Can ordinary ASDL users use IPv6 and how to set it up?

The use of IPv6 now requires the support of a switch or router, as it is still the transition period from IPv4 to IPv6. At this time, a large percentage of ADSL is not supported. As long as the device supports it in the LAN, IPv6 can still be used.

IPv6 settings are different from IPv4 because it is a new technology, so it does not provide a window interface like in IPv4, and you need to use the command line to set it.

Installation: Enter command-line mode (method is Start, Run, enter cmd, OK).

ipv6 install

The installation is successful.

Then ipv6 add address 4 (this is the sequence number of the connection, the local connection is usually 4) 2001:250::This is your IP address).

ipv6 add dns "Local connection" 2001:250::.This is your DNS).

Of course, normally, if you use an IPv6 network, you usually don't need to manually configure these yourself, because IPv6 supports "stateless auto-provisioning", which means that when you connect an Internet cable, router, or a server, it will automatically help you set up the settings that need to be set up automatically.

The method is similar under linux, I guess you won't use that, so I won't write it.

Also, how to use IPv6 is described in detail in the Windows help documentation, you can check it out.

The upstairs one is the IPv4 configuration method.

: Angela.

Scholar May 8 13:40 XP System, My Computer Control Panel Network Connectivity Local Connection, Right-click, Properties, under the General page, select Protocol, click Properties, and in Properties General, select 'Use the IP address below' to enter the address and DNS server address.

Find the ** server address here.

XP has improved IPv6 support. And even if you add DNS, it won't resolve.

The method of adding is to write netsh int ipv6 add dns in the command prompt (run cmd)."The name of your connection"DNS address.

Others are similar, you can type netsh, int, ipv6 step by step, and then enter enter to check the cavity to see. To delete is to enter delete to view the banquet shirt command.

1.Directly remove the checkmark before IPv6 and remove the shirt with tassels.

2.After the dial-up connection is successful, enter ipconfig all in the dos window, remember the relevant parameters, and set the ip to fixed in IPv4.

This concept is similar to IPv4, when DHCP allocation fails, the router will not ** it, such packets can only communicate in the LAN.

Currently, IPv6 is only supported within some universities and in limited regions.

win7 under the setting IPv6, you can take a look at this:

You can get it automatically. Or you need to first "firmware upgrade" your wireless router, and then restart the computer and router, and set the wireless router again, then note that the network name you set cannot be the same as the previous one. For example, it was originally called dlink615, but this time it can be changed to dlink61, as long as the name is different.

If it doesn't work well this time, you can see if there is a problem with the crystal head of your network cable, and you can remake a crystal head. If none of the above is good, it's a problem with the broadband company equipment you are installing,Win7 is a very comprehensive system。 Remember to give extra points.

First, make sure your school has an IPv6 network.

Win7 doesn't need to be set, just get it automatically.

Because the IPv6 protocol is integrated into the system.

There is no integration in the XP system that requires an installation protocol.

This is not widely used at the moment, and it is generally automatically assigned. And the traffic has nothing to do with this.

IPv6 has not yet been applied on a large scale, and only some national backbone networks are gradually replacing with IPv6

So you can't set up IPv6

Starting with Vista, the IPv6 protocol comes with no additional installation.