Is the sewer pipe at home suitable for installing a siphon toilet? 50

1. Siphon toilet.

The difference with a flush toilet is the way the toilet itself drains, as long as the connection of the sewer pipe is on the ground.

2. The above two kinds of toilets have a backwater bend, that is, they can use the backbend to prevent the smell from returning.

3. It is recommended to use a direct-flush toilet because it should not be blocked.

Does your house end up with a siphon? My home is similar to yours, and I asked customer service that I couldn't install it. Hope, thank you.

Hello dear, happy to answer your <>

Answer: The sewer pipe has a trap and can be installed with a siphon toilet, but it is not recommended to do so, because in the case of a trap, if you choose to install a siphon toilet, it will lead to a decrease in the flushing efficiency of the toilet, resulting in insufficient flow rate, and after a long period of use, the position of the toilet sewer pipe is prone to blockage, affecting the normal use of the user. If there is a bend on the sewer pipe, you can't install a siphon toilet, that is, you should be careful to take the toilet with a bend, but Xiaosui This is mainly because the toilet is flushed after use, and its impact force is after the bend of the toilet itself, there is no momentum, and the feces will stay there when it rushes to the next bend, and it will not be able to go out and cause blockage, so there can only be one bend on the toilet sewer pipe.

Summary. Hello, dear, no, the toilet sewer pipe has a trap, and it is not possible to install a siphon toilet, which will lead to a decrease in flushing efficiency.

The toilet sewer pipe has a trap, can it be installed with a siphon toilet yard?

Hello, dear, no, the toilet sewer pipe has a trap, and it is not possible to install a siphon toilet, which will lead to a decrease in flushing efficiency.

In the case that the toilet sewer pipe has a trap, if you choose to install a siphon toilet, the chaotic liquid will cause the flushing efficiency of the toilet to decrease, resulting in insufficient flow rate, and after a long period of use, the position of the toilet sewer pipe is prone to blockage, which affects the normal use of the user's dismantling.

Thank you, can the U-shaped submersible bend be installed in a straight-filling toilet?

Are you there. Yes, dear.

U-shaped ones are OK, kiss <>

Now there are two kinds of toilets on the market, one is siphon and the other is straight-put, I believe everyone will have the following confusion when buying. That is, what is the difference between a siphon and a drinking toilet? Siphon toilets.

Is it better or a straight-put toilet is better, so which one should we choose? In fact, just take a closer look at the relevant knowledge. So let me introduce the difference between a siphon toilet and a straight-put toilet.

Linear toilets use the propulsive force of water to expel dirt. Generally speaking, the pool wall is steep and the water storage area is small, so the water force falling around the toilet seat is greater, and the pollution efficiency is higher.

The huge thrust formed by the use of compressed air has the advantages of washing speed, impulse, polluted water, speed, reduced water consumption, and no leakage. The direct hitting type uses the water flow to instantly hit the pipe wall with strong kinetic energy, and the sound is relatively loud. Most of the rear drain is direct current.

However, the diameter of the drain that flushes directly into the toilet bowl is large, and it is easy to put large dirt down. Straight toilets have simple stamping lines, short paths, and thick pipe diameters. Utilizes the gravitational acceleration of water.

The toilet bowl can be cleaned, and the cleaning process is very short. Compared with siphon toilets, straight toilets do not have a backpipe, which makes it easy to flush large dirt and not easy to clog during cleaning.

There is no need to have a trash can in the toilet to save water.

Also than a siphon toilet.

The biggest disadvantage of a good direct shipping toilet is that the flushing sound is loud and the sleep is small, it is easy to produce scale, and the anti-odor performance is not as good as that of the siphon toilet. At present, there are very few varieties of tandem toilets on the market, so the choice area is not larger than that of siphon toilets. The structure of the siphon toilet is that the drain pipe is shaped.

When the drain is filled with water, a certain water level difference is created, and the suction of the washing water in the sewer inside the toilet bowl will be discharged from the toilet. The cleaning of the siphon toilet depends on the water flow, so the pool water level is large and the cleaning noise is low. Siphon toilets can also be divided into vortex siphons and spray siphons.

Advantages: The biggest advantage of a siphon toilet is that it has low flushing noise and is silent. In terms of flushing capacity, the siphon type is easy to clean dirt that adheres to the surface of the toilet.

When flushing the siphon toilet, the water must be discharged to a high water surface to clean the dirt In order to achieve the purpose of flushing, there must be a certain amount of water, at least 8 9 liters of water should be used each time, which is more expensive. The siphon drain is about 56 cm in diameter, which is easy to clog when flushing, and paper towels cannot be thrown directly into the toilet. Siphon toilets are generally installed with garbage cans and chopsticks.

What we introduced above is which is better, siphon toilet or in-line toilet, and what is the difference between the two. We should have an idea about this issue Currently, regular toilets are divided into two categories. One is straight and the other is siphon.

Because such a toilet is very expensive, but it is also very inconvenient to use and is very prone to failure.

Because such a toilet is easy to smell, and such a toilet is also very inconvenient to use, such a toilet is also very troublesome to install.

When installing, it needs to be installed at a very high height, and it is particularly water-intensive, there must be a lot of water to flush it out each time, and it is particularly easy to block, and the used paper can not be thrown in the toilet, so people do not choose this kind of toilet.

Because this kind of toilet is very water-intensive, and it is not easy to use, there are many functions, and it is very troublesome to not understand at all, so people do not buy it.

Summary. Dear Kiss I am happy to answer for you, my answer is as follows<> straight discharge type (also called flush down type), its principle is to use the flush of the water tank flushing water flow to directly discharge the dirt, save water, good sewage effect, slightly worse anti-odor effect, loud noise. The siphon toilet has low noise and good anti-odor effect of flushing, flushing and drainage.

From a hygienic and economic point of view, I recommend that you opt for flushing siphon toilets. The toilet is displaced by 60 cm, and whether it is suitable for the toilet with a siphon is suitable for the siphon type depends on the distance of the shift. If the toilet displacement distance is short, within 10 cm and the diameter of the sewer pipe is greater than 10 cm, in this case, a siphon toilet can be used, with a large punch and a small chance of blockage.

If the toilet displacement distance is greater than 10 cm, it is not suitable to use a siphon toilet, and it is recommended to choose a flush toilet. Because the inner diameter of the S pipe in the siphon toilet is thinner, the displacement too far will affect the siphon effect, and it is easy to drain poorly.

Only the position that should be no more than 10 centimeters was transverse.

Kiss is a pleasure to answer for you, my answer is <> below

The principle of the in-line discharge type (also called the flush down type) is to directly discharge the dirt by the impulse of the flushing water flow of the water tank, which saves water, has a good sewage discharge effect, and has a slightly worse anti-odor effect and high noise. The siphon toilet has low noise and good anti-odor effect of flushing, flushing and drainage. From a hygienic beam cover and economic point of view, I recommend that you choose a flushing siphon toilet.

The toilet is displaced by 60 cm, and whether the toilet with a direct flush and a shifter is suitable for the siphon type depends on the distance of the displacement. If the toilet displacement distance is short, within 10 cm and the diameter of the sewer pipe is greater than 10 cm, in this case, a siphon toilet can be used, with a large punch and a small chance of blockage. If the toilet displacement distance is greater than 10 cm, it is not suitable for siphon toilets, and it is recommended to choose a straight-flush oak toilet.

Because the inner diameter of the S pipe in the siphon toilet is thinner, the displacement too far will affect the siphon effect, and it is easy to drain poorly.

Kiss is a pleasure to answer for you, my answer is <> below

It is better to use a siphon for 10 cm outside, and it is better to use a straight flush for the inside, which is not easy to block.

All toilet drain pipes are siphon-type, dear! Hello, glad to answer for you. The sewage pipe of all toilets is not all siphon type and direct suction type1, from the outer wall, we can look at the outer wall of the toilet, from the outside to see the toilet sewage pipe, if it is a curved shape, then it is a siphon toilet.

If the toilet drain pipe is straight, then it is a straight-side suction toilet. 2. From the sewage outlet, look at the direction of the toilet outlet, if the slope of the toilet is not very steep, and its sewage outlet is horizontal, not upward, then it is a siphon toilet, and the sewage outlet of the direct suction toilet is generally very deep, basically you can't see the bottom at a glance. 3. From the flush outlet, we can take a closer look at the flush port of the toilet, if the toilet has two flush outlets, then it is a siphon toilet, and if there is only one flush outlet, then it is a direct suction toilet.

4. From the flush button, there is only one button, which is the siphon horse. If there are one or two buttons, then it is a direct-suction toilet, but most of the two flush buttons on the market are not talked about, so you can take a look at this method, but not all of them are suitable. 5. In terms of flushing noise, we can listen carefully to the sound of toilet flushing, if the sound of toilet flushing is relatively small, it is a siphon toilet, but if the sound of toilet flushing is relatively loud, then it belongs to the dry and direct suction toilet.

Hope mine can help you! Do you have any other questions?

OK. The backbend is one of the most clogged locations in the pipeline. The toilet has a siphon toilet and a straight toilet, the siphon toilet looks clean, but because of the addition of a bend is easy to cause blockage, the straight toilet is not easy to block, but it looks unsightly.

If you use a siphon toilet at home, it is recommended to use a can to clean it regularly to prevent blockage, and a bottle cap every week, so as to achieve the effect of smooth pipes.

This is an example of science applied to life. Hehe, the specific reason is this.

In the middle of the sewer pipe of the wash basin, there is a curve bend, which is called a reverse bend. This is actually a communicator, and when the liquid is stationary, the liquid level on both sides is always level. When the basin is lowered downwards, the water surface exceeds the point and the water flows naturally down the sewer.

When the water in the basin is about to run out, the water level in the pipe gradually declines, and when it falls to the same height as the point, the water no longer flows, and this part of the pipe forms a "water plug" to isolate the sewage and odor in the pipe from the outside world.

In addition, the scientific principle of floor drain is this.

At the top of the floor drain is a grate that prevents large pieces of dirt from falling into the sewer pipe. Underneath is an upside-down iron bowl with several arched notches around the bowl that allow water from the ground to flow smoothly into the sewer pipe. If that's all it takes, the water will flow in and the stench will come out.

Therefore, there is also a circle of grooves at the mouth of the sewer pipe. It is used to store water. Obviously, the depth of the water in the groove is to submerge the arched gap of the buckle bowl, so that the odor does not come out, and the water level on the ground is higher than the inner mouth of the floor drain, and the water flows smoothly into the sewer pipe thanks to the communicator principle.

From this, we also know that there must be some water stored in the groove from time to time, and if the water is all dry, it will not act as a "water cover", and the smell will come out.

If you choose to install a siphon toilet, it will lead to a decrease in the flushing efficiency of the toilet, resulting in insufficient flow rate, and after a long period of use, the position of the toilet sewer pipe is prone to blockage, which affects the normal use of the user.