I would like to know what knitting machine is weaving, indoor shoes. It s shoes made of wool

It is a knitting machine (also called a flat knitting machine, the kind that makes sweaters) and then cuts it to make an upper, but with a thick needle:

There are a lot of Zhangjiagang, to inquire, find one closer to you, easy to maintain.

Knitting of woolen shoes**:

1. Weave slippers face.

Two colors of wool were used, red and yellow).

6 stitches from the red wool thread, weaving the first row; When turning back to weave the second row, the first stitch is not knitted, and a stitch is added before the last stitch, and the last stitch is knitted; Then go back and weave the third row, the first needle is not knitted, at this time, it is already 7 needles.

At the beginning of the fourth row, use yellow wool, tighten the red thread a little, pull it to the back, and use the yellow thread to cross the red thread and start weaving. The first stitch is removed directly and is not knitted; The second needle begins to weave the yellow thread, and when it reaches the penultimate needle, one more needle is added, and the last one is knitted; Then go back and weave the fifth row, and the first stitch is not knitted, at this time there are a total of 8 stitches.

At the beginning of the sixth line, first pull the yellow line to the back, press (cross) with the red line and start weaving the sixth line, the method is the same as above.

Repeat this until about 54 stitches (you can measure the edge of the needle with a single sole, tighten it a little, and measure half of the sole - the midline is separated, and only half of the edge is measured.) ), starting with the front toe part of the shuttle shoe. Take the yellow line as an example.

The first row of yellow thread is woven in the past, and the last 4 stitches are not woven in the rest, and the red thread is woven in the past, and the red thread is woven in the past (so that the front is flat, not pointed.) Then turn back to weave until there are 4 stitches left from the yellow thread, change the yellow thread to weave, so that after 8 small pieces (5 needles each, a total of 40 stitches), the remaining more than 10 needles will not be added or subtracted, and the same remember to change the thread, weave three back and forth (that is, yellow-red-yellow, the middle is facing red).

After weaving the middle part, the red thread begins to shuttle back. That is: when weaving the red thread, weave the last dozen needles first, and then weave the remaining 5 needles (red) together, after weaving these 5 needles, immediately change to yellow thread to weave over, turn back and weave the remaining 5 needles (yellow) in front of the front, and so on, until all the 40 needles of the front shuttle are finished.

After all the remaining 40 stitches in the middle are finished, the first line of weaving will pay attention to the beginning of the needle, that is: the original needle place, now it becomes the last two stitches into one stitch, be careful not to pull too tight, the edge is too tight to make the upper smaller, left and right asymmetrical. There is no change in the method of turning back to weave.

In this way, only 6 stitches are left, and all the stitches are broken. Now the upper of the shoe looks like a bat with wings spread.

3. Put on your shoes.

Go up first. Orient the front of the face to the bottom of the sole, find the middle position on the top of the sole, align the front of the face with the front of the sole (don't be crooked), first fix the front part with two threads to avoid straightening it when it is pulled in other places, and then use a strong thread to start from the back and go up along the edge.

Then go to the lizi, the method is the same as above.

Then, cut out a pair of insoles from an old sweater (you can also use thread to knit insoles) and sew them onto the soles.

Finally, turn the lining over, turn the face over, and a pair of woolen slippers will be completed.

Material required: Medium-thick with thread.

A pair of soles and a pair of sponges.

2 taels of line, a little jacquard line.

No. 13 rod needle, 2 shoe needles.

Weaving**: 1. Start the needle diagram, start 35 needles, weave 2 back and forth washboard needles, and then weave into the leaves, with a total of 12 needles in the leaves.

2. After arranging 3 leaves, weave them into the center point, and the leaves are always 12 needles unchanged and weave back the needles 4 times.

3. There are 12 needles in the bottom row of red in the middle position, 8 needles in the second row (2 needles are red, 6 needles are yellow), and 4 needles in the third row are red.

4. Divide the heel, 32 needles on both sides, 12 needles in the middle, and weave the return needleUntil there are 2 stitches on the rod needle, 12 knits in the middle and 2 back and forth.

5. Finally, there are 76 needles in the heel of the circle weaving, no less than 76 needles in the circle weaving, not enough to add needles, add enough 76 to 82 needles, the maximum is not more than 86 needles, and finally 3 needles are sewn at the heel, and the upper is finished.

The weave of the woolen shoes is as follows:

1. First of all, knitting shoes needs to be woven from 3 parts. the first part of the sole; The second part is the upper, and the third part is the tube. Start knitting the soles first. Let's start with 4 needles and we'll do the demonstration.

2. Then, there are 6 coils on the rod needle.

3. Then, add a needle to the head and tail again, and then return without adding or subtracting the next needle. At this point, there are 8 coils on the rod pin. Then knit the needle on both sides without adding or subtracting, and weave it to the required length.

Then start to subtract the needle, as with the additional needle, after the first needle, before the last needle, 2 needles and one needle.

4. Subsequently, there are 4 more stitches on the rod needle, and these 4 stitches are used as the toe cap. The sole is knitted.

5. After that, start knitting the second part of the upper. Use a stick needle to pick out one stitch from each of the other 3 sides and start knitting the needle. Every time you knit to the left and right sides of the toe cap, you have to reduce the stitch, that is, you have to have 2 stitches and one stitch.

6. Repeat the weaving to the height required by the upper. So that the upper is knitted. The next step is to weave the shoe tubes.

7. Then, knitting the shoe tube, to change the knitting stitch, start to knit a needle, a needle. Weave to the desired length without adding or subtracting. Then close the needle. So that the shoe tube is knitted.

8. Finally, tidy up and turn the shoe tube down.

So the knitting is complete, come and give it a try.

<>1, the first is the needle: 38-39 size shoes from 10 needles at the beginning of each knitting color plus 5 needles until the end of 35 needles, this is my added needle 2, weaving back and forth 30 circles, this I knit each color back and forth 15 lines. 3, weaving the first needle, the second needle plus a needle, weaving to the end of the remaining 2 needles with a needle on the left side of the pick out 2 needles do not weave, 4, the back are weaving the second needle when adding a needle, the last two needles pick out not to weave 8, good now weaving flowers, first knitting 9 needles and then pick a needle not to weave.

Knit three more needles, and pick a needle not to weave, has been repeated 11 a needle does not weave the past, only the back 8 needles are left, in turn weaving is like that, pick the past 11 single needles also sell bent mountain or that pick the past not to weave, the rest of all the weaving under the needle 5, change the thread, weave out 11 needles to pick 1 needle not to weave the same as the previous line, but the previous line can now be knitted, and then knit three needles, and pick a needle not to weave, has been repeated 10 a needle not to weave the past, only the back 10 needles are left, and vice versa, Just picked out or not knitted, directly pick the past 6, change the thread, the same as the first row of pick weaving, first knit 9 needles and then pick a needle not to weave. Knit three more needles, and pick a needle not to weave, has been repeated 11 needles do not weave the past, 7, only the back 8 needles left, the reverse weaving is also like that, pick the past 11 single needle stupid is still like that pick the past not to weave, the rest of all the knitting needle, the first pick in the needle. Change the thread and weave it back and forth, change the thread and weave it back and forth, and then start to pick, and finally become like this, three I-words.

Preparation materials: wool, crochet.

1. Prepare the wool and crochet needle, and double the wool. 6 stitches.

2. Then hook a long needle into each braid of the back, and add a needle when hooking to the last stitch. Then hook 3 braided needles, turn them over, and add one needle to the last long needle like a hook.

3. Then hook to the desired length without adding or subtracting.

4. Then start to subtract the needle, and add the same needle in the last 2 needles and one needle. Hook until there are 6 into the needle, and then end. The soles are hooked.

5. Then start hooking the upper. Upper hook 2 long needles. Then the needle is withdrawn to the end.

6. Then hook 3 braid needles, continue to hook medium and long needles, when there are 6 needles from the toe cap, hook the long needle, but only 2 coils are withdrawn, and 2 coils are left.

7. Continue to hook a long needle, also return 2 coils, and leave one in this way, hook 6 long needles to the toe cap in a row, and then continue the same flying hook method, hook 6 long needles, and hook 6 long needles and 14 long needle coils are left on the crochet needle. Then pull it out all at once.

8. Then hook a pull-out needle, hook a medium-length needle on the left side, and then continue to hook a medium-length needle in each braid. The head and tail are connected to the end of the extraction needle.

9. So that the shoes are hooked. Then tidy it up, sew the flowers, and you're done. Hook the other one in the same way.