Dynasty Warriors 3 enters the game and exits when it reads NOW LOAD90

Your CPU can also drive:

Entering the game screen normally, it proves that it is not a problem with the graphics card.

The memory is a bit low, but it doesn't affect the overall game, but the speed may not be as good as it could be.

The hardware is no problem.

Now it's time for the software solution.

Can check it out.

Sometimes your system files will conflict with the running program, there are usually prompts, and there are a few cases that will not prompt, consider trying a different system, or adjust the compatibility of the game.

The minimum configuration of playing the Three Kingdoms Warriors graphics card is a dual 128M graphics card, which is a 128M128-bit graphics card, your GF440 should be 64M, right, that can't be played, and you can't enter the game at all. And Warriors of the Three Kingdoms needs to be installed, and your graphics card doesn't support this either.

It is recommended that you buy an FX5200 graphics card, FX5200 is the model of the graphics card, this kind of graphics card is what I said about the double 128 graphics card, very cheap, it is more than 200 yuan, my machine uses this kind of graphics card, it is no problem to play Warriors of the Three Kingdoms 4.

You're a ** person.,If it's from Beijing.,I have an installation disk of Three Kingdoms Warriors 3.,It's the hard disk version.,I can give you one.,It's absolutely no problem to play.。 If you need it, leave a message here and we'll get in touch.

The old problem, there is no problem with the game files, it is completely caused by the lack of hardware support of the graphics card.

There is a very detailed solution in the Ranger Warriors area (the main point is to force the driver change first, and then use 3da simulation to enter the game).

Well, the landlord doesn't seem to know much about computers, so I guess you don't have to look for it on the Ranger forum, which might be too complicated for you.

And the chances of success are not big I have a block of mx4000 that also jumps out when loading is almost completed.,Finally, you can enter the game with the method on the ranger.,Theoretically speaking, it's the same core.,MX4000 can enter the mx440 ironclad can also enter.,But some people can't get in alive or dead.。

Copy what I used to give to someone else:

Changing machines is more practical than trying to run a game that doesn't work at all, and MX400 is already the lowest scale, and there is no possibility of entering the game below MX400.

Spending more than 200 yuan to buy 6600 yuan is much easier than tossing and turning like this.

1) Does your home meet the requirements?

4) Are you sure your ** is good?

5) If you can't understand the above draggers, mine:

1) Check your configuration, right-click on my computer and press Properties, to see if the configuration is qualified with the one you uploaded.

2) Please confirm (to be 100% confirmed) that your ** is valid and useful.

3) If it really doesn't work, I have the genuine version of "Dynasty Warriors 3", bought for 86 yuan, if you want, I can copy it to you for free, and it can be sent to your computer in less than 10 minutes, and then you install it again, 100% of it can be installed,、。

4) Don't support your own ideas, sometimes it's very troublesome on the Internet, my classmates have loaded n+1 for a game, and it's only useful to use 1, I think your **** may have a problem.

5) Please consider the following, it will be good for you and me and for the person who reads the answer......

I've had this question before.

Is your graphics card an MX440? If yes, please don't look at the online method anymore, I can tell you clearly here that it is impossible to use the online method My graphics card is the same as yours It doesn't work at all I use many methods I can't at all The problem I encountered is the same as yours I changed a graphics card and I can play immediately I strongly recommend that you use a graphics card with 128m video memory so that you can definitely play I recommend that you use Colorful FX5200 is only 250 yuan 128 video memory If you have money, exchange it for 9550 Cost-effective value If your home is not an MX440 graphics card but something else, then there must be something wrong with the ** I have encountered this problem before I recommend you re**.

Not a memory issue....At that time, my family's 768M memory was enough, and the graphics card was MX440, and it couldn't be used, which was a problem with the graphics card.

It's really a graphics card problem.,It's also a problem at home.,To 90, there's something wrong.,Send or not.,Depressed.。

But it's unlikely, if, I said if, if there is a condition, change the graphics card (hehe, this may be nonsense).

It's as simple as right-clicking on an empty space on your desktop.

Select Properties.

Select Settings.

Select Advanced.

Select Adapters.

After clicking on the adapter, a box comes up.

There's a memory size in there.

How much do you see yours?

Mine is 512m

It runs perfectly and smoothly.

If yours can't run.

Personal advice: change the graphics card.

The problem is solved

No problem with the configuration.

Just because you can get into the game means that the game itself is fine.

If the read error is correct, you can try to increase the virtual memory and change the graphics card driver, and that's pretty much it.

Well, the memory is not enough, because if the problem is **, the game can't run at all, only the memory and graphics card will cause this kind of problem, and your computer CPU is also a little slow, and you will be satisfied with the score

Let's see my guarantee that you can play, as I've had this issue too.

It's very simple to change the driver version, I believe you are using the latest driver version, change the old one. It's OK to use a 44-point drive.

It should be a problem with the gaming software, my previous laptop, the integrated graphics card.

It's all good to play, but it's completely slow-motion to play.

It can be seen that it cannot be judged simply as a graphics card problem.

Speechless, the graphics card is not good, the memory is not enough, such a configuration can't be played at all, even if you enter the game, it will be very stuck.

The speed is only 5kb and the things that have been under for 4 days, why are you so confident that what you have under is no problem.

Oh, my machine is rotten, but it can play smoothly Three Kingdoms Warriors, this is going to be a software, I forgot the specific name.

But it says Tomti Systems.

In terms of options, just tick the emulate pixel shader caps

You can play this cool game in a grand way.

My machine, graphics card, 32m memory, 256+128, can run smoothly!!

Oh machine look optimization and software aids the vegetable machine can still cope with the configuration requirements for the howling game

Hello landlord, you have two options when you interrupt, one is to save sure, and the other is to cancel the save. Just cancel the landlord's election.

The landlord's free mode wants to change people and refight, and that's it.

If the landlord is in Musou mode and wants to change people to refight, then the previous steps are the same, and then select Change the generals on the battle start interface.

First of all, you can't change people in battle.,Substitution can only be before the war.,Provided that you have a save before this game.,Go directly into the "Musou mode".,It will remind you if you don't save the original data.,Select Yes.,Then select load game on the line!

After playing a level, it continues to disappear automatically after playing.

It could be an issue with the graphics card. Today's games have higher requirements for graphics cards, and this will happen if the graphics card of the older machines cannot support it.

First of all, a 10th edition patch on the Internet. Then go in and see if you can play. If you still can't,You can search for an original true 3 on Thunderbolt and then use the Chinese patch of the ranger network The patch of the tenth edition。 Then you can definitely play.

Change the resolution, just change it to 1024x768.

It's about the same as me, I can't play it, let's start over.

You change it to run the program as an administrator, and if it doesn't, you can upgrade the functionality patch with 360.

Hello landlord, happy to answer your questions.

Dynasty Warriors 3 flashes out after the game runs The solution is as follows: Enter the Dynasty Warriors 3 game installation directory and find 'data'——'movie'folder, as shown in the image below.

Cut all the animations inside to other places or delete them all, be careful not to delete the 2 folders and the contents in the red box in the picture above; Then run Dynasty Warriors 3 (the disadvantage is that you can't play **cutscenes**, but you can use Storm Video to open these animations separately and directly**).

If you still can't solve it, then Daolang I suggest you change the 'movie' folder in the data folder to another name, just change it.

Hope you can solve the problem and play to Three Kingdoms Warriors 3

This is a good game.

As soon as you enter the game, you can get a super beginner gift pack, and every 10 levels, you can get a variety of items given to you by the gift pack, and you will be guaranteed until level 80.

The next patch will do, and some clients will do just that.