesn't matter how you use it, I personally recommend using the original wipers, the wipers are wearing parts, you can use both for a period of time to compare** It is not expensive.

Hello! It depends on personal preference, and it doesn't make much difference which one you like.

Boneless wipers are better than boneless wipers, but boneless wipers are more expensive than boneless wipers.

The difference between bone-based wipers and boneless wipers:

1. The order of power transmission of traditional wipers is: main arm, main pressure strip, secondary pressure strip, fixed pressure strip scraper; And the order of the power transmission of the boneless wiper is: the end of the bracket guide strip scraper.

2. Different stress methods: traditional wipers have multiple pressure points, while the integrated steel sheet used in boneless wipers has relatively uniform stress points.

3. When replacing the boneless wiper on the car, there is no need to replace the wiper arm; To replace the bone-based wiper, the bone-based wiper needs to be replaced together with the wiper arm.

Here are the pros and cons of bone-based and boneless wipers:

Bone-based wipers. 1. Advantages: Cheap;

2. Disadvantages: discontinuous pressure distribution, uneven wear, troublesome replacement, and short replacement cycle.

Boneless wipers. 1. Zheng slip advantages: easy to replace, uniform pure loss of grinding ear bush, guess long replacement cycle, anti-floating wing can avoid wiper fluttering at high speed;

2. Disadvantages: **More expensive.

Hello, I think the boneless wiper is better because it is of better quality.

If you encounter similar problems in the future, you can follow the following ideas to solve them:

1. Finding problems: often living in the world, always in these kinds of contradictions, when some contradictions are projected into consciousness, the individual only finds that he is a problem, and asks to find a way to solve it. This is the stage where the problem is discovered.

From the perspective of the stage of problem solving, this is the first stage and the premise of solving the problem.

2. Analyze the problem: In order to solve the problems found, it is necessary to clarify the nature of the problems, that is, to figure out what contradictions there are, which contradictions, and what is the relationship between them, so as to clarify what results the problems to be solved, the conditions that must be met, the relationships between them and what conditions have been met, so as to find out the important contradictions and key contradictions.

3. Put forward hypotheses: on the basis of analyzing the problem, put forward hypotheses to solve the problem, that is, the solution that can be adopted, including what principles and specific ways and methods to take, but all of these are often not simple and ready-made, and there are various possibilities. However, putting forward hypotheses is the key stage of problem solving, and correct assumptions lead to the smooth solution of the problem, while incorrect and inappropriate assumptions lead to detours or lead the solution of the problem astray.

4. Verify the hypothesis: The hypothesis only proposes n possible solutions, and there is no guarantee that the problem will be solved, so the last step in problem solving is to test the hypothesis. In either case, if the test does not produce the expected result, a new hypothesis must be proposed and tested again until the correct result is obtained, and the problem is not solved.

The degree of scraping glass, cleanliness and strength of boneless wipers is much better than that of boneless wipers. And when scrubbing, it will change with the curvature of the front windshield, and will not cause scratches on the glass surface. Here are the differences between bone-based and boneless:

1. Bone wipers: It is through a number of fulcrums to compress the close cooperation between the wiper blade and the glass, due to the need for strong pressure of the wiper arm, which will cause the fatigue of the wiper motor, its advantage is that the shell is relatively hard, and the disadvantage is that the swing is very poor in use. 2. Boneless wipers:

The first advantage of boneless wiper is light, and the second advantage is to support it through a fulcrum, which is the so-called elastic steel sheet, which is tightly sealed with the blade surface of the wiper blade, and can be pressed on the glass by a small force.

The wipers we are talking about today can be said to be an indispensable part of the car, which can effectively alleviate the impact of rainy weather on the driver's vision. But some friends don't know that wipers are divided into two types: skeleton and skeleton, don't underestimate the distinction between skeletons, which are very different in terms of function. Let's talk about which is better, bone-based wipers or boneless wipers.

First of all, let's talk about the boneless wiper, because there is no support of the pylon, not only can the wiper and the glass have a good fit (low noise), but also in terms of force and wear are relatively uniform, so that there is a better scraping effect. As for the bony wipers, with the support of the pylon, it is easier to remove impurities from the front windshield glass, especially the dirt of large objects, and the bony wipers can also be effectively removed.

As for which is better, in fact, the boneless wiper has more advantages, not only the wiper effect is more obvious, although there is no boneless wiper that can effectively remove impurities from large objects, but we use the wiper almost to scrape the rain. And the boneless wipers will be much quieter to use, and the sound of the wiper operation will hardly be heard. But boneless wipers are more expensive than bone-based wipers in terms of **, so if it is not a place where it rains often, in fact, you can choose bone-based wipers.

The boneless wiper is to bend the iron bar in the middle, so that the wiper is attached to the glass surface of the force point unevenly, resulting in unclean water marks, plus the method of fixing the rubber strip is not the same, so the service life is not long, although it is very good when it is first installed, the effect is significant, but after a long time, there will be a very hazy phenomenon of scraping and scraping!

In terms of the principle of boneless wipers, the so-called boneless wipers are relative to the traditional wipers with brackets, the fulcrum of the wiper is the more the better, the more fulcrums, the more uniform the force of the wiper blade, and the more obedient the contact with the glass. The boneless wiper does not have a bracket, and the entire wiper blade itself is pressurized, which is equivalent to all the force points, so the design of the boneless wiper is more effective than the general traditional wiper, and is conducive to improving the best vision. Four months after leaving the factory, the bony wiper will have problems such as unsatisfactory scraping and water marks, which will seriously affect the driving safety in rainy and snowy days.

The boneless wiper is designed with aerodynamic factors in mind, the structure is relatively simple, and the overall weight of the material is light, which undoubtedly reduces the burden on the motor and rocker arm. When in operation, boneless wipers are not only quiet or even noiseless, but also have a relatively long lifespan.

Boneless wipers will have more advantages, not only the effect is obvious, but also the use will be much quieter. If you're in a place where it doesn't rain a lot, it's fine to use a boneless wiper, as boneless wipers will cost more than boneless wipers.

Compared with boneless wipers, boneless wipers have a simpler structure and are easier to disassemble and replace accessories. Moreover, the boneless wiper steel strip is elastic, which not only makes the wiper better fit the glass surface and achieves a better wiping effect, but also the wiper will not shake easily and is not easy to produce noise.

It must be oil-bone wipers. This model of wipers, its use time is longer, grains, it is only cheaper, but you replace it more frequently.

If you buy a fire wing, the U-shaped interface is universal and can be installed. Wiper size: 20 inches + 22 inches If it helps you, I hope to click on the "answer" in the lower right corner, thank you for your support!

Boneless wipers are cleaner and last longer than boneless wipers. Boneless wipers are more effective than traditional bracket bone-based wipers, and at the same time, boneless wipers remove the metal bracket, which also reduces the impact of the wipers on the driving vision when opened, and the safety is also greatly improved.

Generally speaking, rain is used for about a year, and it needs to be replaced for a year and a half at most. Of course, depending on the environment used and the problem of rubber band material, the specific replacement time will also vary. Every time you use a wiper, whenever there is an irregular trail of water, there will be a screeching sound and a noticeable water leak, which are all signs of premature aging of rain.

Common rain is divided into bone rain scratches.

The bones and wipers are evenly distributed by multiple supports (skeleton structure) to support the wipers, and the degree of wear and tear during use is also average, which is easy to produce scratches and noise of friction between glass, and it is not easy to scrape impurities. Boneless wipers are the only points of support with a long, smooth arc. The full conductive steel bar is used to disperse the pressure, and the force of all parts of the non-scratch can be evenly forced, which can achieve the effect of reducing water marks and wiping defects.

Just like this one, a glass surface filled with foam will completely disperse if you scratch it twice, leaving almost no marks if it is a covered area.

The strength of the wiper's cleaning ability has a lot to do with the adhesion of the rubber band and the windshield, and the toughness of the conductive steel bar determines the high adhesion. When it comes to rain, it's quicker and cleaner, and with this kind of rain, the next rainstorm won't be in vain. Which is better, a ballless wiper or a golf wiper, the old driver will tell you the answer.

In addition to being clean, the low noise of the rain without bones is also a big advantage. Imagine if it rained and made a screeching noise, and your nails would feel like they were scratching a chalkboard. Which is better, a ballless wiper or a golf wiper, the old driver will tell you the answer.

Golf wipers generally use a special car interface, that is, a U-shaped port suitable for the wiper and a side check design, which is very convenient to install and can be completed by pressing a button. Which is better, a ballless wiper or a golf wiper, the old driver will tell you the answer. On the whole, in addition to being cheap, bones and rain no longer seem to be able to compete with the same quality of boneless ratio, the possible boneless ratio and scratches when replaced, more clean and quiet, and the most important driving process may be safer, why not be happy!