How to deal with negative emotions in the cost engineer exam preparation

Take a proper break, sing a song, watch a movie, and soothe your exam preparation.

Adapt the way you learn.

The low learning efficiency is often due to the incorrect way of learning

Caused by low enthusiasm for learning.

But once there is inefficiency、

When the effect is not obvious, candidates are often depressed and fall into a cycle of lack of confidence in revision.

Candidates want to get out of the circle.

It is necessary to adjust the way of learning, continue to maintain enthusiasm for learning, and plan the review of each subject reasonably.

Cost engineer exam review suggestions can be combined with textbooks and test questions to review, textbooks are the foundation, exam questions are around the content of the textbook, followed by the cost engineer red book and other learning question bank, to strengthen the understanding of textbook knowledge, improve review efficiency.

At that time, it was to prepare for the exam in advance, and it was best to study as early as possible and before the year.

First of all, plan first, if you follow the planned August study time, you will definitely be able to pass.

Second, the difficulty is not to make a plan, but to execute the plan. I don't know what your usual study and work style is, if the planned things can be implemented without discounting, then I suggest that you can compress the plan a little more to avoid the plan being too grandiose and the battle line being too long and causing fatigue. If there is a big deviation in the planning and execution in peacetime, I suggest adjusting the plan and shortening the front.

Third, for most other children's shoes, one hour a day for a month, and three hours a day for ten days, the latter is a little more operational. In my personal experience, the two months before the exam are the most efficient and the fastest time to improve. To get the most out of this last bit of time, I suggest you plan it like this:

Sprint: 1-2 months before the exam, 4-6 hours a day, brush books, questions, and brains. Make sure that your brain is soaked in these knowledge points, and that you will feel the same as taking the test in the exam room and doing the test as usual.

The introduction and familiarization stages can be flexible and disconnected, and the sprint time before the exam must be guaranteed. You can only play 30% in the front, and you must ensure 80% in the later stage. The difficulty of the registration certificate lies in the fact that the knowledge system capacity of the entire exam must be taken seriously by 99% of people, either fighting for time or energy.

If you are a beginner, then I suggest that you can join the preparation now, so that you can give yourself more time to study.

1. Formulate a plan and implement it conscientiously to ensure that the progress is completed.

1. Make a plan.

The National Cost Engineer Qualification Examination has four training materials: knowledge related to engineering cost management, "Determination and Control of Engineering Cost", "Construction Engineering Technology and Measurement (Civil Engineering or Installation)", and "Case Analysis of Engineering Cost". The textbook closely focuses on the requirements of the syllabus of the professional qualification examination, and explains it in simple terms, with a reasonable knowledge structure and rich content. When studying, you should read at least twice, and the first time you have a preliminary understanding of the content of each chapter, whether it is the content that you are required to be familiar with and master in the "Outline", or the content you understand, you should read it to have an overall impression.

Don't grasp the place you don't understand, avoid a problem stuck, delay time to solve it, and affect the progress of the mouth for the second time is the key to grasp, firmly grasp the main problems discussed in each chapter to understand, and extract the internal connections and differences between the knowledge points to prevent conceptual confusion.

2. Schedule.

It is necessary to insist on 1-2 hours a day, preferably in the early morning, so that the mind is clear, the understanding is profound, and the physical and mental exhaustion after a day of work is prevented, and reading books has no effect. The daily learning task is one or two sessions, don't be greedy, so that you will lose the learning interest and motivation for the next study due to fatigue, and don't arrange it at will, just watch it when you have time, even if you don't have time, you can't complete the learning task, and it's useless. Make a plan for your work and implement it carefully.

2. Find out the key points, solve the difficulties, and deeply understand the knowledge learned.

Each of the four subjects of the cost engineer qualification examination has its key points and difficulties"Mastery is required to be able to solve practical work problems, familiarity is required to have a deep understanding of the knowledge of the project cost, understanding is required to have a wide range of knowledge related to the project cost"requirements, find out the key points, solve the difficulties, and integrate the knowledge learned.

There are four subjects in the cost engineer examination, which are divided into public courses (economics, regulations, management) and professional practice courses. The professional practice course is the top priority, and the vast majority of them did not pass the cost exam, and they were hung on this subject. Practical and public course difficulty rankings:

Review ideas: go through four intensive lectures - quickly go through the book (four) - do real questions (nearly five years for public courses, nearly ten years for practical courses) - four sprints - do real questions - practical special courses - case analysis courses - reading and memorizing books in public courses - practical endorsement - case questions - endorsement - doing simulations. My reading progress, a year ago, three public courses were completed, and after the year, I listened to practical lectures, and then I have been implementing my plan, reminding myself to complete the plan at a fixed time.

To prepare for the exam, you can use the red treasure book to review the exam, or you can find the "Xiaoyou Question Bank" to prepare for the exam!

You can click on my avatar and follow the famous teacher to prepare for the exam efficiently! There are also free famous teacher auditions and materials waiting for you. The cost discount campaign is underway.

There is still a lot of content in the 2018 cost engineer exam, which requires you to have a strong memory, and Dali Education has summarized a set of methods for you, which can help you improve your memory in preparing for the exam.

1. In-depth understanding.

After systematically studying the textbooks, candidates have a detailed understanding of the knowledge points of each subject and each chapter, and what they need to do now is how to systematically process these important test points and make them their own things and successfully control the examination room. Take the exam syllabus as the table of contents, recall the knowledge points of each chapter, and the instructions that can be easily recalled are well mastered, and the more difficult places need to be focused on, you can make marks, and then find out the teaching materials for key learning and memory, insist on it every day, practice makes perfect, and keep it in mind.

2. Understand memory.

There are also some test points in the cost engineer exam that candidates need to memorize, such as engineering cost pricing and control, basic theory of engineering cost management and related regulations, first of all, it is necessary to make it clear that understanding is the basis of memory, and the knowledge will naturally be remembered after understanding, and the effect of remembering after understanding is the best, and it is not easy to forget, so in order to make the memory more durable, it is a good memory method to take some time to understand, candidates may wish to try.

3. Summarize memory.

Summarizing and memorizing the following important contents such as concepts, theorems, and formulas involved in the exam, you can take the method of summarizing and memorizing. At this time, it is best to summarize such content, summarize it together for comparison and generalization, and organize it into your notes.

4. Associative memory.

This method is mainly aimed at the time when the exam is approaching, the exam is approaching day by day, many candidates also feel the urgency of time, it is impossible to conduct a comprehensive review of the textbook, but the knowledge points can not be ignored, at this time, you can take associative memory to consolidate the knowledge points, candidates can follow the smooth association of each chapter, and can also diverge and extend a certain knowledge point. Before going to bed, when taking a walk and other leisure time, you can think about it, and if you can't think of it, you can find teaching materials in time to check and fill in the gaps.

1. Read the textbook repeatedly.

It is said that the cost engineer exam is difficult, in fact, because the book is relatively thick, most of the test points are focused on the textbook, and the textbook is worth reading at least 3 times. The first basic learning can be combined with handouts and **, after being familiar with the framework, then go to the textbook to draw out the key points, and the second time before doing the questions, sort out the key points of the textbook. The third time is to return to the textbook by making mistakes.

The book should be in the first round, the more you read, the thicker it becomes, and when you need to combine other subjects with understanding, you need to expand it; In the second round, the more you read, the thinner and thinner, the key points and test points form a clear framework, and the third round does not need to be written by doing questions, and repeated reading can you thoroughly understand the textbook. It should be noted that the old and new textbooks are replaced, and each change point must be clearly summarized.

2. Ensure implementation in accordance with the plan.

The examination cycle of cost engineers is relatively long, which is not only a test of knowledge, but also a test of time and planning. Choose a suitable combination for you, then make a detailed planning list, allocate the time you can use to study effectively, and then urge yourself to follow the plan. If the execution is poor, you can make a weekly score sheet, summarize your own performance every week, and constantly supervise and improve.

You can join a test preparation team to encourage each other, supervise each other, and do questions together to simulate the feeling of the exam room to see who has a high score.

Third, it is easy to understand in combination with reality.

Some knowledge points are very blunt, more difficult to bite, every day the brain is entangled with different knowledge, it is easy to make yourself confused, through a simple case to connect these knowledge points together, easy to remember, just like using a sentence to string together English words, you only need to remember this example, you can distinguish these definitions. Combined with reality, it can help you understand some empty concepts. If you work, you can also combine your own work and dissect these knowledge points from some examples of actual work, which is a good direction.

Fourth, use exercises to break through yourself.

The real question is the window for you to spy on the cost engineer exam, grasp the key points and test points in the exam by doing the questions, find the breakthrough of the problem, dig deep into the idea of the question, and master the law of the proposition, only in this way can you achieve the effect of doing the question, sort out some wrong questions, you can see where the weakness of your review is, and return to the specific chapter of the textbook to find the answer. It is also necessary to use the past questions of cost engineers to simulate the environment of the examination room, exercise their ability to think independently, control the time, and use the exercises to further improve themselves.

Fifth, persevere to the end no matter what.

When you make up your mind to do something, no matter what the result is, you must persevere to the end, so that you have no regrets, you are qualified to be willful, and you know whether you can do it or not. Preparing for the cost engineer is also, go to the examination room to see, all the people who have paid the money and missed the exam, if you identify this matter, why not insist on doing it to the end? In the preparation for the exam, you should develop a good habit, study time every day should be moderate, find your own appropriate work intensity, and improve efficiency; Put your study plan in a conspicuous position and constantly strengthen your habits; Make the most of your scattered time and don't try to break the habit.

Stage 1: Reading Through Stage (Pre-Study) The four subjects take 1 month (an average of one week per subject).

This round of review requires familiarity with the table of contents and a grasp of the content of the chapters. Learn about the exam, the characteristics of the previous year's past questions, the key points of the current year's exam, simple test-taking skills, study plans and revision suggestions, etc.

Stage 2: Perusal (Priming).

After this round of review, all the difficult points are required to be understood, and all knowledge points must be covered.

This process is the process of reading the book thickly)

1.The four courses take five months (one month for management and pricing, one and a half months for cases and measurement, i.e. one chapter and one week).

3.At this stage, the review should focus on depth and breadth. Depth: In addition to the review of the basic content, it is also necessary to consolidate the learned content with chapter exercises; Breadth: It is best to listen to the lessons of several teachers, and then mark the key points of Teacher Youlu.

Stage 3: Quick Review (Problem Solving).

1 book per day, and a large number of exercises to consolidate.

This process is the process of reading the book thinly)

1.The four subjects take one month.

2.Do the past 5 years of past papers first, and test the effect of the first 2 rounds of review through the past questions, and there is a summary of the past questions on the Global Online School page, which can be read for free.

3.After the past questions have been done, review the book again, quickly pass the knowledge points, and strive to read the whole book in one day; Consolidate knowledge points with a large number of exercises, of course, it is best to read some quality assurance questions.

Stage 4: Focus on the sprint phase (error correction).

Sum up all the mistakes and go through them again, and be sure to figure out what went wrong.

The four subjects take a month, and you can read the key points in the four books repeatedly, and you can go through it again with the online school's sprint course, and at the same time do all the questions that you did wrong.

1. Since we can't guarantee that all the questions we do are correct, and we can't master all the knowledge points. So less loss of points is the biggest "political correctness" for us, since the goal is to get the certificate, then focus on learning the key points of the exam, and distinguish the priorities to study.

The second is to understand, and understanding is very important. The effect of rote memorization and self-understanding is definitely not the same! So how to understand it?

It's just to think more about some of my own fragmentary time to remember him, think about him, repeat it over and over again in my mind, and slowly form an understanding memory.

Third, the speed of writing questions should be fast, and the questions that are not written must be 0 points, so the speed of writing questions must be paid attention to, the exam is short, there are many questions, and if you write slowly, you will lose points for the questions that should have been scored, and the gains outweigh the losses. Therefore, writing questions quickly is also a prerequisite for getting points.

Fourth, mentality is very important, in the early stage of preparing for the exam, many people slowly lose the learning mentality when they were in school because they have been working for a long time. I often can't stick to it after turning a few pages of a book or listening to it for a few minutes, and by the time I think about learning again, time has been wasted for a long time. Learning the knowledge of cost is very boring in itself, but in order to take the exam, you need to overcome your slackness, even if you only study for 20 minutes a day at the beginning, you must slowly persevere.

Fifth, the first time to learn is not the point.

Many people like to get the textbook for the first time, it is very meticulous to study, but the time is wasted, you must know that you must not only learn once, then the first time only use the general familiarity with the textbook, there is an idea, more is familiar with the textbook and content. When reviewing many times in the later stage, the main focus is on the important knowledge points, and at the same time, you should do more practice questions and use exercises to consolidate the knowledge points.