How to assemble the main unit of a home computer is the most practical?

Configure Brand Model Quantity Previous** Current** Merchant CPU AMD Athlon64 x2 4200+ AM2 (65nm box) 1 450 450 37 merchants in total.

Motherboard Onda A78GT 1 599 599 6 Merchant Memory ADATA 1GB DDR2 800 1 175 175 20 Merchants.

HDD Hitachi 160g 7200rpm 8m(Serial port 3 years box) 1 365 365 A total of 43 merchants.

Optical Drive Pioneer ***-228 1 158 158 A total of 29 merchant chassis Colorful S82 (with power supply) 1 235 235 A total of 4 merchants Total amount: 2000 yuan.

If you buy a home machine without specific functions and functions, buy a brand machine on the market, and the appropriate low point is also enough for home use.

Lenovo's service is better.

Otherwise, install a compatible machine. It's assembled in the computer city. In the early 3000s, there is a 19 widescreen LCD plus a good host.

Cost-effective and suitable for your own use!

If the host you want is for simple entertainment rather than large-scale games, it's good to match it casually, at most 2000 yuan.

But if you play a game, 3500 yuan is enough

The cheapest is the Founder, the Lenovo is a bit expensive, and the performance of the Founders is good.

1. Before the desktop is assembled, you need to prepare some necessary tools such as Torx screwdrivers, scissors, silicone grease, and cable ties.

2. When assembling the desktop, do a good job of anti-static, because adding to your body may cause a certain degree of damage to the desktop assembly.

3. For desktop assembly, all the copper screws in the computer need to be aligned, and they must not be less because of trouble or lack of screws.

4. When assembling the CPU later, pay attention to the direction of the CPU and the direction of the machine, not the opposite direction.

5. When the desktop is assembled to this step, pay attention to the buckle at this time, and the CPU on the buckle can be tight, don't force it to be reversed.

6. After assembling the CPU, it is necessary to apply silicone grease, and it should be comprehensive and uniform when applying, otherwise it will affect the thermal insulation effect.

7. The next step is to install the radiator, and align the pre-selected radiator with the four holes on the motherboard. It is also important to note that the direction cannot be reversed.

8. After the radiator is installed, the fan is installed, and the installation of the fan is relatively simple, and the screw buckle is tightened.

9. When installing memory, you need to be especially careful and careful, you need to align the gap of the memory module, and you must not insert it wrongly.

10. The assembly of the desktop computer is almost complete, and the baffle behind the chassis needs to be installed.

11. The selection and installation of the motherboard, start to use a clean fan and the motherboard to put the inside of the desktop computer, at this time, you need to be careful, do not damage the motherboard and other parts that have been installed.

12. For the assembly of the optical drive, pay attention to the screws on the optical drive need to lock the screw ports on both sides of the chassis, and then allow other wiring to be connected.

13. To install the hard disk of the desktop computer, you need to confirm the installation location first, not the front fan should not contradict it, and secondly, it should be aligned with the radiator to facilitate heat dissipation.

14. For the installation of the graphics card of the desktop computer, there are generally 2 slots on the desktop computer, one is PCIEX16 and the other is PCIEX4, which needs to be installed in the former.