Nomos after sales service center, Nomos watch after sales service center

Ruijiang Famous Watch Customer Service Center Introduction: Water ingress of Nomos watches may cause rust on the watch, so once the watch gets into the water, you can go to [1102, Block D, Central World Trade Center, No. 6A, Jianguomenwai Street, Chaoyang District] for treatment, if the water ingress is not serious, you can also try the following methods:

Method 1: When an ordinary mechanical watch is wet, you can wrap the watch tightly with several layers of toilet paper or flannel cloth that is easy to absorb moisture, put it at about 15 cm near a 40-watt light bulb, and bake it for about 30 minutes, and the moisture in the watch can be dissipated. Do not bake the watch close to the fire, so as not to deform the watch by heat.

Method 2: Put the surface face inward and the bottom shell outward, and wear it on the wrist, and the moisture can be eliminated after two hours. If the water ingress is severe, it is best to wipe the oil immediately at 1102 World Trade Center in Central on Jianguomenwai Street to remove the moisture from the movement to avoid rust on the parts.

Method 3: Put the granular silicone into a closed container with the watch that has accumulated water, and after a few hours, take out the watch and the water will disappear. This method is simple and economical, and there is no damage to the accuracy and longevity of the watch.

The silica gel that has been absorbed many times can be dried at 120 degrees for several hours, and the water absorption capacity is renewable, and it can be used again and again.

Way. 1. If the watch is soaked in water, you can use several layers of toilet paper or fluffy cotton cloth that is easy to absorb moisture to wrap the watch tightly, put it near a 40-watt incandescent lamp about 15 cm, bake for about 30 minutes, and the water vapor in the watch can be water vapor. Avoid baking the watch on the wrist close to the fire, so as not to cause the watch to suffer thermal deformation.

Way. 2. The watch is worn inwards and the bottom case outward, and the water vapor can be eliminated after two hours. If the water ingress is severe, it is best to send it to the watch shop immediately to wipe the oil and sweep away the nutrients of the movement to prevent the parts from rusting.

If only fine dust is entered, there is no need to clean it without affecting the appearance and use. However, if it is a certain length of dust such as hair or acrylic fibers that enters the dial of the watch, it is necessary to pay attention, because this dust is very likely to cause the movement to stop.

After finding that the watch is dusty, do not easily open the back cover for cleaning, and send it to a professional place such as after-sales service for cleaning in time, and regularly do waterproof tests and timekeeping accuracy tests to ensure its normal operation.

At the same time, we should also pay attention to the watch in our daily life not to come into contact with chemicals. The waterproof watch is not cold water or hot water, so don't wear it to take a bath, avoid water vapor to ensure its waterproof effect, and then after adjusting the watch, remember to restore the watch handle and press it tightly to avoid dust entering. In addition, this problem occurs with the watch, please go to:

Room 808, Block E1, Oriental Plaza Office Building, next to Wangfujing Street, Dongcheng District] for processing.

Proper use and maintenance.

1. When wearing a watch, the sweat on the hands is corrosive to the case, the all-steel case is nickel-chromium alloy, the corrosion resistance is better, the semi-steel case is copper, long-term contact with sweat, easy to corrode, should often wipe off the sweat with a soft cloth or pad the plastic watch holder to prevent it from being eroded by sweat.

2. Do not open the back cover of the watch at will, so as not to enter the movement and affect the normal operation of the watch.

3. Do not put the watch in the wardrobe with mothballs to avoid the deterioration of the watch oil.

4. Do not put the watch on the radio or TV to avoid magnetization.

5. Watches that are not worn for a long time should be wound regularly once a month so that the parts will not be in a static state for a long time, so as to ensure the operation performance of the watch machine.

SAC Sichuan Aviation Plaza, No. 6 Renmin East Road, Jinjiang District, Chengdu 2405 (1) When wearing a watch, the sweat on the hands is corrosive to the case, the all-steel case is better because it is a nickel-chromium alloy, and the semi-steel case is copper, which is easy to corrode in contact with sweat for a long time, so you should often wipe off the sweat with a soft cloth or put on a plastic watch holder to prevent it from being eroded by sweat.

2) Be careful not to open the back cover of the watch at will, in order to avoid dust entering the movement and affecting the normal operation of the watch.

3) Be careful not to put the watch in a closet with mothballs to avoid deterioration of the watch oil.

4) Do not put the watch on the power amplifier, stereo, and TV to avoid magnetization.

Five common reasons for the time error and inaccuracy of Nomos watches:

1) Insufficient power reserve: You need to check whether the power is sufficient, if the amount of movement of the self-winding mechanical watch is very small, it may also cause insufficient power reserve, you can replenish the power by manual winding, and then observe whether it continues to have the phenomenon of fast and slow.

2) Insufficient power: If the quartz watch suddenly finds that it is slow, it is likely to be caused by insufficient battery energy, and you can send the watch to a special maintenance point to check the power.

3) Hit or hit: The watch is very tight, if it is hit or hit, it may cause loose damage to the internal parts, and it may also cause the problem of running time. This is to be dealt with in a timely manner.

4) Need to maintain: The lack of oil in the movement or the wear and aging of internal parts may cause time problems, which need to be maintained, and need to be sent to the designated maintenance point for maintenance services. Yes[8th Floor, Block E1, Oriental Plaza Office Building, No. 1 East Chang'an Street, Dongcheng District, Beijing].Dispose.

5) In addition to the above common situations, the watch is affected by some ambient temperatures: if the hairspring of the watch is magnetized, the watch will not be accurate.

Regardless of any problems with the watch, it is recommended that you go to the after-sales point for maintenance consultation, and then see if it needs to be repaired.

You can also find some formal watch service centers authorized by official stores for inspection and maintenance, which can also be visited.

If you have a need, you can also find us, we are professional in this regard.

Hello, it may be magnetized, or it may be out of power.

Once the magnetism on the watch is all of a sudden, it goes very fast, even 1-2 hours a day.

When wearing mechanical watches, pay attention to keep away from magnetic fields, such as stereos, televisions, mobile phones and other electrical appliances. Magnetization is a relatively common phenomenon nowadays, and the solution is not difficult, just go to the watch repair department or return to the Dangdang watch department for demagnetization, or bring your own demagnetizer, it only takes 30 seconds for the watch to demagnetize, and there is no impact on the performance of the watch.

NOMOS is a well-known German watch brand founded by Ferdinand Adolph Lange in 1845, the continuation of the legend of Glashütte watches, independent design, research and development, manufacturing movements, is one of the many watch manufacturers in the world's watch industry, with a unique design.

The best materials are used in the construction of NOMOS, and the watchmakers have the utmost care and attention in every part and every step of the process. NOMOS is designed with a special focus on the performance and readability of each watch.