Professional translator of Japanese about lubricating oil equipment, urgent!

Oily (membrane).

Dope koji processing -- bending processing.

Precision machining.

Oil stains.

Aluminum blades (aluminum heat sinks?) ）

Processing Extrusion (stamping).

Carbon sludge (carbon sludge).

Degreasing No degreasing (yes none, it should be the elimination of the meaning of "degreasing") Wire cutting (such as EDM.

It is the "EDM wire cutting machine") round bar sand core cutting.

Thread roll, thread roller.

Non-pyrimidine non-chlorinated.

Dipping Dipping, dipping, dipping.

Green ignition point 1 flash ignition point, flash point 2 ignition point 3 ignition point of gunpowder.

If you say oil, it should be "flash point").

Resin Forming Gold Resin Molding Mold.

Alas, in the "resin forming gold type", resin molding molds are the basic terms of machinery It is recommended that you hurry up and buy this "Japanese-Chinese Mechanical and Electrical Engineering Dictionary", which must be published by the "Machinery Industry Press".

peto book.

Dope. Bending machining.

Precision final machining.

Oil stained aluminum fins.

Publishing processing. toranfyamashin

Carbon fine rod sludge.

Degreasing and non-chemical. Wire cutting.

Diamond-cut roller taps are non-chlorinated. Dip.

Shower non conditioner.

Conditioner blue lacquer.

Ignition point. Fat forming molds. Pitch.

AGC Work Report.

Bag filter powder permeation confirmation and planning.

The brief report is as follows.

During the previous through investigation, the pressure of the upper container tank fell to MPA, and the timing of the pulse was a little late, and after seeking countermeasures to suppress the overfall, a large amount of powder continued to fall into the situation after the filter, and only one unit (2 tons of 10 kg) was symptomatic, and since one side was able to operate smoothly, it was suspected that only some places were malfunctioning. The pressure is the same as the equipment, but the frequency of operation is different, from before I started to find the reason, went to the scene, this time dealt with the suspicious place where the new powder fell off, the following is the **report:

When disassembling the inside of the filter, it is difficult to determine that there is almost no adhesion to the inside of the venturi because the powder tends to adhere to the inside anyway.

The contact surface between the venturi tube and the tube seal (white new packaging or white new seal) is not attached, but part of the bolt is seen to be attached to the self-tapping part, and all of them are suspicious, and it is found that the countersunk surface of the venturi tube and the disc bolt is in very small contact (the lower aperture is large, so it is unreasonable), as long as you can see the traces on the silicone roll used for the last countermeasure, it can still be used.

Therefore, as an emergency treatment, all the adhesives prepared at the site were coated as a measure to prevent the upper powder from falling off. Permanent countermeasures for the future are still under discussion with technology.

1. Width 620mm -- the amplitude (width) of the impact bar is 620mm

2. Motor -- iron chip conveying motor (power).

3. Stroke max: 850mm; Commonly used 600mm -- lift stroke max: 850mm; Commonly used 600mm

4. Hole diameter 190 pins, 118mm -- Backing plate hole diameter 190 pins, 118mm

5. - Main striker.

6. Opening and closing--detection head switch.

7. Iron filings conveyor.

8. a detection head.

9. Formula -- bifurcation.