Rebooting the computer after the blue screen shows what happened without a hard drive

Then you have a bad sector on your hard drive, which causes a blue screen, loses the boot partition, or the motherboard can't boot the system partition normally, just find an efficiency source to fix the bad sector, I hope there is no physical bad sector.

Replace the hard disk data cable and power interface first, if you can't find a hard disk, if someone else's hard disk is normal on your computer, it means that your hard disk is broken.

Pay attention to the following issues to avoid most computer crashes or "suspended animations".

1. Installing too many operating systems on the same hard drive will cause the system to crash. It is best to format and clean it with PQ before reinstalling.

2. CPU, graphics card and other accessories should not be overclocked too high, and pay attention to the temperature, otherwise, it will restart or freeze inexplicably when starting or running. In general, don't overclock casually.

3. When replacing computer accessories, be sure to plug them in, because poor contact with accessories will cause the system to crash.

It is strictly forbidden to copy and repost, Eagle in the Blue Sky

4. BIOS settings should be appropriate, sometimes due to sudden power failure and other reasons caused by BIOS chaos, it can be discharged or restored to factory settings.

5. In summer, the night is generally the peak of electricity consumption, and the voltage is unstable and easy to cause crashes, so it is best to equip it with a stabilized power supply.

6. Do not use floppy disks and CDs from unknown sources, and use anti-virus software such as Rising to check the software attached to the e-mail, so as not to cause the virus to crash after infection.

7. Do not turn off the power when the application software does not end normally, otherwise it will cause damage or loss of system files, cause automatic startup or crash during operation. This is important for systems such as Windows 98 2000 NT.

8. In the installation of application software, if the prompt dialog box "whether to overwrite the file" appears, it is best not to overwrite. Because the current system file is usually the best, you can't overwrite the file based on the order of time (unless you are concerned about the timing of the file).

9. When running large application software (such as Office 2000), do not exit the previously running program in the running state, otherwise it will cause the crash of the whole system.

I saw that a lot of people raised the blue screen problem, and I summarized it seriously, and finally wrote out the method after all my hard work, I hope it can help you, and I want to adopt my answer Oh oh:

Reason 1: A blue screen will occur when the program is wrong. Sometimes it's just a mistake made by a program or driver that can be restarted and restarted.

Reason 2: If the new hardware is not added properly, it will cause a blue screen. Check that the new hardware is plugged in, unplug it, try a different slot, and install the latest drivers.

Reason 3: If the new driver is not added properly, it will cause a blue screen. If a new driver that has just been installed has a BSOD, go to Safe Mode to uninstall or disable the new driver (Enter "Safe Mode" Method 1:

When powered on, quickly press the F8 key to select "Safe Mode". Method 2: First, start running msconfig and enter OK to click the "tab"; 2nd, select "safenoot"; 3rd, click "OK" to save, exit and restart the computer; Fourth, select "Safe Mode" from the Windows XP Advanced Options menu that appears after restarting; 5. Repeat the above steps if you want to cancel the "Advanced Options Menu", the difference is that step 2 deselect "Safenoot".

Reason 4: Virus invasion will cause a blue screen. Viruses such as shockwaves and oscillating waves can sometimes cause the Windows Blue Screen of Death, so it is essential to detect and kill viruses.

Reason 5: Newly installed computers sometimes have blue screens. If you have a new computer that often has blue screen issues, you should check and upgrade the BIOS to the latest version.

Reason 6: The system file will be replaced with a blue screen. Start Run sfc scannow to check if the system files have been replaced, and then use the system installation disk to restore (if you don't, it is quickest to reinstall the system directly).

If this is the case or not, you can use the following common blue screen solution: Quickly press the F8 key when booting up the computer and the advanced boot options menu will appear, and then select "Last correct configuration" to boot the computer. zz

There are several possibilities.

1. Change the boot order in the BIOS to hard disk first.

2. Jump the hard disk jumper to the main disk, sometimes there is only one hard disk and jump to the slave disk, it is best to use a data cable for the hard disk and optical drive.

3. In the most likely case, the machine configuration is high, the boot speed is fast, and the hard disk has completed the self-test before it is fully rotated, resulting in a black screen after the self-test. Solution: Turn off the Quick Power on Self Test in the BIOS

4. The data cable of your hard disk is broken, you can change a few data cables to try;

5, there is a possibility that when your motherboard has a problem, if the data cable is replaced or not, see if your motherboard has burned off the chip or capacitor, if not, it is best to let the motherboard repair the motherboard take a look.

I guess you use a serial port hard disk, if that's the case, I recommend you buy a better serial port hard disk cable.

Computer blue screen failures are relatively common. There are many failures that cause the blue screen, and I can't give you the details of the reasons that produce the blue screen. In a nutshell, there are only two reasons for the blue screen.

1. If the system fails, the solution can only be reinstalled.

2. Memory failure, memory replacement.

Look at what you said you can get in if you try a few more times.,I guess it's caused by unstable memory.,If it's a system failure.,Then the system is broken.,Can't go in.。

Take a look here and you'll understand. Hope it helps!

How long has the computer been used, you first clean the chassis, unplug the memory and graphics card and clean it with an eraser, is there any poisoning?

Hello, computer blue screen, [F4] appears, this is: memory read error!

1。Try to boot up, after the computer brand is out, press F8, Safe Mode, Cursor Select: Last Correct Configuration, Enter, Enter, Press Down! [Critical step].

2。If it still doesn't work, you need to "one-click restore" or "reinstall the system"!

3。If there is a problem with the hardware, send it for repair!

In most cases, the hard drive will need to be replaced, or the motherboard chip will be damaged.

The blue screen mainly analyzes the bright call from two aspects:

First, there is a problem with the hardware, that is, the memory.

Second, software, there are many problems. Workaround:

Check the memory module and replace it if it is broken.

Dual memory is not compatible.

Use the same brand of memory or just one memory.

Memory quality issues.

Replace the memory module.

Heat dissipation issues. Enhance heat dissipation inside the case.

The memory and motherboard are not plugged in properly or are not compatible with other hardware, etc.

Reinsert the memory or replace it with a bad one.

There is a problem with the hard drive. Replace the hard drive.

Driver issues. Re-installed drive. If you are using a new system, you need to install the motherboard driver first.

Corrupted software. Reinstall the software.

There is a bug in the software

Patch or use the latest version.

Software and systems are not compatible.

Patch the software or try the compatibility mode of the system.

There is a conflict between the software and the software.

If you have recently installed any new software, uninstall it.

The software should be used to reinstall the relevant software if there is a problem with other related software modifications.

Virus issues. Antivirus.

Antivirus software conflicts with the system or software.

Since the antivirus software is entered into the bottom Jing Jiankai layer monitoring system, it may conflict with some software, uninstall it and try.

There is something wrong with the system itself.

Sometimes the operating system itself will also have bugs, pay attention to install the official release of the upgrade program, like the SP patch, most.

Good. To be hit. If you can't reinstall the system or replace it with a different version of the system.

If it helps you, I will give you five stars and wish you a happy game! Remember

In this case, it is possible that there is a problem with your system, and you can try to reinstall the system to see.